> The figure shows the tungsten filament with a constant diameter except for a piece of it which has half of the diameter as the rest of the wire. Assume the temperature is constant within each part and changes suddenly between the parts. If the temperature of the thick part is 2000K, the temperature of the thin part of the filament is as:
>[![enter image description here][1]][1]

I considered applying Fourier law hereby assuming the temperature of the middle part as $T$ and the thick part taking the midpoint of the thin part than from the midpoint of the thin part to end thick rod. After that assuming steady-state and approximating derivative as finite difference (*)

$$ \frac{dQ_{in} }{dt} = \frac{dQ_{out} }{dt}$$

By fouriers law:

$$ \frac{dQ}{dt} =  - k A \frac{dT}{dx}$$

Hence,

$$ -k A \frac{\Delta T_{left}}{\Delta x} = -kA \frac{\Delta T_{right}}{\Delta x}$$

Now if I since I took the midpoint of the rod, the $\Delta x$ cancel, the areas cancel and conductivity cancels. This leaves me with:

$$ \Delta T_{left} =\Delta T_{right}$$

Now, the temperature difference from middle part to right (I.e: $ \Delta T_{right}$ )is given as $ 2000-T$  and for left part it is given as $ (\Delta T_{left})$ which is $ T-2000$:

$$ T-2000 = 2000 -T$$

Hence,

$$ T=2000$$

But... this is wrong?


----------

**Self-Research attempts:**

In  [solutions I found on the internet][2],  they equate the a term which looks like a joules heating effect in current electricity to the Stefan Boltzmann law. I have written the equation they've used below:

$$ ( \frac{dQ}{dT})^2 R = \sigma A T^4$$

Where R is the thermal resistance

As far as I understand, the Stefan Boltzmann law is [regarding radiation][3] and the Fourier heat law is heat transfer through thermal conduction. I assume that they derived the equation of $ ( \frac{dQ}{dt} )^2 R$ using Fourier's law, this makes it even more confusing of how these two forms of heat transfer are equal.



----------
*: I feel a bit uneasy doing this because it is written in the question that the temperature spike is sudden so the function must be discontinuous at that point


  [1]: https://i.sstatic.net/1B542.jpg
  [2]: https://www.sarthaks.com/432423/the-figure-shows-the-tungsten-filament-of-a-bulb-with-constant-diameter-except-piece-of-it
  [3]: https://physics.stackexchange.com/questions/584212/is-stefan-boltzmann-law-regarding-thermal-radiation-or-thermal-power
  [4]: https://physics.stackexchange.com/questions/439580/calculating-rate-of-heat-loss-through-conduction-and-radiation