-1
votes
1answer
36 views

equivalent spring constant for a nonlinear spring force [on hold]

The force-deflection relation of a steel helical spring used in an engine is found experimentally as $F(x) = 200x + 50x^2 + 10x^3$, where the force $(F)$ and deflection $(x)$ are measured in pounds ...
0
votes
2answers
42 views

equivalent spring constant for a drum floating in water

If I have a drum floating in water, how do I find the equivalent spring constant? I know that the water has density $\rho$, the drum has diameter $d$ and height $\ell$, and the positive direction is ...
0
votes
1answer
46 views

Coupled Spring System (3 mass 3 springs)

Hello I am having trouble trying to find the correct model for this coupled spring system. The scenario is the following we have: Ceiling - Spring - Mass(1) - Spring(2) - Mass(2) - Spring (3) - ...
0
votes
2answers
45 views

Deriving spring oscilation period [duplicate]

We have a spring attached to a wall and at the other part an object on a frictionless surface. I tried to calculate the spring oscilation period. I used the conservation of energy and kinematics ...
0
votes
1answer
82 views

Where have I made a mistake? [closed]

Question Find the period of oscillation of the above figure, assuming frictionless and massless pulley? I figured the displacement from each side is the same thus $x(k_{1}+k_{2})=-ma$, after the ...
2
votes
3answers
442 views

Why doesn't Lenz's law predict the behavior of a rod on springs in a magnetic field?

This comes from one of the free response questions from the AP Physics B 2014 exam. 5. (15 points) A conducting rod of mass $m$ and length $L$ hangs at rest from two identical conducting ...
0
votes
1answer
35 views

Doing a spring experiment, and need to find the stretch required

I'm doing an experiment where I have to calculate the stretch of a spring needed for it to launch itself into a trashcan located some distance away. The spring is located on the edge of a ramp that is ...
0
votes
1answer
68 views

Spring Constant - Waves

I tried to prove that for the same length of spring , a one dimensional wave that moves faster in spring 2 than spring 1, its spring constant will be lower than the spring constant of spring 1. ...
-1
votes
1answer
50 views

A block falling from a height on a block suspended by spring [closed]

The block suspended by the spring is hanging freely and its mass is M. The small block of mass m is dropped on the bigger block from height h. After the small block is dropped 》》》 I want help in ...
0
votes
1answer
103 views

Lagrangian for a moving spring device [closed]

How can I write the proper Lagrangian for such as system as the one shown in picture? Am confused about what is the suitable way to designate the coordinate.
0
votes
0answers
21 views

Question about two masses connected by a spring [duplicate]

I have two masses connected by a spring. They are horizontal and are not affected by friction or gravity. The spring's stiffness constant is $k$, and $x_1$ and $x_2$ are the displacements of the ...
0
votes
1answer
69 views

Why are 3 different road tests enough to say the suspension system of a car can handle any random road?

In an assignment I am given a random car with a random suspension system, and told that it is sufficient to test the safety of the car with regards to the suspension on three different sinusoidal ...
0
votes
1answer
149 views

Atwood machine with spring

I'm just beginning to learn about Lagrangian mechanics, and I am asked to find the kinetic energy of this Atwood machine (See figure). I am told, that the kinetic energy should be: ...
1
vote
2answers
73 views

Using an electric winch to compress a spring and launch an object

I'm having trouble grokking the relationship between a winch's pull/torque and a spring's potential energy. I would like to compress a spring using an electric winch and figure out how far it will be ...
1
vote
1answer
133 views

Spring Damper System : Recoil Reduction

I am designing a man-"portable" 30mm sniper rifle. Although it may be classified as a anti-materiel cannon. I have the mass of the round in total, and the mass of the projectile leaving the barrel, ...
1
vote
1answer
264 views

Modeling a 2-dimensional mass spring system

First of all, I am unfortunately not an expert in physics, so please be indulge with me. I am trying to model a $2$-dimensional mass-spring system with $1$ mass and $3$ springs to solve a dynamics ...
3
votes
0answers
154 views

Practice AP Physics B Exam Question regarding Momentum

I am trying to review momentum for the AP exam coming up. I will be taking the AP Physics C exam for Mechanics, but I was just practicing on any free response questions I could find and I came across ...
0
votes
1answer
88 views

Two masses attached by a spring [closed]

Suppose there is a system of two masses $M_1$ and $M_2$ connected by a spring with constant $K$ on a frictionless surface. What is the frequency of this system's oscillation? So I have fixed a ...
2
votes
0answers
56 views

Can I use the reduced mass principle in a spring-damper system?

http://hyperphysics.phy-astr.gsu.edu/hbase/orbv.html#rm I want to know, if I can use the reduced mass principle to solve a two object spring-damper system. In the books and webpages that I have ...
1
vote
1answer
672 views

Confused about relating spring force to maximum distance

I keep working through this problem and getting the wrong answer: A spring with spring constant k is positioned vertically and then compressed from its equilibrium length by a distance Δy. A ...
0
votes
0answers
275 views

Damping ratio and damping coefficient of two objects connected by spring

There are two objects m1 and m2 connected by a spring and a viscous damper (e.g car body and wheel connected by spring) From wiki: $\zeta ={c \over 2{\sqrt {mk}}}$ ζ is damping ratio, c is damping ...
-1
votes
1answer
73 views

Oscillator, angular frequency equation

I found the highlighted equation on the Wikipedia on angular frequency, however it doesn't say how it was obtained, could someone please explain that? Also, it says that the spring is massless, if ...
0
votes
1answer
183 views

Minimum separation distance between two masses cushioned by a spring [closed]

I think this problem is much more difficult than what I've learned so far. B) is the problem I'm having a hard time with. I think it is much more difficult to consider because as the red object ...
1
vote
1answer
180 views

Hooke's Law simple question

Just got introduced to Hooke's law Simple Q: Three light springs, each of natural length l and with spring constant k, are arranged vertically between two points a distance 3l apart. One end of ...
-2
votes
1answer
391 views

Spring problem? [closed]

I came across this problem in physics "Physics for Scientists and Engineers with Modern Physics by Serway" A block on the end of a spring is pulled to position $x = A$ and released from rest. In ...
2
votes
1answer
320 views

Spring system - 3 DoF system and its properties while changing stiffness

I was given the attached 3 degree of freedom spring system with the purpose of analyzing it. I came up with the following equation of motion and then I ran Matlab to calculate the corresponding ...
0
votes
1answer
167 views

Period of small oscillations [duplicate]

A light elastic string is stretched between two points, one lying vertically below the other. A particle is attached to the mid-point of the string, causing it to sink a distance h. Assuming that ...
2
votes
1answer
155 views

What forces are exerted on a clothespin in space?

Let's say a clothespin is modeled as a simple torsion spring as follows. Given: $p_1,\ p_2,\ p_3$: point-like objects of equal mass in 2-D space. All objects float in space, i.e. the center of mass ...
1
vote
1answer
331 views

Determining the spring constant in an oscillation problem [closed]

A 130g air-track glider is attached to a spring. The glider is pushed in 10.4cm and released. A student with a stopwatch finds that 14.0 oscillations take 19.0s I would like to know why the ...
1
vote
2answers
1k views

Finding max height of a mass launched by a spring?

I have the following problem on my homework. The actual problem has numbers, but I figure using symbolic notation will help me understand the concept in the long run. A block of mass $M$ is launched ...
2
votes
2answers
3k views

How to find the compression of a spring attached to an object [closed]

I am having some trouble figuring out the equation needed to solve this problem. A 3.0-kg block slides along a frictionless tabletop at 8.0 m/s toward a second block (at rest) of mass 4.5 kg. A ...
1
vote
1answer
71 views

Spring with changing equilibrium

Suppose that we have two cars on a track, each with a different mass. Now suppose that the cars are connected with a spring. We smack one car. I would like to write down the equations of motion for ...
8
votes
2answers
459 views

What will be different if the spring is not massless?

In almost all text, it uses the massless spring as example to illustrate the idea of elastic potential energy. I wonder what's really being changed if we consider the mass of the spring? I saw a ...
0
votes
1answer
635 views

Relationship between angles [closed]

Question: Find the relationship between angles $\theta$ and $\phi$ using the equations of equilibrium and solve for $\theta$. Express your equation for $\theta$ in terms of $\phi$. ...
1
vote
2answers
378 views

Vibration of pulley and string system

So here's the statement: A pulley of a mass $M$ is hanged using a spring (stiffness of the string being $k_1$), as shown in the image. What is the frequency of the pulley's oscillation? So that's ...
0
votes
2answers
280 views

Law of conservation of energy and kinetic energy: deformation of a spring [closed]

Problem: A block B of 1,5 kg is attached to the right of a spring (not deformed, with its right side attach to a wall) with a constant of $k = 80 N/m$ and, at rest, the block enter in collision with ...
0
votes
0answers
183 views

Coupling oscillator

I am currently doing the following problem: Two identical undamped oscillators, A and B, each of mass m and natural (angular) frequency $\omega_0$, are coupled in such a way that the coupling ...
-2
votes
1answer
140 views

Tension in parallel springs [closed]

A block of mass $200$kg is connected to a horizontal ceiling by four identical light elastic ropes, each having natural length $7$m and stiffness $180$N/m. It is also connected to the floor by a ...
-2
votes
1answer
72 views

Elastic Spring And Energy Issue

I`m trying to write an expression ( Work & Energy ) of spring that is not loose and it has a box on it with a weight of 1Kg. how its should be? this is what I tried to do: $$\frac{kx^2}{2}-mg$$ ...
-2
votes
2answers
3k views

Newton Laws of Motion + Effective spring Constant [closed]

! Can someone please help me in solving this question: What is the effective spring constant for the system of the two springs, perfect pulley, and string shown on the left for it to be modeled ...
1
vote
1answer
158 views

Proving Simple Harmonic Motion (direction of acceleration)

A particle of mass $m=0.5kg$, is attached to a spring of natural length $l=0.6m$ and modulus of elasticity $\lambda=60N$, and the setup is on a horizontal smooth table. The other end of the spring is ...
0
votes
2answers
154 views

Is my physics correct or torque correct?

I would like to put this into a differential equation. This is what I have. $$r \times F = I \ddot\theta + \mu \dot\theta + k \theta$$ What I need verified: $\text{Torque} = I\ddot\theta + \mu ...
3
votes
2answers
559 views

Equal mass on either end of a spring

I'm taking physics this term and this is the first time taking physics in 3 years. Here is my homework question (of course those variables all have values but we'll use variables for now): Consider ...
1
vote
1answer
176 views

How do determine the equation of motion of slinky?

I'm trying to analyze the forces exerted to slinky. First, I've divided both ends. The red vector is the force exerted by slinky itself, and the green vector is gravitational force. Force exerted ...
3
votes
0answers
774 views

Effective mass in Spring-with-mass/mass system

Suppose you have a particle of mass $m$ fixed to a spring of mass $m_0$ that, in turn, is fixed to some wall. I'm trying to calculate the effective mass $m'$ that appears in the law of motion of the ...
0
votes
2answers
530 views

Time period for spring connected body

Two identical springs with spring constant $k$ are connected to identical masses of mass $M$, as shown in the figures above. The ratio of the period for the springs connected in parallel (Figure 1) ...
-4
votes
1answer
92 views

High School Physics student needs help [closed]

A human cannon has a spring constant of 35 000 N/m. The spring can be extended up to 4.5m. How far horizontally would a 65kg clown be fired if the cannon is pointed upward at 45 degrees to the ...
0
votes
1answer
79 views

Period of oscilation [duplicate]

Two masses $m_1$ and $m_2$ are connected by a spring of spring constant $k$ and slide freely without friction along horizontal track. What is period of oscillation? No force influence.
3
votes
1answer
5k views

Two masses attached to a spring

I'm trying to understand the solution of the following problem. Two masses $m_{1}$ and $m_{2}$ slide freely in a horizontal frictionless track and are connected by a spring whose force constant is ...
0
votes
0answers
37 views

How can I find the frequency? [duplicate]

Grocery stores often have spring scales in their produce department to weigh fruits and vegetables. The pan of one particular scale has a mass of 0.5 kg, and when you place a 0.5 kg sack of potatoes ...