I have found several discussions on how to calculate the sag of rope that is tied off at two points (like a tightrope), and I understand it to a certain extent. What I can't wrap my head around is how come it is impossible to pull the rope tight enough that the sag goes away completely? I'm talking about big thick ropes, like a tightrope that has to be strong enough to hold at least one person. I can pull a piece of string so that it's perfectly straight...does this just have to do with scale?

I like physics, but I'm not great at it, so if someone could answer this in as close to layman's terms as possible, that would be greatly appreciated.


5 Answers 5


This is the boring answer that your physics teacher would give you :-)

enter image description here

The diagram above shows an idealised rope with all it's weight concentrated at the centre of the rope. If the rope mass is $m$ then the force downwards is just $mg$, where $g$ is the acceleration due to gravity.

Suppose you're pulling on the rope with force $F$, and the angle of sag is $\theta$. Because the rope is at an angle, when you pull on the rope you're pulling partly sideways and partly upwards, and the upwards part of your pull has to balance out the force $mg$. If the angle is $\theta$ then the component of your pull in the upwards direction is just:

$$ F_up = 2Fsin(\theta) $$

and because this balances the downwards force, $mg$, we get:

$$ 2Fsin(\theta) = mg $$

To find out how hard you need to pull we rearrange this to get:

$$ F = \frac{mg}{2sin(\theta)} $$

For very small angles, $\theta$, we use the approximation that $sin(\theta) \approx \theta$ and our equation becomes:

$$ F \approx \frac{mg}{2\theta} $$

and you can now see why it's impossible to pull the rope straight. As you pull the rope straighter $\theta$ becomes smaller, and for the rope to be completely straight $\theta$ would have to go to zero. But the force is proportional to 1/$\theta$ so to get the rope straight the force would have to be infinite.

For light ropes/strings the force $mg$ is very small, so we can eaily pull the string straight enough that by eye we can't see the sag. The sag is still there but it's to small to see. With a heavier rope $mg$ is greater and we simply can't put enough force in to make the sag too small to see.

  • $\begingroup$ $\cos(\theta)$ does not go to zero as $\theta$ goes to zero, it goes to $1$. $\endgroup$ Commented Jun 19, 2012 at 7:48
  • $\begingroup$ Oops, I meant sin($\theta$) of course :-) I'll edit my answer. Thanks for spotting the typo. $\endgroup$ Commented Jun 19, 2012 at 7:51
  • $\begingroup$ Thanks for your answer! I +1'd it, but I understood Mark's a bit more :) $\endgroup$ Commented Jun 22, 2012 at 2:44
  • $\begingroup$ OK here's a question. Would the force required change if one side of the rope were attached to a wall? $\endgroup$
    – AaronF
    Commented Dec 4, 2016 at 7:14
  • $\begingroup$ No, the wall then will pull the string with same force as f, you can visualize the picture as both ends are attached to wall $\endgroup$
    – Nemexia
    Commented Nov 16, 2017 at 12:47

There are three parts to this:

  1. In mechanical equilibrium, things go to their lowest energy state.
  2. A straight line is the shortest distance between two points.
  3. Whenever you've minimized something, it means that small deviations don't change its value (to first order).

Let's start with the third point, which is mathematical, and then look at the physics of the situation. Take a look at this hill:

enter image description here

At the bottom, it's flat, which the middle red line shows. When you look on the sides away from the bottom, it's sloped. So if you want to be at the bottom, you need to be somewhere where small steps in any direction don't change your height. When you minimize a quantity, small deviations don't change it.

On to the physics.

enter image description here

The black things are pulleys on supports. The brown thing is a rope. The grey things are weights. How heavy do the weights on the sides have to be to pull the rope straight?

The physics of a system like this is that the weights will try to fall as much as they can. Another way to say this is that at equilibrium (i.e. nothing is moving), systems go to their lowest possible energy state. (Or a local minimum, at least.)

There's a tradeoff here in terms of energy. You could pull the middle weight down further, lowering its energy, but that would yank the end weights up some, raising their energy. The system will have to find the right angle of the ropes so that the energy is minimized.

A straight string will never minimize the energy, though. It's the shortest possible path between the two supports. Since it's the shortest path, small deviations to that path don't change its length to first order. (That's the math point from the beginning of the answer.) That means that you could always lower the energy a little bit moving the middle weight down. The side weights don't go up because the distance between the middle weight and the posts isn't changing. Meanwhile, the middle weight is going lower down, so the total energy of the system goes down. That means the straight line is never the lowest energy state, and so can't be the equilibrium configuration.

  • 4
    $\begingroup$ Several parts of this answer don't make much sense to me. If the rope is inelastic, how could you pull the middle weight down (thereby increasing the distance between each pulley and the middle weight) without the side weights going up? Also why does the bottom of a hill have to be big enough for me to take steps that don't change my elevation? Couldn't the bottom be only a few inches across, for example? You mentioned mathematics but didn't explain any of the statistical terms you used. $\endgroup$
    – TylerH
    Commented Mar 21, 2016 at 14:38
  • $\begingroup$ When the rope is straight, you can pull the middle down without the side weights going up to first order. When the rope is not straight, the side weights will have a first-order rise when you pull the middle down further. The bottom of the hill is where steps do not change your height to first order. I don't know what statistical terms you want defined. $\endgroup$ Commented Mar 21, 2016 at 23:26

You can't pull a piece of string perfectly straight - you just can't see the sag.
(excluding the limit where variations in the thickness of the string are greater than the sag)

Two simple ways of looking at it:
Mathematically - As you pull tighter the sag gets less, but it's a function of 1/force, so to get zero sag you need infinite force.

Physically the force is only applied sideways, as the particle of string gets less sagged the vertical effect of the sideways force gets less so if it was infinitesimally just below straight the force would have infinitely small effect and so there would be nothing to pull it up into perfectly straight.


You will not be able to make a string completely straight in the influence of gravity as you earlier thought, because any string/rope has its own weight and that leads to sagging of the rope. Usually in high school education this fact is not pressed upon, by considering an ideal string/rope (that doesn't have mass at all). When you sit down to do mechanics with a massive string, then you need to account for the mass of the string as well. What one does is in that case at a point he takes a infinitesimal segment of string having mass $dm = \mu.dl$ and equates force in horizontal and vertical directions.

  • $\begingroup$ Simply put there has to be a vertical component to the tension to support the weight of the cable, and the tension is always "in line" with the cable curve. $\endgroup$ Commented Jun 19, 2012 at 21:44

Well, if the string was pulled such that it was along a radial arm from the centre of the "earth", in other words, in a vertical, then it wouldn't sag. Any deviation such that it is no longer exactly vertical, then the above answers come into play. I know this isn't what you are really asking, but let's admit, it does apply to the question as stated.


Not the answer you're looking for? Browse other questions tagged or ask your own question.