0
votes
2answers
34 views

requirements for hydrogen fusion

What are the requirements for hydrogen atoms to go through fusion? Is it a ratio of heat to pressure or are there specific heat and pressure values that must be met (per atom or per mole?) Are there ...
39
votes
5answers
6k views

Why does a candle blow out when we blow on it? Our breath is 16% oxygen and only 4% CO2

Don't say that a layer of carbon dioxide covers the flame, because our breath has more oxygen than carbon dioxide. Also, our breath does not cool the flame as it is itself warm. So what is happening ...
0
votes
0answers
36 views

How does pressurized gas constantly push?

If a gas, such as hydrogen, is pressurized into an air tight container, a force in terms of pascals (or whatever unit you want to use) is exerted, correct? That is what pushes against every surface ...
0
votes
2answers
99 views

Compression and expansion

Why is it that solids on compression [As in striking a hammer etc.] heat up, but liquids and gases on compression [Pressurizing liquids causes them to freeze or gases to liquify] cool down? Can ...
22
votes
6answers
3k views

Is it possible to “cook” pasta at room temperature with low enough pressure?

It is known fact, that boiling point of water decreases by decreasing of pressure. So there is a pressure at which water boils at room temperature. Would it be possible to cook e.g. pasta at room ...
0
votes
0answers
37 views

Linearity of the critical isochore?

When looking at the pressure-temperature diagram along the critical isochore (up to quite high reduced temperatures) a very linear trend can be observed. From a theoretical point of view, is the ...
1
vote
0answers
80 views

Second derivative of vapor pressure from a cubic equation of state

It is quite easy to compute the first derivative of vapor pressure with respect to temperature from a cubic equation of state at least at the critical point since there is a continuity with the ...
1
vote
1answer
207 views

Is temperature-induced change in the volume of balloons dependent on gas?

Which balloon will have higher relative change in volume, helium balloon immersed in liquid nitrogen or air balloon immersed in liquid nitrogen? Since volume is directly proportional to temperature ...
0
votes
1answer
57 views

Determining if a solution will boil

A piston compresses a solution of 40% $HNO_3$ in $H_2O$. If the piston breaks and the pressure is reduced from 12.0 atm to 1.0 atm: a) If the temperature of the solution is 110 degrees C, will the ...
0
votes
0answers
99 views

Food kept in a container in my pressure cooker cooks slower

The pressure cooker is heated at the base to cook the food. The pressure cooker releases steam when the force exerted by pressure exceeds the counterweight, at which point the weight rises up allowing ...
3
votes
1answer
340 views

Diffusion of gas in a liquid with changing pressure and solubility (chemical potential)

Modelling the diffusion of a gas dissolved in water in a vertical column of water, several meters deep. Also assuming the water is completely still, so only diffusion plays a role. (Actually a model ...
5
votes
2answers
769 views

Why does deodorant always feel cold?

We all use deodorant and they always feel cold, why is that? Is it because it is liquid inside the bottle and a gas when it is released?
0
votes
0answers
58 views

Which pressure to use in the $T~ds$ equation?

Let's say I have an adiabatic, rigid, open container that has an amount of air at some pressure, $P_\text{cv}$, and some temperature, $T_\text{cv}$. I have heated pressurized air coming into the ...
0
votes
1answer
234 views

Calculating the amount of dissolved gases in a liquid?

The most basic situation, water at room temperature, has dissolved oxygen, CO2, and more. Why is this? How would one calculate how much gas should be dissolved in any given liquid?
0
votes
0answers
64 views

Calculating the osmotic pressure in counterion (Manning) condensation

I'm going through Manning article about counterion condensation and I've reached equation 27 $ kT \left ( \phi - 1 \right ) \left (n_1 + n_2\right) = \pi = - \left ( \frac{\partial F^{ex}}{\partial ...
1
vote
0answers
144 views

ideal gas law modelization in a vacuum chamber

I am trying to model a pressure sensor in COMSOL. The basic work is that there is current flowing inside it, if the pressure of the gas around it drops down, the temperature goes down as well (ideal ...
0
votes
0answers
161 views

Constant Pressure lines in evaporation diagram

Assume that there is the following $T-H$ phase diagram with the constant pressure lines. Which is greater preasure? The preasure drops as we move to lower temperatures (i.e. from top to bottom)? ...
1
vote
3answers
1k views

Air pressure in balloon

I have to calculate the air pressure inside of an hot air balloon. After some searching I found out that I can use the ideal gas law: PV = nRT (from Wikipedia) So to get the pressure in the balloon I ...
2
votes
1answer
136 views

Thermodynamics, PV diagrams?

My teacher told me that the total amount of work done on or by a gas can be represented by the area enclosed in the process in a PV diagram. This is only valid for non isothermic processes, right?
2
votes
2answers
44 views

Gas Circulation Using Pressure Difference

Dear all, see attached picture Please, is it possible to have the gas recirculated from the gas phase to the liquid as described in the diagram assuming the gas is not soluble in the water. These ...
1
vote
1answer
2k views

What is the effect of an increase in pressure on latent heat of vaporization?

What is latent heat of vaporization ($L_v$) in the first place? Wikipedia seems to indicate that it is the energy used in overcoming intermolecular interactions, without taking into account at all any ...
0
votes
1answer
79 views

If a balloon is continuously filled with air and stays at a constant shape and size will there be any empty space in the balloon?

If a container like a balloon but with constant volume is filled, is it possible to pack air molecules so closely together that they don't have any empty space between them? If so, what would this ...
0
votes
2answers
378 views

Temperature change inside pressure chamber

Let's say there is a pressure chamber with some sort of sample / specimen (e.g. protein crystal) in it. Now I apply a certain amount of gas pressure, e.g. 10 or 20 atm. Let's say I use xenon as a gas. ...
3
votes
1answer
361 views

Have negative pressures any physical meaning?

Some cubic thermodynamical equations of state predict negative pressures, have negative pressures any physical meaning? Could they be related to negative mass?
6
votes
1answer
143 views

What pressure or tension occurs in a glass jar when I pour boiling water inside?

Sometimes it happens that when you pour a boiling water into a glass jar, it cracks. Since glass is very hard material and resilient to pressure, the tension must be very high. Is it possible to ...
1
vote
0answers
87 views

How to solve state parameters using these givens for an ideal gas?

In a thermodynamic turbine using air as an ideal gas, given that you have a known inlet temperature value $T_i$, a known exit pressure value $P_e$, a known inlet and exit velocity $V_i$ and $V_e$, a ...
3
votes
2answers
693 views

With ideal gases, varying quantity of moles, and having a constant volume how do temperature and pressure behave?

I'm trying to build a simulation of gases so I ended-up trying to use law of ideal gases ($PV = nRT$). In my scenario: volume is constant ($V=1\rm{m}^3$); a known quantity of moles are being added ...
3
votes
1answer
888 views

Area under a $pV$ diagram

What does the area under a Pressure volume diagram equal? I read in my textbook it equals 'external' work done, but why is this? First of all, what exactly is external work? Can you get it ...
3
votes
1answer
189 views

Which heated, partially filled bottle will explode first?

This is in reference to a pasteurization discussion on a homebrewing forum. I have four closed bottles which will explode if containing too much pressure. Two of them are 50% full (A and B), and two ...
0
votes
1answer
4k views

How much work is needed to compress a certain volume of gas?

I want to know the formula (and what does the symbols stand for) for how much work is needed to compress a certain volume of gas?
1
vote
3answers
198 views

Water, can it break through temperature?

If water is heaten up to ridicilously high temperatures, is it possible for the atoms in the molecules to lose their bonds? And if it is possible, isn't this some kind of chain-reaction? Like you ...
2
votes
1answer
2k views

Why did my frozen water bottle explode when I opened it after it defrosted a bit?

Last night I filled a 20 fl oz bottle (http://www.thenibble.com/reviews/main/beverages/soft-drinks/boylans-mash.asp) with lukewarm water from my tap. I filled the bottle pretty much to the brim, ...
2
votes
1answer
1k views

Heat of vaporization of water - dependence on relative humidity?

Does the heat of vaporization of water depend strongly on the relative humidity of the gas into which it evaporates? Some context: If we want to calculate the dew point of water, we find the ...
4
votes
1answer
895 views

What is the meaning of pressure of a solid?

Currently I'm taking an introductory course on thermodynamics. I've got a problem with understanding what is the meaning of pressure of a solid body. The question arose when I looked at phase diagram ...
2
votes
4answers
15k views

Why are volume and pressure inversely proportional to each other?

It makes sense, that if you have a balloon and press it down with your hands, the volume will decrease and the pressure will increase. This confirms Boyle's Law, $ pV=k=nRT $. But what if the ...
9
votes
5answers
4k views

If I take a bottle of air into space, and open it, where does it go?

It seems to me that space doesn't have any/much air, and if my bottle is full of air, when I open it, where does the air go?
-2
votes
1answer
272 views

For how long can we make an air balloon stay flying via remotely controlled heat system?

I wonder how a function $$f=f(h, m_{\mathrm empty}, V_{max}, T_{h}), $$ with the top height $h$, the empty mass $m$, the maximum volume $V_{max}$, and the temperature of the heater $T_{h}$ would look ...
1
vote
2answers
789 views

What is the physical or mathematical meaning of the Gibbs-Duhem equation?

The Gibbs-Duhem equation states $$0~=~SdT-VdP+\sum(N_i d\mu_i),$$ where $\mu$ is the chemical potential. Does it have any mathematical (about intensive parameters) or physical meaning?
4
votes
2answers
234 views

What's the classical limit of the pressure of the ultrarelativistic Bose gas

The pressure for the ultrarelativistic Bose gas is $$p~=~U/(3V) ~\propto~ (kT)^4/(hc)^3.$$ It looks to me like it diverges for $h \to 0$. Looking at the derivation, it diverges because $h$ is the ...
3
votes
1answer
160 views

In a Sterling Engine, does heat from the hot side transfer to the cold side?

A Sterling Engine is a closed system. The "hot" side oscillates between higher temperature with higher pressure and lower temperature with lower pressure. Does Nature switch back and forth between ...
1
vote
1answer
4k views
1
vote
3answers
1k views

When a gas expands against an external pressure of 0, must the stopper on the cylinder be massless?

Basically, I need to conceptually understand why the work a gas does is the integral $\int p_\mathrm{external}dv$ and is 0 when pressure external is 0. I understand why $\mathrm{d}w = - ...
1
vote
1answer
398 views

Given two boiling temperatures and pressures, how can I find the latent heat?

I am given the fact that at a certain pressure a liquid boils at a corresponding temperature, at a different pressure it boils at a different temperature, and then I am asked to find the latent heat ...
4
votes
1answer
196 views

Can i use coils with compressed air to make a superconductor?

What im saying is inside pipes i am going to use compressing so that that in the places with low pressure they cool the superconducotor. is this possible? Can i use this concept to make ...
1
vote
1answer
293 views

simulations at constant pressure-volume and constant volume-temperature

I have read some papers where the authors perform simulations at constant pressure and constant volumen or sometimes constant volume constant temperature. My question is when is it better to use one ...
2
votes
1answer
5k views

Best way to solve P-V-T Question

Typically in an exam or problem set we have a problem that's like this: Determine the specified property at the indicated state of water. Locate the state on a sketch of the T-v and P-v diagram. p= 3 ...
6
votes
8answers
8k views

Why does the gas get cold when I spray it?

When you spray gas from a compressed spray, the gas gets very cold, even though, the compressed spray is in the room temperature. I think, when it goes from high pressure to lower one, it gets cold, ...
4
votes
0answers
944 views

Inflating a balloon (expansion resistance)

I am doing a quick calculation on how to calculate the pressure needed to inflate a perfectly spherical balloon to a certain volume, however I have difficulties with the fact that the balloon (rubber) ...
1
vote
3answers
586 views

Why isn't pressure a measure of energy?

Hey guys, I'm having a problem in understanding the 1st Law of Thermodynamics. If i would increase the pressure of a closed system by compressing a gas in a cylinder isothermal, the 1.Law states, ...
6
votes
5answers
863 views

What would ACTUALLY happen to a person jettisoned into space?

[insert obligatory statement of my lack of knowledge in physics] Alright, so we have all seen the movies where someone gets blasted out of the airlock on their starship, or their suit decompresses ...