Questions tagged [power]

The time rate of change of energy

584 questions
Filter by
Sorted by
Tagged with
2k views

Power dissipation in circuits:Why is high voltage used in power lines?

I know this question has been asked before, but there is one doubt I still cannot clear. Power dissipation is proportional to $I^2R$. Does this not mean that it is also proportional to $V^2/R$? If ...
1k views

Is a billion volt electrical transmission line possible?

Because $$P_{\,\displaystyle\rm loss}=\frac{P^2R}{V^2}$$ in an electrical line where $R$ is the total resistance Why not use a $1$ billion volt line instead of a $800\,\rm kv$ line? Is there a ...
9k views

What does it mean when we say that power of a bulb is 10 W? Since $V/I=$ resistance is a constant, how can power $=VI$ be a constant?

My question is simple. In Ideal situation, at constant temperature, we know that normal appliances like a filament bulb has straight Voltage vs Current graph, meaning its resistance is constant or ...
1k views

Why is there no upper-bound on power-efficiency of Hydro-turbines?

We have Betz's law, an upper bound on power efficiency, for wind-turbines. But there is no theoretical upper limit on hydro-turbines, Why this is so? Is it mainly due to the incompressibility of ...
9k views

Is it possible to get energy from electrical wire using induction?

Pardon me if this is a stupid question but my physics courses are from a long long time ago and I was a teenager back then. ;) Electricity in a wire generates electromagnetism, right? Would it be ...
383 views

How is the dot product a generalization of multiplication?

I've seen an interesting explanation for lots of what I previously thought were unmotivated definitions in Newtonian mechanics, namely that power is always defined as effort times flow. But when ...
856 views

Why aren't (domestic) kettles insulated?

In my experience of buying and using kettles, I have come across none which are insulated. The obvious reasons as to why it would be beneficial being that heating time would be reduced, similarly, ...
175 views

Did Usain Bolt really sustain 11 horsepower of exerted power during the 100 m sprint?

I've just come across a WP article which says: "The Jamaican sprinter Usain Bolt produced a maximum of 3.5 hp (2.6 kW) 0.89 seconds into his 9.58 second 100-metre (109.4 yd) dash" Out of curiosity, I ...
613 views

How should I think about voltage and power?

I have been extremely confused about exactly how to think about voltage (and power) when it comes to circuit analysis. In physics, voltage is just described as the energy required to move a unit ...
565 views

How does the energy remain conserved in a transformer?

The induced voltage in the secondary coil of a transformer is given as $\frac { { N }_{ S } }{ { N }_{ P } } *{ V }_{ P }$ (where ${ N }_{ P}$ and ${ N }_{ S }$ are the number of turns in the primary ...
3k views

Why high voltage transmission lines?

This is a question which I seem to have tackled multiple times, solved each time after reading a dodgy internet explanation, then partially forgotten about and retackled half a year later. It is time ...
9k views

Why do people with bigger hands/wrists have bigger torque advantages in arm wrestling?

I have arm wrestled people with less strength than me who win simply because they have thicker wrists, or larger hands. It has nary to do with having better technique either, because their wrist size ...
8k views

Calculating displacement amplitude of ultrasonic power transducer

I am not a physicist, but my current project drives me to some physics-related computations, hence seeking help. I have some ultrasonic transducers, 5938D-25LBPZT, for which very limited information ...
103 views

Have Sterling Engines Been Used In Outer Space?

I was reading about Stirling Generators having potential applications for power generation in outer space. Have Stirling engines ever been sent into space?
123 views

Passively moving air [closed]

I'm interested in channeling air into an underground condenser to generate water. Which of these approaches would be most appropriate, and is there a better approach I haven't considered? A: A wind-...
1k views

How much power to keep surface of aluminum plate at given temperature? [closed]

I want to heat one side of an aluminum plate enough to hold the other side of that plate $100K$ above ambient. I'm willing to assume that the heated side of the plate is "well" insulated (along with ...
364 views

Why does a rocket engine have increasing power as the speed of the rocket increases? [duplicate]

Sorry to repeat this question, but I got no definite answer last time, so I am trying to state the question more clearly. Power = force x distance / time = force x velocity. So if we apply a small ...
3k views

Can a nuclear reactor meltdown be contained with molten lead?

If lead can absorb or block radiation, would it be possible to pump molten lead into a reactor core which is melting, so that it would eventually cool and contain the radiation? Is there something ...
17k views

What is the relationship and difference between BHP and Torque?

I've recently been looking into performance figures for various auto mobiles, and I see the terms BHP and Torque used quite often, but I can't say I really understand the terms, or how they relate to ...
3k views

Power to suspend a mass in air

How much power is needed to suspend a mass in the air? The four parts below deal with the same problem. I post them all here, should there be some subtle things I didn't see. The textbook problem A ...
8k views

How power lines use high voltages with a low current?

I've read that power lines use high voltages and low currents to reduce power loss due to resistance. Looking at the formula for power - P = VI So to increase P, you increase V rather than I for ...
4k views

Harvesting electricity in the air from power lines:

Recently I came across this quote on the internet, about a person who apparently set up devices to extract electricity from the "air", on his own property: I read an article a couple of years ago ...
109 views

How can we show Power = $\mathbf{F}\cdot \mathbf{v}$? [duplicate]

How can we say that $$\text{Power} = \mathbf{F}\cdot \mathbf{v}$$ We know that small work done by a force $\mathbf{F}$ to displace an object by '$\mathbf{x}$' is $$W = \mathbf{F}\cdot \mathbf{x}$$ ...
1k views

Why does the work-energy theorem need to include internal forces?

Can anyone kindly explain me why work energy theorem must also include internal forces? The proof of work energy theorem is derived from Newton's laws of motion, but Newton's laws of motion don't ...
4k views

How are the CPU power and temperature caculated/estimated?

From Wikipedia The power consumed by a CPU, is approximately proportional to CPU frequency, and to the square of the CPU voltage: $$P = C V^2 f$$ (where C is capacitance, f is frequency ...
640 views

Should we forget fusion and focus on geothermal power? [closed]

Firstly I can say that I would love us to come up with a sustainable fusion solution. However with the latest estimates being 2050 at the earliest for an effective fusion solution and the planets ...
217 views

High Voltage Powerlines - clarification of energy loss

I've been having a bit of trouble understanding the High-Voltage powerlines. If I was sending power from $A \rightarrow B$, we have: Ohm's law $V = IR$ Power lost in the form of heat $P = I^2 R$ ...
289 views

RMS Values in AC Circuits

When do you use RMS values when calculating power? My physics textbook provides several equations for determining the power dissipated in AC circuits. For example, there are power equations using ...
2k views

Engine fuel consumption vs power

Something that has bothered me for a long time is why a 600 hp engine uses more fuel per kilometer than a 80 hp engine. Let pretend I have two equal cars (same shape same weight etc) except for the ...
681 views

What does Power really mean?

I've been trying to solve a problem for some time. I have been given conflicting information by both literature, colleagues and people on this very forum. It's a very simple question: What is the ...
7k views

Does the 'mAh' rating of a battery have something to do with its power?

I'm curious about the 'mAh' of a battery: how can this impact the power of the battery? I've done some research on the internet, and most of the articles I found explain about the 'amount of charge ...
296 views

If I directly connect two terminals of 3V battery (negative to positive) using copper wire, would it lose all its charge faster compared to another 3V battery that is used to lighten a 1.5V bulb?
189 views

Can a solar thermal collector designed for use in homes ever power a stirling engine designed for use in homes?

Can a solar thermal collector common on private roofs today designed for collecting heat for the household ever collect enough heat to power a stirling engine of say this model: http://www.whispergen....
337 views

How much power can be drawn from stray electromagnetism in the atmosphere?

I know this probably varies quite a bit from place to place on earth. But just some rough estimates: if I were to pull power via multiple antennae tuned to a variety of different frequencies, how much ...
60 views

Why does current arrange itself in such a way as to minimize power loss in resistors connected in parallel?

In problem 2 in Problem Set 6, it is said: "Electricity prefers to flow in the way that minimizes energy loss to resistance." Using Lagrange multipliers I was able to show that assuming the above ...