# Tagged Questions

The time rate of change of energy

117 views

### Does ambient day/night temperature change have significant energy generation potential

Is there significant energy to capture in daily day/night temperature change? For instance, I see from posts such as the following that there are materials with varying coefficients of linear thermal ...
214 views

### Negative power measurement of transformer short-circuit test. What happened?

I have a dissectible transformer, made up of two 120-turn coils. I connect a function generator to the primary side, set the AC voltage to be constantly 10V, and short circuit the secondary side. And ...
136 views

### Instead of a dynamo-meter, why can't we use $\tau=I\alpha$ to determine the power of a rotating shaft?

To measuring the power of a rotating shaft, dynamo-meters are used. Instead, why can't we find torque using Torque=Moment of Inertia times Angular Acceleration, $\tau=I\alpha$? And given that we know ...
96 views

### What is one human power? [closed]

some time ago I was asked what the HP equivalent of a human was, looking into this apart from in the creation of steam engines the power definition 1 Horse power was set at the work of two of the best ...
601 views

### Car “oomph”: power or torque?

Two of the most important magnitudes that characterize a car's engine are maximum power and maximum torque. How are those two magnitudes related to the sensation that the car has "oomph" or is "...
69 views

### Electricity from effervescence, is it possible?

I've had this idea for quite some time (after having a cold and seeing Tabcin sparkling tablets), is there the possibility to generate electricity from effervescence? I envisioned something like the ...
78 views

### Solar plants and energy conservation

I'd like to apologise if this question is stupid or if it was asked ten thousand times - I haven't found an answer to it. Quite possibly due to mediocre English or abominable knowledge of physics. So,...
271 views

### Can we make a “Gravity Mill” based on principle(s) of Newton's cradle?

DISCLAIMER: Newbie/Wannabe Physicist. What's to stop us from making a "Gravity Mill" which is a bar/rod attached with weights on both ends and pivoted at the ...
978 views

### Laser power consumption vs power output [closed]

I have a 5 mW laser pen powered by a 1000 mAh 3.7 volt battery that takes over 2 hours to recharge. It drains it in 15 minutes. Why is it only called 5 milliwatts output if it is consuming 14.8 W?
376 views

### Electricity consumption in fan

Does regulation in a fan vary in Electricity consumption? i.e. I want to know exactly, is the energy consumption more when regulator is tuned to highest number or lowest number?
54 views

### Is it true that a processor with a higher temperature uses inevitably more power in comparison with a processor with a lower temperature?

If a processor has a higher temperature, can you be sure it it consumes more power than a processor with a lower temperature? And is the reverse relationship true? A processorchip with a higher mean ...
1k views

### Defining Reference Directions for Voltage and Power (sign convention)

My professor decided to use the above reference directions when calculating power in circuits. He says that when power > 0, power is consumed. When p < 0, power is generated. This definition is ...
141 views

### Why aren't (domestic) kettles insulated?

In my experience of buying and using kettles, I have come across none which are insulated. The obvious reasons as to why it would be beneficial being that heating time would be reduced, similarly, ...
861 views

### What's the intensity of a laser pointer?

The unit of intensity or the irradiance of the light is $\mathrm{W/m^2}$. So what's the intensity of a light pointer? Searching on the web, the laser pointer's power is about $5\mathrm{mW}$, imagine ...
2k views

### What does 1714 mean in hydraulics?

After reading this answer: http://www.answers.com/Q/What_does_1714_mean_in_hydraulics, I still do not have a good idea of what 1714 represents. In fact, in the equasions I was working with I saw a ...
56 views

### What is the equivalent of the “amount of fuel” for a battery?

I am trying to make a performance diagram of an electrical powered device vs range, speed, etc. I want to compare it using the equivalent of fuel for a battery? I am not sure if it is just voltage... ...
89 views

### Energy stored in hard disk [closed]

What is the type of energy stored in hard disk when data is stored? And Can we use it for electric power production?
49 views

### Does the effect change if a continuing and constant force acts upon a mass?

If a continuing and constant force $F$ acts upon a body with the mass $m$, does the power (work per unit time) increase over time? It would mean that the converted energy per time unit increases. Is ...
54 views

### Too many antennas around a single energy transmitting antenna?

I am not a physicist. So I am not even sure, if I am phrasing this question properly. Lets say there is a wireless transmitter transmitting energy. Let us say I place $N$ number of antennas around it ...
81 views

### How big would a Dyson swarm have to be to supply the whole earth's human population with power?

If human energy consumption per year is 150,000 Terrawatt-hours, and the energy output of the sun is about 380 Yottawatts, how much area would you need at a distance of 0.5 Astronomical unit, in order ...
289 views

### If a propane torch is rated at 200,000 BTUs, what does this translate to in terms of joules/second?

If a propane torch is rated at 200,000 BTUs, what does this translate to in terms of joules/second? Not exactly a physics question per say, but it falls in the realm. How do I convert/understand ...
468 views

### Calculating estimated HP from velocity, auto weight, and constant acceleration

I am working on a simulation program that runs theoretical performances of different cars and was wondering if there is a way to estimate the HP at any running RPM? the problem is (and this may be me ...
77 views

### Out of phase AC transmission lines in parallel

I've been reading up on power transmission networks and came across this thing. http://en.wikipedia.org/wiki/Quadrature_booster Basically it balances the load between two parallel power lines by ...
726 views

### Why can't unequal current sources be connected in series?

Imagine two power sources: PS-1 that can supply $5A$ at $100V$, and PS-2 can supply $10A$ at $40V$. Due to conservation of charge and Kirchoff's current law (KCL), this is incorrect, and would lead ...
103 views

### How big does a natural gas compressor station have to be, so as its possible explosion to produce power equal to that of a nuclear bomb [closed]

I live in Greece and a natural gas compressor station is going to be constructed within a radius of 3km. That got me wondered. Can a possible explosion produce equal power with the little boy, the ...
225 views

### Sound power radiation of two monopole sources

For a fixed given electrical power to two monopole sources, producing the same frequency. Which mode, either in-phase or out of phase, will radiate the most sound power into the far-field?
52 views

### Power spectral density of noise: what is $\mathcal{N_0}$ in $S_X(f)=\mathcal{N_0}/2$?

My question is regarding power spectral density of white gaussian noise. It is known that the power spectral density of white gaussian noise is $$S_X(f)= \frac{\mathcal{N_0}}{2}$$ My question is does ...
899 views

### Why high voltage transmission lines?

This is a question which I seem to have tackled multiple times, solved each time after reading a dodgy internet explanation, then partially forgotten about and retackled half a year later. It is time ...
137 views

### If halving signal strength is only a 3db drop, why can't cell phones be much lower powered?

My phone can receive a signal that's -90dBm. That's roughly one-billionth of a milliwatt. Cutting a signal's strength in half only drops the signal by 3dBm. Apart from slightly higher range, is there ...
91 views

### Power and velocity?

If $P=Fv$, power is constant and the power is the rate of change of kinetic energy, i.e. $$P = d(mv^2/2)/dt,$$ what must $v(t)$ be to satisfy this equation?
78 views

### Parallel Resistors (special cases formula)

1) A car's rear window defroster uses $n=15$ strips of resistive wire in a parallel arrangement. If the total resistance is 1.4 ohms, what is the resistance of one wire? Solution: I rearranged the ...
229 views

### Power - 1/2 Force x velocity? [closed]

A pump, taking water from a large reservoir, is used to spray a jet of water with speed 20m/s. The nozzle of the pipe has radius 0.05m, and is level with the surface of the reservoir (no change in PE)....
104 views

### What is DX technology and what are the effects on digital cameras?

I am photographing in a high power voltage field in Industry producing aluminium, called DX technology. How do I know if my digital camera will not be affected? At 350kA current my film cameras were ...
785 views

### If a 2,400 lb. car is moving at 1 mile per hour, how much force is required to stop its motion? [closed]

Given that I stand behind or in front of a car and someone will move the car from within at approximately 1 M.P.H., how much force is needed to stop the force driven by the engine to put the car at ...
60 views

### High power short duration from low energy source?

1MW, can 1000Joules source of energy deliver 1M of power in 1 millisecond? $Energy =$ $P$ $x$ $t$ , so does it make sense to have small amounts of energy in large pulses of power? In an extremely ...
44 views

### Making of the electricity

I'm interested if there are actually some new electrons created in the process of Making of the electricity (turbine-generator-electricity)? I guess (flow of the electrons in the wire - electricity) ...
994 views

### Power dissipation in circuits:Why is high voltage used in power lines?

I know this question has been asked before, but there is one doubt I still cannot clear. Power dissipation is proportional to $I^2R$. Does this not mean that it is also proportional to $V^2/R$? If ...
217 views

### Does adding water on convex mirror increase its power?

What is the comparison between the power of convex lens in air and in water ? What causes the change in its focal length
327 views

### Finding power in series circuit

A resistor of resistance 12 ohms is connected in series with a cell of negligible internal resistance. The power dissipated in the resistor is P. The resistor is replaced with a resistor of resistance ...
88 views

### Getting maximum power/brightness from 5 lightbulbs with different resistances [closed]

Hi I am trying to figure out the best way to arrange 5 lightbulbs to get all of them to have the maximum brightness with a 30V battery. The 5 five lightbulbs have different resistances: 3ohms, 6ohms, ...
732 views

### What's the relation between output voltage and time to boil water given the same kettle?

An electric kettle rated 220V, 2000W needed 10 minutes to boil water when it is half filled with water in Singapore where the output voltage is 220V. Estimate the amount of time needed to do the same ...
517 views

### Why doesn't a resistor dissipate reactive power? [closed]

Is there a (preferably microscopic) explanation for why a resistor does not dissipate reactive power?
77 views

Our home appliances are mostly resistive loads and the bill we pay for consuming power is actually real power. If we use more inductive loads at our home, will it just cause problems in power factor ...
198 views

### Calculate signal strength received by an Ultrasonic Transducer [closed]

Below is an image showing transducer A transmitting a signal with an amplitude of 3000mV, I am trying to calculate the amplitude of the signal received by transducer B in mV, I understand that there ...
830 views

### Power to suspend a mass in air

How much power is needed to suspend a mass in the air? The four parts below deal with the same problem. I post them all here, should there be some subtle things I didn't see. The textbook problem A ...
190 views

### Eddy Currents: Relationships between thickness and deceleration

This is probably a question with a very simple answer, but I want to make sure before I write too much. I'm doing an investigation on Electromagnetic fields, in particular eddy currents and how they ...
1k views

### How does Ohm's law apply to superconductors?

As radio amateurs we've all learned the various relationships of power, voltage, current and resistance as expressed in Ohm's Law. My question relates to the following simple circuit showing an ideal ...
178 views

### Will my car consume more if I plug in my laptop?

I drive a Volvo v40 with a 110hp diesel engine. It usually use 4.6L/100km. If I plug my laptop which is 85W, will this change the fuel need? If so, by how much?
I understand that power is that rate at which work is done and that because of this the power in an inductor is equal to $$P=\frac{d}{dt} \left(\frac12Li^2\right).$$ I also understand that the power ...