The time rate of change of energy

learn more… | top users | synonyms

3
votes
4answers
5k views

What is the relationship and difference between BHP and Torque?

I've recently been looking into performance figures for various auto mobiles, and I see the terms BHP and Torque used quite often, but I can't say I really understand the terms, or how they relate to ...
0
votes
0answers
21 views

Energy and momentum [closed]

In a good wind location offers a modern wind turbine with a maximum output of 1 MW over 2 million kWh per year. a) How many m ^ 3 of oil is equivalent to that energy content if 1 liter of oil ...
0
votes
1answer
75 views

Which thermoelectric effect is better?

I am doing an experiment which requires the thermoelectric effect. I know about the Seebeck and the Peltier effects. Well, from what I have found till now on these topics is that they both can produce ...
0
votes
2answers
164 views

How much electricity can be produced by my thermoelectric generator?

I am using a thermoelectric cooler from a pc's heatsink to produce electricity. Its size is 30mm by 30mm. I will cool it on one side at -10 degree Celsius and the other at 24 degree Celsius. Can ...
1
vote
0answers
26 views

What is DX technology and what are the effects on digital cameras?

I am photographing in a high power voltage field in Industry producing aluminium, called DX technology. How do I know if my digital camera will not be affected? At 350kA current my film cameras were ...
1
vote
1answer
37 views

Can a transformer transfer all power?

How can the transformer transfer exact power from primary winding to secondary winding if there are core losses, eddy current losses and hysteresis losses?
0
votes
1answer
38 views

Quadrupling Power in a Circuit

If I have a heating wire with resistance $R$ to be connected across a constant potential difference $V$, it would seem like cutting the wire into two (thus each having half the resistance) and ...
-3
votes
1answer
53 views

If a 2,400 lb. car is moving at 1 mile per hour, how much force is required to stop its motion? [closed]

Given that I stand behind or in front of a car and someone will move the car from within at approximately 1 M.P.H., how much force is needed to stop the force driven by the engine to put the car at ...
0
votes
4answers
25 views

High power short duration from low energy source?

1MW, can 1000Joules source of energy deliver 1M of power in 1 millisecond? $Energy =$ $P$ $x$ $t$ , so does it make sense to have small amounts of energy in large pulses of power? In an extremely ...
4
votes
4answers
7k views

How does power consumption vary with the processor frequency in a typical computer?

I am looking for an estimate on the relationship between the rate of increase of power usage as the frequency of the processor is increased. Any references to findings on this would be helpful.
0
votes
2answers
515 views

Does the mass of a car frame has any effect on its horsepower?

I want to know whether decreasing the mass of the frame of a car will increase its horsepower. From what I understand horsepower is a measure of the car's ability to transport load, and decreasing the ...
0
votes
1answer
70 views

Suggest why electrical power input P1 differs from power used P2

We have done an experiment heating water with a wire element and have determined it takes 21.5964 watts to heat 200ml of water to a specific temperature in 10 minutes. However the power of the ...
0
votes
1answer
37 views

Making of the electricity

I'm interested if there are actually some new electrons created in the process of Making of the electricity (turbine-generator-electricity)? I guess (flow of the electrons in the wire - electricity) ...
3
votes
1answer
391 views

Power dissipation in circuits:Why is high voltage used in power lines?

I know this question has been asked before, but there is one doubt I still cannot clear. Power dissipation is proportional to $I^2R$. Does this not mean that it is also proportional to $V^2/R$? If ...
0
votes
1answer
19 views

Does adding water on convex mirror increase its power?

What is the comparison between the power of convex lens in air and in water ? What causes the change in its focal length
1
vote
1answer
26 views

Understanding the energy transffered/used from a power source?

A source of power(from a generator,battery,etc...) is used to power a system of any kind. We can calculate the energy used via this formula $E$ = $IV$ x $t$ ? For example, a battery that is connected ...
3
votes
2answers
114 views

Optimal speed for the water wheel

The hydroelectricity plants extract the potential energy of highly deployed massive object (water) as it falls down. Without turbine, all that energy would be converted into speed (kinetic energy) at ...
2
votes
1answer
1k views

Finding electric power generated using heat transfer

I'm working through an example I have been given to study. Suppose I have a 2m X 4m photovoltaic panel on my roof that is irradiated with a solar flux of $G_s = 700W/m^2$. Given: $\alpha_s = 0.83$ ...
3
votes
2answers
1k views

Why do people with bigger hands/wrists have bigger torque advantages in arm wrestling?

I have arm wrestled people with less strength than me who win simply because they have thicker wrists, or larger hands. It has nary to do with having better technique either, because their wrist size ...
24
votes
8answers
5k views

Why don't modern spacecraft use nuclear power?

The Voyager 1 & 2 spacecraft launched in 1977 with Plutonium as their source of electricity. 34 years later they claim these two spacecraft have enough power to last them until at least 2020. That ...
1
vote
2answers
32 views

Finding power in series circuit

A resistor of resistance 12 ohms is connected in series with a cell of negligible internal resistance. The power dissipated in the resistor is P. The resistor is replaced with a resistor of resistance ...
0
votes
1answer
36 views

Getting maximum power/brightness from 5 lightbulbs with different resistances [closed]

Hi I am trying to figure out the best way to arrange 5 lightbulbs to get all of them to have the maximum brightness with a 30V battery. The 5 five lightbulbs have different resistances: 3ohms, 6ohms, ...
0
votes
2answers
103 views

What's the relation between output voltage and time to boil water given the same kettle?

An electric kettle rated 220V, 2000W needed 10 minutes to boil water when it is half filled with water in Singapore where the output voltage is 220V. Estimate the amount of time needed to do the ...
-1
votes
2answers
45 views

Why doesn't a resistor dissipate reactive power? [closed]

Is there a (preferably microscopic) explanation for why a resistor does not dissipate reactive power?
0
votes
3answers
901 views

How can AC source with different voltage provide same power

As some of us maybe aware, USA mains connection is 110 V while those in Asian countries are 220 V. How is it still possible for the Adapter to provide the necessary power to the device, say a laptop, ...
0
votes
2answers
25 views

Question about indutive loads in power system [closed]

Our home appliances are mostly resistive loads and the bill we pay for consuming power is actually real power. If we use more inductive loads at our home, will it just cause problems in power factor ...
2
votes
0answers
29 views

Calculate signal strength received by an Ultrasonic Transducer [closed]

Below is an image showing transducer A transmitting a signal with an amplitude of 3000mV, I am trying to calculate the amplitude of the signal received by transducer B in mV, I understand that there ...
2
votes
2answers
125 views

Power to suspend a mass in air

How much power is needed to suspend a mass in the air? The four parts below deal with the same problem. I post them all here, should there be some subtle things I didn't see. The textbook problem A ...
1
vote
3answers
145 views

How does Ohm's law apply to superconductors?

As radio amateurs we've all learned the various relationships of power, voltage, current and resistance as expressed in Ohm's Law. My question relates to the following simple circuit showing an ideal ...
2
votes
1answer
35 views

Eddy Currents: Relationships between thickness and deceleration

This is probably a question with a very simple answer, but I want to make sure before I write too much. I'm doing an investigation on Electromagnetic fields, in particular eddy currents and how they ...
2
votes
2answers
81 views

Difference between $I^2R$ and $V^2/R$ and $VI$ for measuring power $P$

We use $I^2R$ or $V^2/R$ or $VI$ for measuring power $P$. Are all of these applicable for all circuits? I have seen in some circuit $V^2/R$ is not equal to $I^2R$. Why is that?
2
votes
3answers
123 views

Will my car consume more if I plug in my laptop?

I drive a Volvo v40 with a 110hp diesel engine. It usually use 4.6L/100km. If I plug my laptop which is 85W, will this change the fuel need? If so, by how much?
0
votes
1answer
24 views

Why does the power in an inductor equal what it does?

I understand that power is that rate at which work is done and that because of this the power in an inductor is equal to $$P=\frac{d}{dt} \left(\frac12Li^2\right).$$ I also understand that the power ...
1
vote
0answers
45 views

Max speed as a function of engine power

My question started out as finding the maximum speed of a go kart, taking into account only the drag forces as force opposing the motor. I've done some investigation to find: $$ F_{drag}=\; ...
1
vote
1answer
55 views

The inverse square law of sound through solids?

We all know about the inverse square law of sound. In short the power of the wave will get evenly spread on an ever increasing spherical expansion and this will dissipate the power of the wave at a ...
1
vote
2answers
159 views

Finding power with Drag Force equation

The mass of the car is 1500 kg. The shape of the body is such that its aerodynamic drag coefficient is $C_D=0.330$ and the frontal area is $2.50 m^2$. Assuming that the drag force is proportional to ...
10
votes
3answers
3k views

why aren't there nuclear powered aircraft?

I know this might sound like more of an engineering question that about physics, and it probably is, but bear with me: i'm still not sure if the answer to my question lies in the physics or in the ...
2
votes
1answer
28 views

Cooling induction current generation

We know that conducting materials can be heated by electromagnetic induction. Is it possible to generate current using a cooling process?
1
vote
2answers
102 views

who will win a race between man, horse and car of same power

Other day I got into a chat with my friend on work power and energy where he asked an intelligence related question the question was like this if a race was conducted between a man a horse and a ...
0
votes
2answers
3k views

How to calculate fuel consumption of car (mpg) from speed and accleration knowing mass, drag coeff and rolling resistance?

How can I calculate the current (instantaneous) mpg of my car if I know the speed and acceleration of the car? From reading various answers for the "car going level or up/down hill" question asked ...
-1
votes
1answer
27 views

Is watt unit depended on turbine speed

I'm new to electronics. I have a doubt. That is... Is watt unit depended on speed of turbine ? In my mind When turbine rotates fast the power in increase. Is it right ? Please help me. Thanks for ...
1
vote
3answers
5k views

Two 60W-lightbulbs are connected on 220 V AC-voltage - how much electric power is spent by each lightbulb? [closed]

Two 60W-lightbulbs are connected on 220 V AC-voltage - how much electric power is spent by each lightbulb? There are two scenarios: In one, these two lighbulbs are connected serially, and in the ...
5
votes
1answer
122 views

Poynting theorem and entering power

I refer to the time-domain version of the Poyinting theorem in electro-magnetism: $- \displaystyle \oint_S (\mathbf{E} \times \mathbf{H}) \cdot d\mathbf{S} - \int_V \mathbf{E} \cdot \mathbf{J}_i \ dV ...
0
votes
0answers
9 views

Transient Stress and Piezoelectric Generators

From what I can gather, the piezoelectric effect links mechanical stress to the potential difference across a material, with a two-way relationship between the two (motor or generator). I don't know ...
0
votes
4answers
7k views

Power dissipated in Series versus Parallel

Do two resistors in parallel dissipate more heat per unit time for an applied voltage when compared to two resistors in series?
1
vote
1answer
46 views

Power delivered by a plug

Ok so i know that (in the UK) the voltage of a mains supply is 230v. But when we plug a item e.g. a tv in to it what determines how much power is drawn from this supply. I presume it is the current ...
3
votes
1answer
75 views

Counter rotating propellers: better in same column or staggered?

In an octo-copter design, is it better to put four pairs of counter-rotating props over each other so that each pair works in a column together? Or will you get more power or efficiency from ...
1
vote
2answers
55 views

Is battery capacity proportional to Ampere-hour in every case?

Suppose I have two batteries one inside the laptop with 2.5 AH giving a backup for around 2 hours. The battery is external inside a UPS system with 7.5 AH. Since it has thrice the capacity of the ...
2
votes
4answers
1k views

Do Alkaline batteries, $\mathrm{NiMH}$, rechargeable alkaline, Lithium $\mathrm{AA}$, all have similar MAX POWER?

So in physics, one smart teacher told me, $$ V = IR $$ or $$ I = \frac{V}{R} $$ but it is not always true, because $P = VI$ and each power supplying device (such as battery) has a "maximum power" it ...
-1
votes
1answer
136 views

why countries can't make nuclear bombs? [closed]

Somehow when I google about the nuclear bombs I find a lot of books and resources that seem to explain everything about how those bombs are made. But sometimes I often hear that countries that want to ...