0
votes
1answer
21 views

Self inductance & time constant formula

Is this a correct formula for calculating the induced EMF of a wire after the current stabilizes/ or while it stabilizes in the beginning of a DC circuit? What is the difference between the above ...
0
votes
1answer
18 views

Why do we always consider the area of inner solenoid while calculating the mutual inductance of two coaxial solenoids?

While we know that flux linked to an area is the dot product of the area vector of the loop(and not the actual area encountering the field lines) and the magnetic field linked to it, why then do we ...
0
votes
1answer
44 views

EMF due to self-inductance? [closed]

I'm trying to calculate the induced $-V$ in a DC circuit when current starts to flow, and reaches it's maximum value. The inductance of the conductor is 1000nH it carries large amounts of current ...
1
vote
1answer
83 views

Is there inductance to a DC circuit?

When a DC circuit is carrying current, large amounts or small, is there induced-emf due to the inductance? Or is it only applied to AC circuits?
0
votes
2answers
48 views

Electromagnetic Inductance: Different voltmeter readings from different positions

In the setup below, the voltmeter on the right would read differently than the voltmeter on the left even though they are both connected to point D and point A. This picture is taken from Lecture ...
6
votes
1answer
170 views

Reluctance of torus shaped iron core with embedded wire loop

Imagine a circular wire loop (r = 50mm), the wire has an assumed diameter of zero, which is embedded in a torus shaped iron core with a circular cross-section of R = 10mm. A current in that loop ...
1
vote
2answers
38 views

Why does the current increase in an LC circuit while the capacitor is being discharged?

From the maths governing an LC circuit (eg. $E_B=\frac{LI^2}{2}$) we can deduce, that the current through the inductor will have a maximum value, when there's no energy stored in the capacitor, or ...
0
votes
0answers
27 views

Mutual Inductance of co-planar (but not concentric) loops

Two small wire loops, each with radius b, are placed a distance $d >> b$ apart. The loops are oriented as shown below; i.e., both loops lie in the x-y plane. Each loop carries the same current ...
0
votes
0answers
23 views

Origin of induced emf

What is the origin of induced emf in a conductor which is produced by changing magnetic flux.I mean why changing magnetic flux causes the production of induced emf. Is there some kind of energy ...
0
votes
1answer
34 views

Inductor's energy

I have some knowledge about LC circuits, like I know Maxwell's equations, the differential equations of circuit oscillator and so on. I am armed with equations to solve physical problems involving ...
0
votes
2answers
85 views

Magnetic field by a solenoid?

I am really not able to understand why is it that the current,while finding the magnetic field in the solenoid (ideal one), is not $I$ the current flowing throught the solenoid but $nI$, where $n$ is ...
1
vote
3answers
96 views

Current through two inductors after a long time

I'm having trouble with visualizing the following problem, which is asking me for the final, steady current in both inductors $L_{1}$ and $L_{2}$. I was thinking that after a long time, essentially ...
1
vote
1answer
59 views

Energy in a Solenoid?

Consider a circuit consisting of a battery, a resistor and a solenoid inductor. Then, the emf $\mathcal{E}$, is defined as: $$\mathcal{E} = L\frac{di}{dt} + iR$$ Multiplying both sides by ...
6
votes
3answers
858 views

When mutual inductance is occurring between two coils, is self inductance always occurring in each individual coil?

When a coil connected to an AC generator creates an EMF in another nearby coil (mutual inductance), is self inductance simultaneously occurring in both coils?
6
votes
0answers
102 views

Are there analogs to resistance, inductance, capacitance, and memristance connecting the weak force to electromagnetism?

A question was asked over at EE.SE recently which I tried to answer, but much of my answer was speculative. I'm hoping someone here can help my ignorance. In electronics design, there are four ...
0
votes
1answer
135 views

determining Induced emf/current through v x B . l

I am working on a question from my book. I am wondering how they conclude emf is negative in this case. looking at $$ \mathcal{E} = \vec{v} \times \vec{B} \cdot \vec{dl}$$ If there's some implied ...
1
vote
1answer
204 views

How to imagine the first few moments of an LR circuit?

For example, there's a very simple circuit which only contains on resistor. So according to Ohm's law, we have: $\mathrm{emf} = IR$ As we know when time $t = 0$, the current must be $I = 0$. However, ...
0
votes
0answers
131 views

Comparing sensitivity of flat spiral coils with regular solenoids

I'm attempting to compare the sensitivity that can be gained by using flat spiral coils against regular solenoid coils. A nice paper here gives reasonably accurate expressions for the inductance of ...
2
votes
1answer
91 views

Inductor rise time and inductor wire length

So here is an interesting question about inductors or coils in general. Suppose you had a inductor which was 12 inch's in diameter and say 12 inch's in length and has 100 turns of wire. The total ...
1
vote
4answers
2k views

Transformer: primary side & secondary side current 180 degree out of phase

I am a novice in electrical engineering. I notice that in transformer the secondary side current & current referred to as primary are 180 degree out of phase from each other. But why it is so, I ...
2
votes
1answer
83 views

Circuit Loop Law Doubt

In a circuit with a solenoid/inductor and a resistor and a battery . Books say that $\Sigma \Delta V=0$ around a closed loop . That means work done by electrostatic field per unit charge is $0$ ...
3
votes
1answer
393 views

inductance value of a single turn thin circular coil

the question may seem simple but I haven't found any fitting formula yet. The problem is the following: consider a single-turn, circular coil made of reasonably thin wire (diameter of the wire much ...
6
votes
3answers
3k views

Faraday's law - does the induced current's magnetic field affect the change in flux?

I've had this conceptual problem with Faraday's law and inductance for a while now. Take the example of a simple current loop with increasing area in a constant field (as in this answer). So ...
2
votes
2answers
190 views

What is the maximum power available from a magnetic field?

I just want to validate something I inferred from studying Griffiths (1999). The instantaneous magnetic field $\vec{b}(t)$ at a distance $r$ from a long infinite conductor carrying a current $i(t)$ ...
0
votes
2answers
96 views

Where's the energy in coupled magnetic fields?

Suppose I have two identical current loops superimposed upon one another, but with their currents in opposite directions. The coefficient of coupling $K=1$, and therefore the mutual inductance $M ...
0
votes
1answer
202 views

Inductively coupled DC circuit

The circuit under consideration has two inductively coupled loops, one with a DC battery, inductor, and resistor in series. The other loop has two inductors, one inductively coupled to the first, the ...
5
votes
2answers
1k views

How to calculate required current and specifications for a “wet coil” to generate x Tesla of magnetic field?

A water management project requires a "wet coil" (coil will be submerged in aqueous media) designed to generate a steady-state electromagnetic field of adjustable magnetic magnetic flux density at the ...
0
votes
1answer
1k views

Mutual Inductance and the Dot Convention

Can anyone please explain me, the dot convention in coil systems (Mutual and self inductance) with some related images to understand..?
0
votes
0answers
661 views

Ewings Molecular Theory of Magnetism & Induction Cookers

This question regards Ewings molecular theory of magnetism I.) Ewing's molecular theory of magnetism describes every magnetic substance as being a collection of dipoles that are initially in a state ...
1
vote
1answer
406 views

Non-conservative Electric Field

I was watching this video from Walter Lewin and while watching these two videos, I noticed there is a "contradiction" in what he is doing. All links direct you exactly to where he begins, so you don't ...
2
votes
2answers
758 views

A wobbly pan on an induction cooker, is it less effective?

According to the Wikipedia, one of the limitations of the induction cooker is that the bottom surface of the pot should be flat. Accordingly, I commented on a question on Seasoned Advise, but I'd ...
42
votes
7answers
4k views

Cyclist's electrical tingling under power lines

It's been happening to me for years. I finally decided to ask users who are better with "practical physics" when I was told that my experience – that I am going to describe momentarily – prove that I ...
2
votes
2answers
447 views

Maximize Magnetic Self-Inductance Through a Wire

You are given a long length W of copper wire. How would you arrange it to obtain the maximum self-inductance? Why? I am trying to use the equation $$L=\mu_o n^2 l A$$ I try to solve it using a ...
2
votes
2answers
5k views

Relationship between inductance and number of turns in a coil in loudspeaker

I am in the process of designing a loudspeaker and have a question regarding the number of turns in the multilayered solenoidal coil and the speaker impedance of $8\:\Omega$. I understand that the ...
2
votes
2answers
194 views

Drum head coupled with an RLC circuit

I'm thinking about the possibility of an electroacoustic drum that would be tuned with some kind of RLC circuit. The drum head would have an electromagnet attached to its center, which would be ...
2
votes
1answer
380 views

Induction and Halbach Array

I have recently studied and tried to understand the concept of the Inductrack ( http://en.wikipedia.org/wiki/Inductrack ), a form a magnetic levitation. In the following link they present three ...
1
vote
1answer
221 views

Would a strong diamagnetic material exhibit inductance?

Erm. This question got shot-down in electronics.stackexchange.com and somebody recommended I raise it on here, so ... Do metals with the property of strong diamagnetism also exhibit inductance? ...
2
votes
1answer
257 views

Practical physics: where does this current come from?

It's been a while since school and I don't remember the right laws and formulas. So I come here. :) I've got a power cord extender running from the wall outlet to my washing machine. It's about 3 or ...
6
votes
4answers
7k views

Derivation of self-inductance of a long wire

Currently I am stuck, trying to derive the self-inductance of a long wire. According to literature it should be $$L=\frac{\mu_r\mu_0l}{8\pi}$$ and in literature its derived by looking at the energy ...
2
votes
1answer
307 views

Are inductance and self-inductance synonyms?

Wikipedia mentions that the word self in the word "self-inductance" is to differentiate it from "mutual inductance". But it does not state whether the two things are the same thing. So do the both ...