Surface tension occurs due to the tendency of liquid molecules to favor their own kind. Surface tension is important in fluid multiphase systems typically at small length and velocity

learn more… | top users | synonyms (1)

19
votes
4answers
2k views

Why does a cork float to the side of a glass?

What is this physical phenomenon and when it's happen ? Please take a look at this picture: Link to picture Notice: This is a cork ball attracted to sides of a glass of water
4
votes
4answers
1k views

What is the physics behind a soap bubble?

A soap bubble is an extremely thin film of soapy water enclosing air that forms a hollow sphere with an iridescent surface. What fluid dynamical process occurs during the popping of a soap bubble?
3
votes
1answer
568 views

Change in appearance of liquid drop due to gravity

A liquid drop is spherical in shape due to surface tension. But why does it appear as a vertical line under the free-fall due to gravity? (E.g. During a rain - falling raindrop) Is there a specified ...
54
votes
3answers
2k views

What causes insects to cast large shadows from where their feet are?

I recently stumbled upon this interesting image of a wasp, floating on water: Assuming this isn't photoshopped, I have a couple of questions: Why do you see its image like that (what's the ...
4
votes
2answers
90 views

Why do Oreo crumbs float to a single glob at the very center in a glass of milk? [duplicate]

I had Oreos and milk a while ago and left my half-full cup of milk out on the counter. Afterwards I noticed that the crumbs had surfaced in a circular coin-sized glob, and just now I looked again to ...
21
votes
4answers
3k views

Why is the pressure inside a soap bubble higher than outside?

Apparently, the air inside a soap bubble is under higher pressure than the surrounding air. This is for instance apparent in the sound bubbles make when they burst. Why is the pressure inside the ...
8
votes
3answers
196 views

finding equation of a water droplet

I have a water droplet which is falling down through its gravity. I've supposed that my droplet is an ellipsoid and I want to find the equation that represents this ellipsoid in XYZ coordinate system. ...
5
votes
2answers
476 views

Can water pressure ever be high enough to trap gas bubbles or keep them from surfacing?

Can water pressure ever become high enough to trap gas bubbles and/or keep them from surfacing?
5
votes
1answer
157 views

Dropping condition

Imagine opening a water tap in order to have a smooth and cylindrical outflow and then slowly decrease the flow by adjusting the knob. At a certain moment, the side profile of the flow will become ...
4
votes
1answer
219 views

Is this formula for the energy of a configuration of 3 fluids physically reasonable?

I have studied for a couple of months now a mathematical model of the energy of a configuration of immiscible fluids situated in a fixed container such that the fluids fill the container. In other ...
4
votes
1answer
1k views

Cooking pasta: why does adding a lid lead to overflow?

When cooking pasta, some organic foam usually forms on the surface of the boiling water and the situation can be kept under control by adjusting the heat (and/or adding some oil). Covering the pot ...
6
votes
2answers
544 views

Hydrostatic pressure on a teapot spout

The phenomenon where water flows on the outside side of a teapot spout is named "The teapot effect", and occurs due to a difference in pressure between water and the atmosphere. Consider the image of ...
4
votes
1answer
156 views

Variational principles: Meniscus

In determining the shape of a meniscus, we have to minimize the energy per unit length along the direction perpendicular to the cross-section of the meniscus: $$\frac{E}{L}=\int^L_0 dx [\gamma ...
7
votes
2answers
597 views

How much of the forces when entering water is related to surface tension?

When an object enters water with high velocity, (like in Why is jumping into water from high altitude fatal?), most of it's kinetic energy will be converted, eg to accelerate water, deform the object ...
5
votes
2answers
958 views

Solving the Young-Laplace equation for arbitrary axisymmetric geometry

Say I have a non-ellipsoidal soap bubble and I want to numerically analyse the pressure in the inner lobe of this bubble here: The Young Laplace equation gives the pressure difference across a ...
6
votes
2answers
726 views

How is the water meniscus at the edge of a capillary tube

Suppose we have a capillary tube in which water can rise to a height of x cm. If we dip the tube such that the height above the surface is less than x, then how will the water meniscus be at the edge ...
5
votes
5answers
4k views

How far can water rise above the edge of a glass?

When you fill a glass with water, water forms a concave meniscus with constant contact angle $\theta$ (typically $\theta=20^\circ$ for tap water): Once you reach the top of the glass, the water-air ...
4
votes
2answers
210 views

At what size will self-gravitation contribute more to stability than surface tension?

The governments of Earth have embarked on an experiment to place a massive ball of water in orbit. (umm... special water that doesn't freeze) Imagine this to be a fluid with a given density, $\rho$ ...
2
votes
1answer
122 views

Beer bottle leftovers pour quickly only after waiting?

Why is it that after pouring a delicious beer from a bottle, I can hold it upside down for several seconds without reward, but if I wait a bit, the remainder presumably settles at the bottom and ...
1
vote
2answers
128 views

What is a good model for computing water dropping on a surface?

Before introducing my question I would like to outline the fact that I'm a coder, so I can be wrong when using some kind of terminology. What is a good model for computing the flow, the shape and all ...
1
vote
1answer
647 views

Problem with ring-method of du Nouy for calculating surface tension

I need to calculate the surface tension of a liquid with the ring-method of du Nouy and the correct formula to use is: $\gamma = \frac{F}{4\pi R}$ I understand that the surface tension is the ...
1
vote
2answers
153 views

Amount of material required for a pressure tank

I read the answer for the question Why is a hot air balloon “stiff”? and thought something sounded ridiculous. My engineering requirement is that the walls be strong enough. Here $T$ will be the ...
1
vote
1answer
340 views

Causes of surface tension between two fluids

Suppose that we have two fluids $A$ and $B$ in a container $\Omega$, and we notice that $A,B$ do not mix. Can you pleas explain to me what is the cause of this property? What properties of the two ...
0
votes
1answer
585 views

Calculational method for determining surface tensions from photograph of menisci?

How can I get from a photograph of a liquid surface to a value for the surface tension.
0
votes
2answers
2k views

Physics behind Water drops during falling from a tap

what is physics behind Water drops during falling from a tap. water drop animation A drop or droplet is a small column of liquid, bounded completely or almost completely by free surfaces. Why Water ...