4
$\begingroup$

If you leave a sailing yacht (no sails set, motor off, rudder centered) all to itself it will eventually align with the direction of the wind. The stern will point to where the wind is coming from and the bow will point to where the wind is going to.

If the boat is anchored (at the bow) it's the other way round: the bow will point into the wind and the stern will be where the wind is going.

(I hope my observations are right - otherwise all of this won't make any sense)

Each of these scenarios individually observed is clear to me in a "what else should the boat do?" kind of way. But the exact physical explanation would be interesting.

Particularly the first case is the one I'm struggling with: is the bow moving away from the wind because it is lighter than the stern? Or is it because of the shape of the boat? Other reason?

$\endgroup$
9
  • $\begingroup$ Boats perpendicular to the wind will experience a high pressure on one side, meaning that it is the most unstable there. $\endgroup$ Commented May 15, 2018 at 17:42
  • $\begingroup$ In the first scenario, the boat is not anchored at all - is that correct? $\endgroup$
    – NickD
    Commented May 15, 2018 at 18:29
  • $\begingroup$ That’s correct, yes. $\endgroup$
    – Krumelur
    Commented May 15, 2018 at 18:42
  • $\begingroup$ boats are designed for minium resistance to removing air in forward motion, pointed and slanted. The wind follows that, minimum resistance direction ( when moving, a boat sees pressure as if there is a wind against its motion) $\endgroup$
    – anna v
    Commented May 15, 2018 at 19:21
  • 2
    $\begingroup$ en.wikipedia.org/wiki/Center_of_lateral_resistance suggests that not all boats exhibit this phenomenon, and that it can be tuned based on boat design. $\endgroup$
    – BowlOfRed
    Commented May 15, 2018 at 19:43

3 Answers 3

1
$\begingroup$

Warning: Long post.

Here's what happens with canoes and similar boats that are symmetrical or nearly so, and I think this is quite instructive regarding the principle that's at work here. I also see the same thing happen with any basic, small rowboat/motorboat when the outboard motor is raised, if there is one. These boats will invariably orient themselves at a right angle to the wind and drift directly sideways (with any slight variations from this orientation being the result of a tendency toward one of the modified situations explained below). This is a result of there being a point of balance between opposing forces as the boat drifts sideways. These are the opposing forces of both wind and water, which also are balanced according to the characteristics of the parts of the boat which are forward and rearward the center point. Making a boat drift with one end facing the wind and the other end pointing downwind (with no attachment to something other than the water that supports it, such as with an anchor line) is absolutely impossible without making drastic changes to the boat's underwater profile, the above-water profile, and usually both, thus creating a very unsymmetrical boat, as explained below.

In the case of a canoe or similar craft which is basically symmetrical, if the load is shifted toward one end, that end will sink more deeply and experience more drag as the craft moves sideways through the water as a result of the wind, and the opposite end will rise and have less drag. At the same time, the raising of the light end and lowering of the heavy end will cause the wind to "get a better grip" on the light end of the craft. The result of this combination of factors is that the boat pivots to some extent so that the lighter end faces more downwind than before, but the boat will still be drifting essentially sideways through the water, still moving essentially straight downwind (actually, in this case it will be drifting slightly diagonal to a straight-downwind direction, and this is explained below for the motorboat example). Only by unbalancing the trim so drastically that the stern is overloaded and the bow is high up out of the water will the boat turn to face almost straight downwind as it drifts in that direction. Clearly, it takes a large difference in drag between one end of the boat and the other to make it pivot to the point of being well lined-up with the wind as it drifts, and this applies both to the drag of the in-water portion of the boat, AND the drag of the wind on the out-of-water portion. However, experience shows that the profile and drag distribution of the underwater portion of the boat is more important.

In the case of the "basic little motorboat" mentioned above, tilting the motor down to the operating position will create more drag at the stern of the boat than at the front as the boat is drifting sideways, and the boat will pivot slightly toward a downwind heading as it drifts, and even to the point of having a mostly-downwind heading of there's enough drag at the stern via the motor in proportion to that of the rest of the hull. However, I've never seen one of these boats point straight downwind as a result of putting the motor down. It would take a much larger rudder-like object at the stern than the drive unit of the outboard motor to cause that to happen (a bit off topic but illustrating the principle at work here, dragging a substantial sea anchor with the rope attached to one extreme end of the boat WILL cause the drifting boat to orient itself in direct alignment with the wind). This is a trait that most old-school fishermen (those who fished back in the days before everyone had electric trolling motors on their boats) know how to use to their advantage when drifting, because the boat will drift at a slight angle to the direction that the wind is blowing when the motor is in the down position and the boat is oriented slightly diagonal to the wind.

Since a small motorboat drifting in this diagonal orientation can be made to "balance" its orientation with the bow pointed either slightly to the left or slightly to the right of the straight-downwind orientation, a savvy fisherman can make his boat drift slightly diagonally to to the wind in either direction as well, by manipulating his boat into one diagonal orientation or the other before beginning his intended drift.

I've been away from the study of physics for too many decades to use proper terminology to describe the combination of forces involved in these situations, but likewise, decades of very frequent experience in small boats and windy condition has taught me how this works and the mechanism behind it. As noted above, it requires a very asymmetrical hull design to result in a boat that drifts with the wind while actually pointed in the downwind direction. However, there's another aspect that could be at work here. The balance point between front and rear which is referenced above, moves progressively forward with increased speed. In a sailboat, that balance point must match the location where the force of the wind is transmitted to the hull, and that is likely near the center of the boat. A sailboat that is designed for high-speed operation will have the balance point near the center of the boat when moving at high speed, but when stationary, that point would be significantly astern of center. Thus, a boat having that kind of design might have a balance point that is far enough toward the rear that the boat naturally assumes a downwind heading when drifting. For more on this pivot point and its forward shift with increasing speed, see below. You can see that the pivot point is not a simple thing, and not the same under all conditions.

https://southernjointbranch.co.uk/wp-content/uploads/2017/07/Paradigm-Shift-in-SH20150526-for-Web-via-AB.pdf

https://adventurecurated.com/tips/canoe-skills-worth-mastering/

While not directly referenced in these articles, the pivot point that is described is also the balance point when drifting with the wind. Thus, for a centrally-located pivot point, the result is just as described at the beginning of this post, resulting in a boat orienting itself sideways to the wind and moving sideways through the water.

$\endgroup$
0
$\begingroup$

On the boats I've had, what matters is where the center of wind pressure is, relative to the center of resistance to pressure due to motion with respect to water. If there is anything sticking up near the front of the boat, like a mast or a person, or if there is more keel near the back of the boat or anything like a propeller dragging in the water, the prow of the boat will move downwind more easily than the stern. Most boats have a prow that extends some distance forward of the waterline, and a stern that drops pretty directly into the water, so usually boats turn downwind when drifting.

$\endgroup$
-1
$\begingroup$

When a boat is left alone, its most natural pivot point is its rudder or some point between the rudder and the keel, i.e, closer to the stern.

When a boat is anchored at the bow, the obvious pivot point is the bow.

Regardless of the pivot point, a boat should assume the orientation along the wind direction to minimize its resistance to the wind or to minimize torques trying to rotate it around its pivot point.

$\endgroup$
4
  • $\begingroup$ Does that mean if I were to put the rudder to the bow without any other changes, it would rotate around the bow and the different masses of stern vs bow don’t matter? $\endgroup$
    – Krumelur
    Commented May 15, 2018 at 19:42
  • $\begingroup$ I did not make any assumptions about the weight distribution. I imagine that increasing the weight near the bow could make a difference, but pieces under the water should play a big role. $\endgroup$
    – V.F.
    Commented May 15, 2018 at 19:47
  • $\begingroup$ This doesn't answer the question. $\endgroup$
    – user4552
    Commented May 15, 2018 at 21:35
  • $\begingroup$ @BenCrowell Could you clarify your verdict, please? $\endgroup$
    – V.F.
    Commented May 15, 2018 at 22:19

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.