# Tagged Questions

The time rate of change of energy

26 views

### Calculating estimated HP from velocity, auto weight, and constant acceleration

I am working on a simulation program that runs theoretical performances of different cars and was wondering if there is a way to estimate the HP at any running RPM? the problem is (and this may be me ...
19 views

### Out of phase AC transmission lines in parallel

I've been reading up on power transmission networks and came across this thing. http://en.wikipedia.org/wiki/Quadrature_booster Basically it balances the load between two parallel power lines by ...
45 views

### Why can't unequal current sources be connected in series?

Imagine two power sources, PS-1 that can supply $5A$ at $100V$,and PS-2 can supply $10A$ at $40V$, due to conservation of charge, and Kirchoff's current law(KCL) this is incorrect, and would lead to ...
33 views

### How big does a natural gas compressor station have to be, so as its possible explosion to produce power equal to that of a nuclear bomb [closed]

I live in Greece and a natural gas compressor station is going to be constructed within a radius of 3km. That got me wondered. Can a possible explosion produce equal power with the little boy, the ...
20 views

### Sound power radiation of two monopole sources

For a fixed given electrical power to two monopole sources, producing the same frequency. Which mode, either in-phase or out of phase, will radiate the most sound power into the far-field?
21 views

### Power spectral density of noise

My question is regarding power spectral density of white gaussian noise. It is known that the power spectral density of white gaussian noise is $$S_X(f)= \frac{\mathcal{N_0}}{2}$$ My question is does ...
59 views

### Why high voltage transmission lines?

This is a question which I seem to have tackled multiple times, solved each time after reading a dodgy internet explanation, then partially forgotten about and retackled half a year later. It is time ...
41 views

### If halving signal strength is only a 3db drop, why can't cell phones be much lower powered?

My phone can receive a signal that's -90dBm. That's roughly one-billionth of a milliwatt. Cutting a signal's strength in half only drops the signal by 3dBm. Apart from slightly higher range, is there ...
51 views

### Power and velocity?

If $P=Fv$, power is constant and the power is the rate of change of kinetic energy, i.e. $P = d(mv^2/2)/dt$, what must $v(t)$ be to satisfy this equation?
34 views

### Parallel Resistors (special cases formula)

1) A car's rear window defroster uses $n=15$ strips of resistive wire in a parallel arrangement. If the total resistance is 1.4 ohms, what is the resistance of one wire? Solution: I rearranged ...
32 views

### Power - 1/2 Force x velocity? [closed]

A pump, taking water from a large reservoir, is used to spray a jet of water with speed 20m/s. The nozzle of the pipe has radius 0.05m, and is level with the surface of the reservoir (no change in ...
29 views

### What is DX technology and what are the effects on digital cameras?

I am photographing in a high power voltage field in Industry producing aluminium, called DX technology. How do I know if my digital camera will not be affected? At 350kA current my film cameras were ...
59 views

### If a 2,400 lb. car is moving at 1 mile per hour, how much force is required to stop its motion? [closed]

Given that I stand behind or in front of a car and someone will move the car from within at approximately 1 M.P.H., how much force is needed to stop the force driven by the engine to put the car at ...
28 views

### High power short duration from low energy source?

1MW, can 1000Joules source of energy deliver 1M of power in 1 millisecond? $Energy =$ $P$ $x$ $t$ , so does it make sense to have small amounts of energy in large pulses of power? In an extremely ...
40 views

### Making of the electricity

I'm interested if there are actually some new electrons created in the process of Making of the electricity (turbine-generator-electricity)? I guess (flow of the electrons in the wire - electricity) ...
415 views

### Power dissipation in circuits:Why is high voltage used in power lines?

I know this question has been asked before, but there is one doubt I still cannot clear. Power dissipation is proportional to $I^2R$. Does this not mean that it is also proportional to $V^2/R$? If ...
24 views

### Does adding water on convex mirror increase its power?

What is the comparison between the power of convex lens in air and in water ? What causes the change in its focal length
33 views

### Finding power in series circuit

A resistor of resistance 12 ohms is connected in series with a cell of negligible internal resistance. The power dissipated in the resistor is P. The resistor is replaced with a resistor of resistance ...
46 views

### Getting maximum power/brightness from 5 lightbulbs with different resistances [closed]

Hi I am trying to figure out the best way to arrange 5 lightbulbs to get all of them to have the maximum brightness with a 30V battery. The 5 five lightbulbs have different resistances: 3ohms, 6ohms, ...
126 views

### What's the relation between output voltage and time to boil water given the same kettle?

An electric kettle rated 220V, 2000W needed 10 minutes to boil water when it is half filled with water in Singapore where the output voltage is 220V. Estimate the amount of time needed to do the ...
67 views

### Why doesn't a resistor dissipate reactive power? [closed]

Is there a (preferably microscopic) explanation for why a resistor does not dissipate reactive power?
27 views

Our home appliances are mostly resistive loads and the bill we pay for consuming power is actually real power. If we use more inductive loads at our home, will it just cause problems in power factor ...
40 views

### Calculate signal strength received by an Ultrasonic Transducer [closed]

Below is an image showing transducer A transmitting a signal with an amplitude of 3000mV, I am trying to calculate the amplitude of the signal received by transducer B in mV, I understand that there ...
137 views

### Power to suspend a mass in air

How much power is needed to suspend a mass in the air? The four parts below deal with the same problem. I post them all here, should there be some subtle things I didn't see. The textbook problem A ...
39 views

### Eddy Currents: Relationships between thickness and deceleration

This is probably a question with a very simple answer, but I want to make sure before I write too much. I'm doing an investigation on Electromagnetic fields, in particular eddy currents and how they ...
203 views

### How does Ohm's law apply to superconductors?

As radio amateurs we've all learned the various relationships of power, voltage, current and resistance as expressed in Ohm's Law. My question relates to the following simple circuit showing an ideal ...
132 views

### Will my car consume more if I plug in my laptop?

I drive a Volvo v40 with a 110hp diesel engine. It usually use 4.6L/100km. If I plug my laptop which is 85W, will this change the fuel need? If so, by how much?
25 views

### Why does the power in an inductor equal what it does?

I understand that power is that rate at which work is done and that because of this the power in an inductor is equal to $$P=\frac{d}{dt} \left(\frac12Li^2\right).$$ I also understand that the power ...
41 views

### Can a transformer transfer all power?

How can the transformer transfer exact power from primary winding to secondary winding if there are core losses, eddy current losses and hysteresis losses?
107 views

### Difference between $I^2R$ and $V^2/R$ and $VI$ for measuring power $P$

We use $I^2R$ or $V^2/R$ or $VI$ for measuring power $P$. Are all of these applicable for all circuits? I have seen in some circuit $V^2/R$ is not equal to $I^2R$. Why is that?
52 views

61 views

### Calculating Joule heating in magnetic field

I have problem with calculating Joule heating in alternating magnetic field perpendicular through circulate plate with radios a and height h. Lets say that alternating magnetic field is in form of ...
42 views

### Constant power in rotational dynamics

I am having trouble understanding and applying the concept of constant power (e.g. a motor) in rotational dynamics. We have that: $$P=\tau\omega$$ Therefore if we imagine a physical system with a ...
168 views

### Why is there no upper-bound on power-efficiency of Hydro-turbines?

We have Betz's law, an upper bound on power efficiency, for wind-turbines. But there is no theoretical upper limit on hydro-turbines, Why this is so? Is it mainly due to the incompressibility of ...