4
votes
2answers
151 views

Voltage drop due to a resistor

I'm afraid this question is going to sound rather dumb but here it is: Suppose I have a very simple circuit: one battery and one resistor. The sum of the voltages in this circuit has to equal zero. ...
0
votes
2answers
34 views

Calculating emf with and without resistance

A battery of internal resistance 2 Ohms is connected to an external resistance of 10 ohms. The current is .5 A. What is the emf of the battery? The correct answer is 6.0 V. When I calculated it like ...
1
vote
1answer
37 views

Voltmeter readings at different points in a circuit

I have a circuit with a 6 volt battery and 2 resistors A and B in that order.A has a potential drop of 2 volts and B has a P.D of 4 v. which means every electron moving across the resp. resistors ...
0
votes
1answer
33 views

Getting maximum power/brightness from 5 lightbulbs with different resistances [closed]

Hi I am trying to figure out the best way to arrange 5 lightbulbs to get all of them to have the maximum brightness with a 30V battery. The 5 five lightbulbs have different resistances: 3ohms, 6ohms, ...
3
votes
5answers
1k views

Is voltage always proportional to its derivative?

We write, because of Ohm's law: $$V=RI(t),$$ but also we have $$C\frac{dV}{dt}=I(t).$$ From the first equation we deduce that $V\propto I$ and from the second $\dot V\propto I$. So we can conclude ...
-1
votes
2answers
63 views

Is $V= V_1 + V_2$? horrible question but im confused [duplicate]

So yeah , the answer seems true but i'm very skeptical about it since D3 is in the middle
0
votes
2answers
99 views

$V = V_1 + V_2$ confusion? Why is my “proof ”incorrect? [closed]

Why isn't $V= V_1 + V_2$? $V=V_a - V_c = V_a - V_b + V_b - V_c$, $V_a - V_b= V_1$ and $V_b - V_c = V_2$ Doesn't that prove that $V = V_1 + V_2$? Regardless of $V_3$, If i'm wrong , is there a way ...
0
votes
1answer
42 views

2 simple Generators = Im lost (intensity)

What happens? we have 2 Generators and 2 intensities, when I2 and I3 come together (they have opposite sides ) what happens? I tried writing down the voltage relations but I'm stuck because I don't ...
0
votes
1answer
27 views

Is real voltage always the real part of complex voltage?

If I have a complex voltage $V_z$ is real voltage $V$ (i.e. the voltage used in the normal ohms law and the voltage we normally talk about) always given by $V=Re(V_z)$. Does the same apply to current? ...
1
vote
2answers
49 views

Finding the current in a parallel circuit [closed]

Two resistors are joined as shown. The top resistor receives a current of 3 A. What is the current in the other resistor? What is the current that enters at junction A? I'm confused on how the two ...
0
votes
3answers
62 views

How is voltage increased from a battery?

I have recently watched a video about a powerful Octa-copter that uses 30,000 Volt brushless motors to propell, the batteries however look quite small about a 19v laptop battery. How is the voltage ...
0
votes
3answers
64 views

What does raising voltage do?

If I raise the voltage of a wire from 0V to 1000V and then to 5000V, am I merely packing it with more and more electrons (with those electrons being trapped there until they find a path off the wire)? ...
0
votes
1answer
18 views

Unsatisfactory explanation for the EMF measurement of a battery

Experimentally, I have seen how hooking up a battery to a simple circuit just with a high-resistance voltmeter raises the voltage reading (allegedly to a level equal to the EMF of the battery). ...
0
votes
2answers
28 views

potential difference in parallel connecting resistors

How could the potential difference be constant across all the resistors of parallel connecting resistors although each resistor has a specific resistance?
17
votes
4answers
2k views

Are voltages discrete when we zoom in enough?

Voltages are often thought of as continuous physical quantities. I was wondering whether by zooming in a lot, they are discrete. I feel like the answer to the above question is yes as voltages in the ...
0
votes
1answer
29 views

Name of battery voltage when load connected/disconnected

If I had a 3V battery, and when no load connected it reads 3.2V, and with a load 2.8V (just a hypothetical example), what is the name for these two terms, with a load or no load? I know the voltage ...
0
votes
1answer
59 views

Simple Parallel Electric Circuit [closed]

Ammeter (A1) and voltmeter (V) in series have parallel connection to another ammeter (A2). Currents in A1 and A2 are respectively 0.2 and 1.7 amp. Voltmeter's voltage is 6 volts. How should I find ...
1
vote
1answer
74 views

Interpreting Physics Results Regarding Circuitry Analysis (Highschool Level Physics) [closed]

I conducted an experiment which aimed to detail and record the voltage across series resistors in series circuits. I noticed that: The Final Voltage, V3, stayed the same. The resistors with the ...
0
votes
1answer
78 views

The Voltage and Current of a Discharged Inductor at the Instant the Switch is Closed

The figure shows an LR circuit with a switch and a 240-volt battery. At the instant the switch is closed the current in the circuit and the potential difference between points a and b, Vab, are ...
1
vote
0answers
64 views

Voltage in a lossless transmission line

I have a question where I'm deriving expressions for different variables within a lossless transmission line. Here's the question as posed: Consider a lossless transmission line of characteristic ...
1
vote
5answers
170 views

Ohm's Law Intuition

When we derive Ohm's Law using the Drude Model, we assume at one point of time that $E=V/L$, when is fact, $E=dV/dL$, unless $E$ is constant, in which case the assumption $E=V/L$ is true. But I don't ...
0
votes
1answer
55 views

Back EMF & Current, how can we make I stable?

Lets assume we have a wire that has $10V$ across and $1$ $Amp$ flowing, now if this conductor is introduced to a changing magnetic field, $-EMF$ is induced, can we control our voltage to increase it ...
1
vote
1answer
292 views

The shape of the graph of the equation: $V= -r I + E$

I have recently collected data (for a school experiment) in order to measure the EMF and the internal resistance of a solar cell. The data complied with the equation: $V = -rI + E$, i.e. the voltage ...
0
votes
2answers
99 views

Voltage Drop and Charge Flow

I am hoping someone can help me with understanding voltage drop and charge flow. Here is what I think I know. The voltage drop through a circuit must equal the voltage of the battery source, and ...
1
vote
4answers
75 views

Wrong positioned Ampere-meter and Voltmeter [closed]

I'm dealing with a problem here and even that I'm trying to solve it i can't It says: In what figures the voltmeter and ampere-meter are wrong positioned? I think that all the the others are ...
-1
votes
1answer
119 views

Electric shock from a frayed wire

Let's say it's a laptop charger not connected to a laptop, and it is frayed near the tip. I am guessing about 20Volts runs through that area. Now if a person touches a bit of plastic below the frayed ...
0
votes
2answers
196 views

How to calculate potential in circuit

In the following circuit (that has come up during a BJT DC analysis for what is worth), I'd like to calculate the potential at point B and point E. My notes say that $V_B = -10 + 0.7 = -9.3V$. ...
1
vote
4answers
229 views

Is voltage important when creating a magnetic field?

Would a DC circuit that has a high current and low voltage have a powerful magnetic field? I'm trying to create a powerful solenoid. In order to create a powerful magnetic field, I'm focusing more on ...
1
vote
3answers
848 views

Questions about voltage

For some reason, I feel like the concept of voltage is escaping my grasp. I've done much research on these forums and through texts, and come across answers that seem quite well thought out, but still ...
0
votes
1answer
138 views

Voltage and current in parallel circuit

I am having a bit of a tough time understanding the following: ...
0
votes
3answers
195 views

Current without voltage?

Suppose you have a 120 volt, 20 amp circuit which only has a light bulb connected. When measuring the voltage going to the light bulb my meter reads 120 volts. The basics taught me that a circuit is ...
1
vote
0answers
405 views

Finding potential difference (PD) between two points [closed]

How do I find the potential difference between two points in a circuit without using Kirchhoff laws?
-2
votes
1answer
376 views

Hard circuit problem [closed]

I want to find the p.d. between points A and B. I'm not sure how to approach this problem though, could I have a hint?
1
vote
1answer
58 views

In what way do passive circuit elements change the functional form of the voltage?

I heard capacitors affect the valleys and mounds of voltage sine curves, so that you get DC from AC. It's related to Graetz bridge, flipping signs of sine waves and seemingly afterwards smoothing ...
0
votes
1answer
3k views

Does the phase difference between voltage and current in an LCR circuit exist throughout the circuit?

I know that in an purely inductive circuit the current lags behind voltage by $90^o$, in a purely capacitive circuit vice-versa and in an LCR circuit the current may lag or gain with respect to ...
3
votes
1answer
1k views

Sign conventions for voltage drop and gain in circuit

In Sears and Zemansky's University Physics book and in many other books in English they define the following sign conventions (used for Kirchhoff loop rule for example): While in many other books ...
1
vote
1answer
137 views

Resistance and current

I'm not a current student at any school, but I am learning a new profession, and some of it is a basic understanding of elecrticity. I have some knowledge, but definitely not enough, and I have had to ...
1
vote
0answers
96 views

Circuit Analysis: Help getting the Thevenin equivalent [closed]

I am attempting to solve this problem which requires me to get the Thevenin equivalent of a circuit, and I've gotten as far as getting the equivalent resistance of the circuit (which I believe is 5 ...
0
votes
5answers
8k views

Why does voltage remains same over Parallel Circuit

Why does voltage remains same over parallel circuit. If a resistor is connected in the circuit some of the charge should be transformed into heat and make a lack of charge after the resistor (in my ...
0
votes
3answers
220 views

Potentiometer voltage change

I'm trying to understand simple things about electricity reading allaboutcircuits.com web. This chapter includes image which´s principle I don't understand. Here it is: When supplying constant ...
0
votes
4answers
690 views

If components of differing resistance are wired in parallel, how does a common voltage drop arise?

I've been teaching myself DC electronics as a hobby and, although I have a feeling i'm "missing something obvious", I was wondering if someone could help me out. If two components of differing ...
0
votes
1answer
67 views

Would the empirical behavior of a simple circuit match my model of it?

I have a practical problem in E&M which has baffled me and and my electrician. The copper water pipes in my house are carrying a current of small potential (~1V) AC current. Here is my ...
0
votes
0answers
106 views

About electric current analogy

my teacher gave me this analogy to the electric current , the wire is like a pearl necklace where the pearls can move, the current or the movement of electrons is like putting your fingers between 2 ...
2
votes
2answers
396 views

How to find $\tau$ in this circuit?

1) 2) I know, that $$ τ = \frac{L}{R} $$ but what is $R$ in this formula? It seems to be the total resistance, but how to find it in 1) and 2)?
0
votes
2answers
5k views

What happens when non-equal voltages are put in parallel? [duplicate]

If two batteries, say 2 volts and 5 volts, are connected in parallel, are there any problems? The higher voltage will then want to flow out, but also towards the lower 2 volt battery end, right?
2
votes
1answer
97 views

Help Understanding Non-conservative Fields

While watching a video lecture, I became uncomfortable with the results, (around 35 mins). The professor draws an electric circuit with a 1V batter, and two resistors (1 and 9 ohms). He then ...
0
votes
2answers
463 views

Out of phase voltage current source and resulting power

Examining the following graph, I am trying to understand the power plot. The power appears to take on a negative value when the current changes direction or the voltage changes polarity. Negative ...
0
votes
1answer
3k views

Relationship between resistance and voltage drop

In a series or parallel circuit, if two bulbs have the same resistance, do they have the same voltage drops? The problem I am asking about is below. Do A, B, and C have the same voltage drops since ...
0
votes
4answers
352 views

Why is there a potential difference?

The question then asks for the potential difference between $X$ and $Y$, which is claimed to be $3.6\text{ volts}%$. Why would there be a potential difference in this case? If I connect a lightbulb ...
2
votes
1answer
3k views

Effective resistance of inductor

In a lab experiment, we connected a simple circuit: an AC voltage source, connected (in series) to a variable resistor and an inductor. We measured the current in the circuit, and the voltage that ...