0
votes
1answer
30 views

Calculation of Pressure from flow rate of water

Anybody kindly help me to find how to calculate pressure in barr from flow rate. I have a pipe and from that I am transferring water at a constant flow rate of 5ml/min so at this flow rate with 0.5 cm ...
5
votes
2answers
107 views

Difference between weight of water and pressure of water

(I didn't even have a basic formal education in physics. I'm learning through the internet out of my own interest, so if there are any silly mistakes, kindly bear with and guide me through.) ...
0
votes
0answers
19 views

Building a magnetron powered steamer

I am wanting to build a microwave powered steamer for a reverse engineering project in university. I've read up some on this and know that its not as efficient as a heating element. I'm curious about ...
0
votes
3answers
163 views

In what situations do water levels not reach equilibrium?

I have been taught that water levels will always equal out. However, now I find that sumps and some other setups allow for water not to become equal. What other arrangements allow for the water levels ...
-3
votes
1answer
124 views

Slope of a channel

I have a trapezoidal channel like this: The question is to get the slope of the channel such that we have a Chézy coefficient of 64 $m^{1/2}/s$. Given: $B= 76\: \mathrm{m}$, $y = 10\: ...
0
votes
1answer
163 views

Which one conducts heat better: water, or air?

If we were to assume room temperature of 20C, which of the fluids conducts heat better, and why?
1
vote
0answers
86 views

How much heat needed to heat 400g of ice at 0°C to 20°C in a 200g aluminium pot? [closed]

An aluminium pot has a mass of 200g and contains 400g of ice at 0°C. How much heat would be needed to melt that ice and then raise the temperature of the resulting water to 20°C. The specific heat ...
-2
votes
2answers
258 views

How much water from ice and after how much time? [closed]

I need two formulas in dealing with ice and water. First: If I have 2 x 2 x 2 (cm) ice cube, after it melts, how much water will there be ? Second: If I have 2 x 2 x 2 (cm) ice cube, after how ...
-2
votes
0answers
179 views

The formation of ice from water properties? [closed]

The formation of ice from water is accompanied by: A. absorption of energy as heat B. temperature increase C. decrease in volume D. an evolution of heat E. temperature ...
4
votes
1answer
307 views

Plastic bottle floating and sinking

I was doing this experiment: i take a plastic cup, put in a container of water, it floats – then when I put a coin in the water, it sinks and rests at the bottom. So to make the cup sink, i fill it ...
0
votes
0answers
122 views

Calculating Integrated Precipitable Water using GPS

I'm trying to calculate the Integrated Water Vapor (IWV) using GPS data. I'm following the equations in the following publication: GPS Meteorology: Remote Sensing of Atmospheric Water Vapor ...
1
vote
2answers
109 views

Possibility of determining the mass of the water without a scale?

Possibility of determining the mass of the water by knowing water volume, water temperature and atmospheric pressure. I want to know if I can determine the mass of $V=0.01\,m^3$ of water in ...
0
votes
1answer
1k views

Calculating the coefficient of thermal expansion in liquid

I am trying to write a matlab function that calculates the coefficient of thermal expansion of water from a given temperature. From what I understand the thermal expansion coefficient is calculated as ...
0
votes
3answers
632 views

Pascal's law: pressure of fluid at different locations

I know that's stupid question, but I'm really confused what my teachers says, so I need to check that theory. Here are just two ordinary connected containers, which are full of water. On grounds ...
2
votes
1answer
460 views

Sensible heat question (solving for temperature)

If $55 034.175 \rm{kJ }$ of heat are transferred to $150 \rm{kg}$ of ice at a temperature of $-12.15 ^\circ \rm{C}$, calculate the temperature of the resulting water. Using $Q = mc(t_2-t_1)$ or ...
1
vote
1answer
332 views

Does increasing the density of a solution decrease the rate of temperature change?

I did an experiment to compare whether salt water (5% concentration of salt) or fresh water of the same volume took longer to heat up to a certain temperature. We found that salt water took longer to ...
3
votes
1answer
444 views

Pascal law with two connected cylinders filled with water, and 50kg stones at both their ends

If I have two connected cylinders filled with water, and 50kg stones at both their ends (pressing both ends of the water) how much weight do I need to add on one side so that one of the stones reach ...
0
votes
0answers
181 views

Reduction in velocity in pipe

I have two pipes divided from main pipe. If I add one more pipe, what would be the amount of velocity in each pipes. I know the velocity of main pipe, then diameter and radius of each pipe. Edit: 1) ...
3
votes
4answers
467 views

Water to ice expansion in $1\textrm{mm}^3$ pit - pressure on the pit walls?

[EDITED] by mistake, the subject was regarding 1m^3 instead of 1mm^3. There should be a significant difference between the two... A 1x1x1mm pit filled with water is frozen at a slow rate (1K/minute). ...
2
votes
1answer
851 views

How much water must flow trough canal to maintain a constant water deep?

In order to maintain a constant water deep in canal, how much water must flow trought the pipe ? As shown on picture, canal have a rectangular shape. I don't know if canal length have an influence. ...
-1
votes
1answer
1k views

Mixing Water at Different Temperature

If I have cup of water at room temperature (say, $25^\circ$C). What would be the resultant temperature if I pour another cup of same amount of water at $100^\circ$C to it? Is it simply ...
0
votes
1answer
608 views

Temperature change effected by electric heater [closed]

A 40-gallon electric water heater has a 10kW heating element. What will the water temperature be after 15 min of heating if the start temp is 50F degrees. There must be an equation. I can't find it ...
2
votes
1answer
5k views

Best way to solve P-V-T Question

Typically in an exam or problem set we have a problem that's like this: Determine the specified property at the indicated state of water. Locate the state on a sketch of the T-v and P-v diagram. p= 3 ...
1
vote
3answers
1k views

Maxiumum weight a buoy can float [closed]

I have a buoy that can hold 2943.02 cubic millimeters of non-pressurized air, I need and equation to work out the maximum weight that the buoy can float.