0
votes
0answers
35 views

Which metal will be on the surface after solidification?

I know that there are some metals that just "like" to be on a surface, so if I make an alloy of such metal and some other metal, the first one will be on the surface after solidification of initially ...
0
votes
1answer
106 views

is this heat calculation equation correct?

If I have a line of copper wire (lets say $\textrm{1 meter}$ long, $\textrm{1 mm}$ thick) and one end is a flattened disk of copper about the size of a quarter, and I apply a lot of heat to it (I'm ...
7
votes
2answers
335 views

Why does Platinum evaporate if left long enough?

I have been reading into research relating to the redefining the 1 kg weight as the current Platinum-Iridium is becoming smaller. In this article, here, it mentions that the original metal weight ...
2
votes
2answers
327 views

How would a change in ambient temp affect a radiator?

I'm curious if you have a radiator or say a block of metal (lets say it's copper since it has the highest thermal conductivity) and on one side is a processor producing heat. At idle the processor ...
6
votes
1answer
144 views

Reflectivity of a glowing-hot metal surface

When a polished piece of metal (or steel in particular) is heated to incandescence, how do its reflective properties change? Given a mirror-like surface, would the object temporarily cease to act ...
2
votes
1answer
775 views

How long does it take a warm object to cool in air?

This is a work-related question. A warm steel torus of a given diameter & thickness is left in a room held at a controlled temperature, how long does it take to reach equilibrium? Assume the air ...
2
votes
2answers
3k views

Will the hole on a metal disc expand or contract upon heating? [duplicate]

Possible Duplicate: Will a hole cut into a metal disk expand or shrink when the disc is heated? The metal disc of diameter D1 has a hole in it and the diameter of the hole is D2 (D2 Now, ...
31
votes
8answers
22k views

Will a hole cut into a metal disk expand or shrink when the disc is heated?

Suppose you take a metal disc and cut a small, circular hole in the center. When you heat the whole thing, will the hole's diameter increase or decrease? and why?