0
$\begingroup$

I'm solving an exercise about small oscillations and I have a doubt about coordinates that I have to use.

This is the text of the exercise: "A bar has mass M and lenght l. Its extremity A is hooked to a coil (with lenght at rest $l_0$), its extremity B is hooked to the point O that is the origin of axes. "

I have considered three coordinates: $x$, $y$ (that are the coords of the extremity A on the x-axes and y-axes) and $\theta$ that is the angle that the bar forms with a parallel to the y-axes.

I have to find the points of equilibrium.

I have written the coordinates of the center of mass of the bar as: $M=(x+l/2 \sin \theta, -y-l/2 \cos \theta)$ and the potential energy as $ V=\frac{1}{2}k(x^2+y^2)-Mg(y+\frac{l}{2}\cos \theta)$

Then I have posed $gradV=0$ and I have obtained:

$y=\frac{Mg}{k}$

$x=0$

$\theta=0, \pi$

My doubt is about the result of y.. I was waiting for a negative value.. could you "clarify" my ideas and tell me where I'm making a mistake?

$\endgroup$
2
  • $\begingroup$ What are $x$ and $y$ here, exactly? The coordinates of extremity B? $\endgroup$
    – Izzhov
    Commented May 28, 2013 at 21:20
  • $\begingroup$ @Izzhov no, the coordinates of extremity A $\endgroup$
    – sunrise
    Commented May 28, 2013 at 21:21

1 Answer 1

0
$\begingroup$

The resolution is that your first equation should have $+y$ where $-y$ is, since you're measuring from extremity A to the center of mass. Not sure where you're getting $-y$ from.

$\endgroup$
4
  • $\begingroup$ I'm not sure to have understood... y is the coordinates on y-axes of the extremity A.. but I have considered that it is negative, because it is "under" O.. $\endgroup$
    – sunrise
    Commented May 28, 2013 at 21:28
  • 1
    $\begingroup$ Ah, but see, that would just make $+y$ a negative number. So you would still use $+y$. E.g. if $y$ is 3 units below the x-axis then you'll have $+y = -3$. $\endgroup$
    – Izzhov
    Commented May 28, 2013 at 21:28
  • $\begingroup$ just another (general) doubt: if the text says "for the point P use the q coordinate, where q>0 if P is on the right of O, and q<0 if P is on the left of O"... when I write the coordinate of P, I have to written "+q", isn't it? $\endgroup$
    – sunrise
    Commented May 28, 2013 at 21:41
  • 1
    $\begingroup$ Yes, that is true in general. $\endgroup$
    – Izzhov
    Commented May 28, 2013 at 21:43

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.