2
votes
1answer
48 views

If hot air expands in all directions why is the balloon moving up?

A balloon is moving up. The hot air inside the balloon is expanding in all directions and cold air outside the balloon acts with force on the balloon from all directions (higher pressure force). Why ...
2
votes
0answers
24 views

Simple gas in cylinder modeling

I want to do a simple (physically plausible but not physically accurate) simulation of a gas in a cylinder as it works on or is worked on by a piston. Wikipedia gives a good example of an adiabatic ...
1
vote
2answers
116 views

Relations between pressure and temperature

I have several questions concerning thermodynamics and I order them in 4 points that may be related: What's the difference between heat and work at the atomic level? Isn't heat simply work between ...
3
votes
2answers
63 views

Why doesn't water in water barometer boil?

I have read that the pressure in a water barometer at the top of the water column is around 0.5 psi and at such low pressures water should boil at around ~26°C (Room temperature). [1] [2] How ...
1
vote
1answer
71 views

How does pressure influence temperature in liquids?

Lets say we have a tank with a fixed mass of liquid at atmospheric pressure and room temperature. How do we influence the temperature when we exert pressure (e. g., with a piston) on the liquid? Are ...
1
vote
2answers
207 views

Temperature of ideal gas after volume increases in piston

A three part question, all related Part 1. My question is about an ideal gas in a rigid container with two (equal volume) compartments separated by a rigid wall. One compartment has an ideal gas at ...
1
vote
1answer
50 views

Do gases have a general upper limit of density?

Is there some limit for the density of gases, at which no change in condition could make it more dense without making it fluid, or solid - or something 'in between'?
0
votes
1answer
713 views

Compressed air in a volume: Can I determine its temperature?

Using a compressor, I augment the pressure in a volume (using atmospheric air). I only measure the pressure inside. I now that the density will increase however, the temperature decreases. Can any one ...
28
votes
7answers
4k views

Is it possible to “cook” pasta at room temperature with low enough pressure?

It is known fact, that boiling point of water decreases by decreasing of pressure. So there is a pressure at which water boils at room temperature. Would it be possible to cook e.g. pasta at room ...
0
votes
0answers
53 views

Linearity of the critical isochore?

When looking at the pressure-temperature diagram along the critical isochore (up to quite high reduced temperatures) a very linear trend can be observed. From a theoretical point of view, is the ...
2
votes
0answers
123 views

Second derivative of vapor pressure from a cubic equation of state

It is quite easy to compute the first derivative of vapor pressure with respect to temperature from a cubic equation of state at least at the critical point since there is a continuity with the ...
2
votes
0answers
90 views

How Temperature, Pressure and Altitude are related in the atmosphere?

I'm looking for an approximation for the temperature of the atmosphere at any height and pressure. Both altitude and pressure are known variables, I've derived this equation using maxwell's ...
0
votes
1answer
62 views

Determining if a solution will boil

A piston compresses a solution of 40% $HNO_3$ in $H_2O$. If the piston breaks and the pressure is reduced from 12.0 atm to 1.0 atm: a) If the temperature of the solution is 110 degrees C, will the ...
2
votes
1answer
2k views

Estimate temperature and pressure of steam in a pot of boiling water

Suppose we have a pot of known dimensions filled to level L with boiling water on a stove, covered by a lid with a vent of known dimensions. Given the steady-state temperature of the stove (bottom of ...
0
votes
0answers
23 views

Is the current situation possible for recreaction in a lab?

I want to convert cellulose to another form (crystalline => amorphous). Cellulose requires a temperature of 320 °C and pressure of 25 MPa to become amorphous in water.(Is the pressure achievable in ...
1
vote
0answers
194 views

ideal gas law modelization in a vacuum chamber

I am trying to model a pressure sensor in COMSOL. The basic work is that there is current flowing inside it, if the pressure of the gas around it drops down, the temperature goes down as well (ideal ...
-1
votes
3answers
4k views

High and low pressure area and raining

In the high-pressure area it is mostly likely that there is sun. In low pressure area it is mostly likely that rain will occur. Because of the law that ...
2
votes
2answers
3k views

What is the effect of an increase in pressure on latent heat of vaporization?

What is latent heat of vaporization ($L_v$) in the first place? Wikipedia seems to indicate that it is the energy used in overcoming intermolecular interactions, without taking into account at all any ...
1
vote
0answers
101 views

How to solve state parameters using these givens for an ideal gas?

In a thermodynamic turbine using air as an ideal gas, given that you have a known inlet temperature value $T_i$, a known exit pressure value $P_e$, a known inlet and exit velocity $V_i$ and $V_e$, a ...
3
votes
2answers
817 views

With ideal gases, varying quantity of moles, and having a constant volume how do temperature and pressure behave?

I'm trying to build a simulation of gases so I ended-up trying to use law of ideal gases ($PV = nRT$). In my scenario: volume is constant ($V=1\rm{m}^3$); a known quantity of moles are being added ...
0
votes
2answers
3k views

Ideal gas law, pressure increase and temperature

If I had a container, full with air, and I suddenly decreased the volume of the container, forcing the air into a smaller volume, will it be considered as compression, will it result in an increase in ...
0
votes
3answers
994 views

Units of Distance, Pressure, and Temperature [closed]

I need to store data. I'd like to store them in Metric units and use a tool to convert them to and from other units that these data points will be displayed in. As the title states, my constraints ...
2
votes
1answer
133 views

Is it possible to use a powder-based firearm in space?

A firearm relies upon some kind of explosive powder to drive the slug out of the barrel. My guess however is that in space (at GEO, or higher) a firearm would be unusable due to the extremes of ...
1
vote
2answers
978 views

What is the physical or mathematical meaning of the Gibbs-Duhem equation?

The Gibbs-Duhem equation states $$0~=~SdT-VdP+\sum(N_i d\mu_i),$$ where $\mu$ is the chemical potential. Does it have any mathematical (about intensive parameters) or physical meaning?
1
vote
1answer
258 views

what will happen when I continuously heat a closed heavy iron box half-filled with water?

I mean what will be the situation inside? All water vaporized, Equilibrium, Temperature-pressure situation.. boiling point increase/decrease? Thanks for your time.
3
votes
1answer
179 views

In a Sterling Engine, does heat from the hot side transfer to the cold side?

A Sterling Engine is a closed system. The "hot" side oscillates between higher temperature with higher pressure and lower temperature with lower pressure. Does Nature switch back and forth between ...
1
vote
1answer
458 views

Given two boiling temperatures and pressures, how can I find the latent heat?

I am given the fact that at a certain pressure a liquid boils at a corresponding temperature, at a different pressure it boils at a different temperature, and then I am asked to find the latent heat ...
1
vote
2answers
333 views

simulations at constant pressure-volume and constant volume-temperature

I have read some papers where the authors perform simulations at constant pressure and constant volumen or sometimes constant volume constant temperature. My question is when is it better to use one ...
8
votes
8answers
12k views

Why does the gas get cold when I spray it?

When you spray gas from a compressed spray, the gas gets very cold, even though, the compressed spray is in the room temperature. I think, when it goes from high pressure to lower one, it gets cold, ...