0
votes
0answers
21 views

Energy and momentum [on hold]

In a good wind location offers a modern wind turbine with a maximum output of 1 MW over 2 million kWh per year. a) How many m ^ 3 of oil is equivalent to that energy content if 1 liter of oil ...
-3
votes
1answer
53 views

If a 2,400 lb. car is moving at 1 mile per hour, how much force is required to stop its motion? [closed]

Given that I stand behind or in front of a car and someone will move the car from within at approximately 1 M.P.H., how much force is needed to stop the force driven by the engine to put the car at ...
1
vote
2answers
32 views

Finding power in series circuit

A resistor of resistance 12 ohms is connected in series with a cell of negligible internal resistance. The power dissipated in the resistor is P. The resistor is replaced with a resistor of resistance ...
0
votes
1answer
36 views

Getting maximum power/brightness from 5 lightbulbs with different resistances [closed]

Hi I am trying to figure out the best way to arrange 5 lightbulbs to get all of them to have the maximum brightness with a 30V battery. The 5 five lightbulbs have different resistances: 3ohms, 6ohms, ...
0
votes
2answers
102 views

What's the relation between output voltage and time to boil water given the same kettle?

An electric kettle rated 220V, 2000W needed 10 minutes to boil water when it is half filled with water in Singapore where the output voltage is 220V. Estimate the amount of time needed to do the ...
2
votes
0answers
29 views

Calculate signal strength received by an Ultrasonic Transducer [closed]

Below is an image showing transducer A transmitting a signal with an amplitude of 3000mV, I am trying to calculate the amplitude of the signal received by transducer B in mV, I understand that there ...
2
votes
3answers
123 views

Will my car consume more if I plug in my laptop?

I drive a Volvo v40 with a 110hp diesel engine. It usually use 4.6L/100km. If I plug my laptop which is 85W, will this change the fuel need? If so, by how much?
0
votes
1answer
24 views

Why does the power in an inductor equal what it does?

I understand that power is that rate at which work is done and that because of this the power in an inductor is equal to $$P=\frac{d}{dt} \left(\frac12Li^2\right).$$ I also understand that the power ...
1
vote
0answers
44 views

Max speed as a function of engine power

My question started out as finding the maximum speed of a go kart, taking into account only the drag forces as force opposing the motor. I've done some investigation to find: $$ F_{drag}=\; ...
1
vote
2answers
101 views

who will win a race between man, horse and car of same power

Other day I got into a chat with my friend on work power and energy where he asked an intelligence related question the question was like this if a race was conducted between a man a horse and a ...
2
votes
1answer
26 views

Minimum Power Required

Here is a question, I found two methods to solve it, differing in the answers and I'm not sure why a method is incorrect. Question: A fire hose of cross section area ...
0
votes
2answers
32 views

Question on power

A wind turbine produces a power $P$ when the wind speed is $v$. Assuming that the efficiency of the turbine is constant, the best estimate for the power produced when the wind speed becomes $2v$ is ...
1
vote
0answers
60 views

Calculating Joule heating in magnetic field

I have problem with calculating Joule heating in alternating magnetic field perpendicular through circulate plate with radios a and height h. Lets say that alternating magnetic field is in form of ...
1
vote
2answers
157 views

Finding power with Drag Force equation

The mass of the car is 1500 kg. The shape of the body is such that its aerodynamic drag coefficient is $C_D=0.330$ and the frontal area is $2.50 m^2$. Assuming that the drag force is proportional to ...
-1
votes
1answer
40 views

Acceleration Power [closed]

Suppose we have a trolley currently at rest at point A, but the motor switches on, so that it accelerates and reaches point B, at point B, the velocity is 5m/s, Distance of A-B is 10m, mass of the ...
1
vote
0answers
199 views

Power dissipated through resistor in RC circuit with charged Capacitor [closed]

so here's the problem: A simple RC circuit where the capacitor has been charged, and two resistors are in parallel configuration. How does one find the power (as function of time) through any of the ...
2
votes
2answers
113 views

Numerical: Work Power Energy [closed]

A particle moves along a straight line. A force acts on the particle which produces a constant power. It starts with initial velocity 3 m/s and after moving a distance 252 m its velocity is 6 m/s. ...
-1
votes
1answer
25 views

Computing power based on weighted averages [closed]

I'm struggling to understand the reason why I'm getting different results with two apparently similar ways to compute the power consumption (over multiple time intervals) of an electrical circuit. ...
1
vote
0answers
427 views

Work, Energy, Power, Force question [closed]

Question: 3 boys push a small car 25 m up a hill inclined at 19° to the horizontal. The car has a weight of 860 N and they push it at a steady speed of 0.5 m s-1 against an opposing force of friction ...
0
votes
4answers
7k views

Power dissipated in Series versus Parallel

Do two resistors in parallel dissipate more heat per unit time for an applied voltage when compared to two resistors in series?
-4
votes
2answers
367 views

Basic Physics Question [closed]

I'm having a difficult time answering this question. I think I'm just converting the units wrong somewhere: You're the CEO of a courier company, and you decide to select an electric car for your ...
2
votes
1answer
133 views

Does a 27 hp engine output the same amount of energy as lifting a 1 ton stone block almost 3 meters per second?

I’m trying to get a sense of how much energy a 27 horsepower engine outputs. 27 hp $=$ 20 133 watts (joules/second). Potential energy can be calculated as $E = mgh$ where $g = ~9.8\ m/s^2$ on earth. ...
-1
votes
1answer
126 views

There is no electricity at home,I need to light a 15W CFL Bulb.Can I Do it with the help of a hamster? [closed]

We know that i)avg speed of A Hamster is 30km/hr. ii)Avg mass of hamster is 1.5 kg. From the above info: Kinetic energy=1/2 X mass X velocity^2 So, K.E=1/2 x 1.5 x 30 x 30 ...
0
votes
2answers
134 views

Electric power transmission

If we want to transmit electic current for a long distance, we must minimize a heat that releases because of the resistanse. We cannot make a cable wide because it is expensive and it will be massive. ...
0
votes
1answer
432 views

Is resistance to motion directly proportional to the speed of a moving object?

Power is known to be equal to the force x velocity (P=FV). Im solving a question that states the following : Car with engine working at 32 kW, mass of 1 tonne, travels at a constant speed of 40m/s ...
1
vote
2answers
637 views

Mechanics Question: Energy, Work and Power

I'm a pure mathematician by trade, and have been trying to teach myself A-level mechanics. (This is not homework, it is purely self-study.) I've been working through the exercises and have come up ...
2
votes
6answers
1k views

Confused about unit of kilowatt hours

So I am a little confused on how to deal with the Kilowatt hours unit of power, I have only ever used Kilowatts and I have to design a residential fuel cell used as a backup generator for one day. ...
0
votes
1answer
3k views

Calculate the UPS Capacity in amp-hours [closed]

I am trying to find out the UPS capacity in amp-hours for my HP UPS system. I've already done some calculations based on the UPS information from the HP Power Manager software. Bellow are my ...
1
vote
3answers
5k views

Two 60W-lightbulbs are connected on 220 V AC-voltage - how much electric power is spent by each lightbulb? [closed]

Two 60W-lightbulbs are connected on 220 V AC-voltage - how much electric power is spent by each lightbulb? There are two scenarios: In one, these two lighbulbs are connected serially, and in the ...
2
votes
1answer
1k views

Finding electric power generated using heat transfer

I'm working through an example I have been given to study. Suppose I have a 2m X 4m photovoltaic panel on my roof that is irradiated with a solar flux of $G_s = 700W/m^2$. Given: $\alpha_s = 0.83$ ...