0
votes
1answer
15 views

Can a current source provide Voltage to a resistor?

We know that the tension between a perfect current source is 0 We have Va-Vb= 0 but we also have by ohm's law Va-Vb=RI=5V so 5 = 0?
-1
votes
1answer
22 views

Voltage divider example [closed]

I have the following voltage divider circuit: Now, my goal is to find U_{L}. Altough, I know already the solution (U_{L}= ...
4
votes
2answers
172 views

Voltage drop due to a resistor

I'm afraid this question is going to sound rather dumb but here it is: Suppose I have a very simple circuit: one battery and one resistor. The sum of the voltages in this circuit has to equal zero. ...
0
votes
2answers
38 views

Calculating emf with and without resistance

A battery of internal resistance 2 Ohms is connected to an external resistance of 10 ohms. The current is .5 A. What is the emf of the battery? The correct answer is 6.0 V. When I calculated it like ...
1
vote
1answer
69 views

Voltmeter readings at different points in a circuit

I have a circuit with a 6 volt battery and 2 resistors A and B in that order.A has a potential drop of 2 volts and B has a P.D of 4 v. which means every electron moving across the resp. resistors ...
0
votes
1answer
36 views

Getting maximum power/brightness from 5 lightbulbs with different resistances [closed]

Hi I am trying to figure out the best way to arrange 5 lightbulbs to get all of them to have the maximum brightness with a 30V battery. The 5 five lightbulbs have different resistances: 3ohms, 6ohms, ...
2
votes
5answers
1k views

Is voltage always proportional to its derivative?

We write, because of Ohm's law: $$V=RI(t),$$ but also we have $$C\frac{dV}{dt}=I(t).$$ From the first equation we deduce that $V\propto I$ and from the second $\dot V\propto I$. So we can conclude ...
1
vote
1answer
49 views

2 simple Generators = Im lost (intensity) [closed]

What happens? we have 2 Generators and 2 intensities, when I2 and I3 come together (they have opposite sides ) what happens? I tried writing down the voltage relations but I'm stuck because I don't ...
1
vote
2answers
51 views

Finding the current in a parallel circuit [closed]

Two resistors are joined as shown. The top resistor receives a current of 3 A. What is the current in the other resistor? What is the current that enters at junction A? I'm confused on how the two ...
0
votes
2answers
35 views

potential difference in parallel connecting resistors

How could the potential difference be constant across all the resistors of parallel connecting resistors although each resistor has a specific resistance?
0
votes
2answers
38 views

Can current and resistance result in establishing voltage?

I want to know whether current & resistance can cause a voltage across the circuit, according to Ohm's Law $V=IR$. Is it possible to use a low current to produce a high voltage?! How can this be, ...
0
votes
1answer
59 views

Simple Parallel Electric Circuit [closed]

Ammeter (A1) and voltmeter (V) in series have parallel connection to another ammeter (A2). Currents in A1 and A2 are respectively 0.2 and 1.7 amp. Voltmeter's voltage is 6 volts. How should I find ...
1
vote
1answer
75 views

Interpreting Physics Results Regarding Circuitry Analysis (Highschool Level Physics) [closed]

I conducted an experiment which aimed to detail and record the voltage across series resistors in series circuits. I noticed that: The Final Voltage, V3, stayed the same. The resistors with the ...
1
vote
5answers
174 views

Ohm's Law Intuition

When we derive Ohm's Law using the Drude Model, we assume at one point of time that $E=V/L$, when is fact, $E=dV/dL$, unless $E$ is constant, in which case the assumption $E=V/L$ is true. But I don't ...
-1
votes
1answer
260 views

How can rheostat change the current without changing int voltage

NCERT science of 10th, in chapter electricity on page 205, there, a is line written: a component use to regulate the current without changing the voltage ...
1
vote
2answers
189 views

A confusion in ohms law $V = IR$

ohms law clearly states that potential difference is directly proportional to the current flowing through the wire or V directly proportional to I ______(i) so the formula which is ...
3
votes
3answers
198 views

If the current is increased, is there more charge flowing or is it moving quicker?

Problem Current is the amount of charge that is flowing through a component per unit of time. For a given voltage, Ohm's law tells us that if we increase the resistance, then the current must ...
0
votes
1answer
60 views

Back EMF & Current, how can we make I stable?

Lets assume we have a wire that has $10V$ across and $1$ $Amp$ flowing, now if this conductor is introduced to a changing magnetic field, $-EMF$ is induced, can we control our voltage to increase it ...
1
vote
1answer
337 views

The shape of the graph of the equation: $V= -r I + E$

I have recently collected data (for a school experiment) in order to measure the EMF and the internal resistance of a solar cell. The data complied with the equation: $V = -rI + E$, i.e. the voltage ...
0
votes
0answers
235 views

What would the graph between P (power) and i (current) look like if the graph between V (potential difference) and i is parabolic?

The answer is same... That us the graph between P and I will also be a parabola.... Similar to the graph between V and I. But how? Can anyone explain through mathematical approach ? I used ...
0
votes
3answers
73 views

Capacitor related query

Why does a capacitor charge only upto the voltage of the source? I mean in an r.c. circuit if we have a resistor that is in series with the capacitor then because of the potential drop there will be ...
1
vote
1answer
870 views

Power dissipated on internal resistance of short-circuited voltage source

Suppose we have a voltage source with an EMF of $\mathcal{E}$ and an internal resistance $R$. If we connect to it a perfect wire with zero resistance, we get a short circuit. The value of the current ...
-2
votes
1answer
392 views

Hard circuit problem [closed]

I want to find the p.d. between points A and B. I'm not sure how to approach this problem though, could I have a hint?
1
vote
1answer
140 views

Resistance and current

I'm not a current student at any school, but I am learning a new profession, and some of it is a basic understanding of elecrticity. I have some knowledge, but definitely not enough, and I have had to ...
1
vote
0answers
96 views

Circuit Analysis: Help getting the Thevenin equivalent [closed]

I am attempting to solve this problem which requires me to get the Thevenin equivalent of a circuit, and I've gotten as far as getting the equivalent resistance of the circuit (which I believe is 5 ...
2
votes
2answers
593 views

Why does vaccum have a nonzero characteristic impedance towards electromagnetic radiation

OK, so the characteristic impedance is calculated "as square root of the ratio of the permeability of free space (µ o ) in henrys per meter ( H/m ) to the permittivity of free space ( o ) in farads ...
0
votes
3answers
226 views

Potentiometer voltage change

I'm trying to understand simple things about electricity reading allaboutcircuits.com web. This chapter includes image which´s principle I don't understand. Here it is: When supplying constant ...
0
votes
1answer
68 views

Would the empirical behavior of a simple circuit match my model of it?

I have a practical problem in E&M which has baffled me and and my electrician. The copper water pipes in my house are carrying a current of small potential (~1V) AC current. Here is my ...
0
votes
3answers
399 views

Which quantity gives the resistance of a component?

In a current vs potential difference graph, we can obtain the value of the resistance of the component. There are books that say gradient-inverse is the resistance and also books that say the value of ...
2
votes
1answer
97 views

Help Understanding Non-conservative Fields

While watching a video lecture, I became uncomfortable with the results, (around 35 mins). The professor draws an electric circuit with a 1V batter, and two resistors (1 and 9 ohms). He then ...
1
vote
1answer
629 views

Calculate Capacitance in Series AC Circuits?

I'm supposed to calculate the capacitance of an unknown capacitor in series, but I'm not sure exactly which equation to use. I know the voltage across the resistor (Vr), voltage across the capacitor ...
11
votes
11answers
24k views

I don't understand what we really mean by voltage drop

This post is my best effort to seek assistance on a topic which is quite vague to me, so that I am struggling to formulate my questions. I hope that someone will be able to figure out what it is I'm ...
0
votes
1answer
3k views

Relationship between resistance and voltage drop

In a series or parallel circuit, if two bulbs have the same resistance, do they have the same voltage drops? The problem I am asking about is below. Do A, B, and C have the same voltage drops since ...
2
votes
1answer
3k views

Effective resistance of inductor

In a lab experiment, we connected a simple circuit: an AC voltage source, connected (in series) to a variable resistor and an inductor. We measured the current in the circuit, and the voltage that ...
0
votes
1answer
746 views

How do I solve the current of this resistor using Maxwell's Current Theorem?

I've been trying to solve this using the method the prof. taught us, and I happen to know the answer but I can't reach it no matter how many times I've tried. The circuit in question is below: I am ...
1
vote
2answers
2k views

Basic questions about voltage drop in DC circuit

I understand all the concepts of what voltage is using all the analogies but some things related to the drop of voltage across a circuit confuses me. If I had a short circuit and attached a ...
0
votes
1answer
761 views

What does a positive gradient on a graph of V plotted against I mean in terms of EMF and internal resistance?

According to the equation $V = E-Ir$, the gradient of a graph of $V$ against $I$ should be $-r$ (internal resistance) and the Y intercept should be the EMF. Am I right? In an experiment I used a ...
2
votes
3answers
8k views

Finding current using EMF & internal resistance

What exactly is the difference between internal resistance and resistance? This came up in the context of a homework problem I have been given: The circuit shown in the figure contains two ...
1
vote
2answers
269 views

Fundamentality of voltage to current

From Ohm's Law : Ohm's law states that the current through a conductor between two points is directly proportional to the potential difference across the two points. I would like to know if ...
1
vote
3answers
2k views

Why does the potential drop across a battery and resistor equal the emf of the battery?

In this diagram you can see the potential difference across the battery and resistor is the same as the pd created by the battery (the battery and resistor are representing a battery with internal ...
2
votes
1answer
294 views

What electric potential is found over individual resistors connected in series to an AC power supply?

Given a set of resistors connected in series to an AC power supply: What formula governs the peak-to-peak voltage which will be measured when voltage is probed over individual resistors and sets of ...
0
votes
4answers
664 views

Voltage drop along an idealized resistance-free wire in a circuit?

If you connected the positive terminal of a battery to the negative terminal to a battery with a wire with (hypothetically) no resistance, and are asked to give the voltage drop of a segment of wire ...