0
votes
1answer
61 views

How does friction and mass of the string influence the tension force?

According to my book, "tension is the reaction of a rope when it is stressed". Then it also said when the string is massless, tension is same everywhere. However in a,let, pulley-rope system,when ...
1
vote
1answer
43 views

What force counteracts friction when a block is pulled?

Firstly, I understand and apologize that this is more of a physics question than a math question. I noticed that when I pulled a book out from under a pack of gum, the gum stayed largely in place (it ...
0
votes
1answer
33 views

What will be the acceleration of an object $A$ when its released by another object $B$ moving with an upward acceleration $a$?

What will be the acceleration of an object $A$ when its released by another object $B$ moving with an upward acceleration $a$? Will the acceleration of the object $A$ be more than the acceleration due ...
1
vote
1answer
60 views

Why does Newton's Third Law not preclude any motion at all? [duplicate]

When walking, if I apply a force of 2N on the earth, the earth applies a force of 2N back on my feet due to Newtons 3rd Law of Motion. These 2 forces are equal in magnitude but opposite in direction, ...
0
votes
1answer
30 views

Kinematics - moving body [duplicate]

If I have an inclined plane, which has acceleration $\alpha$, will a block placed on the inclined plane slip back with the same acceleration? (considering that the surface is frictionless)
0
votes
3answers
156 views

Confused about Newton's 3rd law

I am confused about Newton's 3rd Law. If a person jumps off the ground a force is applied both to the person and to the ground. However, as $F=ma$ acceleration experienced by the Earth is much less ...
4
votes
1answer
91 views

Why doesn't a wall move when you push it if there's space behind it?

In the first screen you can see that if a person were to push a wall within a typical household the wall would not move while keeping themselves tractioned to the floor. If you push hard and do not ...
0
votes
1answer
38 views

Tension when two connected blocks are pulled in opposite directions [duplicate]

Suppose there exist two blocks A and B connected by a massless, inextensible cord. Both A and B have equal masses and are acted upon by equal forces in opposite directions. So, is the tension in the ...
0
votes
0answers
42 views

Tension on a string pulled by unequal forces

Suppose two cases where masses are attached to massless, inextensible strings. In the first case a body which has a weight of 20 Newtons(downwards) is attached to a string which is acted upon ...
1
vote
1answer
35 views

Tension in an Atwoods machine conceptual?

Assuming $T_1$ is the force that acts on box $1$ and $T_2$ is the force that acts on box $2$. Exactly what causes the Tension? Why does $T_1 = T_2$? The problem is we are told to memorize that ...
11
votes
14answers
3k views

Is Newton's third law always correct?

Newton's third law states that every force has an equal and opposite reaction. But this doesn't seem like the case in the following scenario: For example, a person punches a wall and the wall breaks. ...
1
vote
1answer
53 views

Motion of a car rounding a bank

When a car is traveling round a banked track as fast as possible, it has a tendency to slip up the slope. Opposite in the case when the car travels slowly and has a tendency to slip down. Can ...
0
votes
1answer
110 views

Newton's third law, action vs reaction

When I push a wall with my hand, the wall does the same and because both forces cancel out the sum of the forces applied by me on the wall and the wall on me is zero, plus the friction on the ground ...
1
vote
1answer
69 views

Naming vectors in free body diagrams

Is there a convention for naming the vectors? Suppose there is a box on a table. I'm going to draw the forces acting on the box. So I focus on the box and ignore forces acting on the table, the ...
2
votes
3answers
184 views

If something that is moving at constant velocity has no net force acting on it, how come it is able to move other objects?

Let's say 10 kg block is sliding on a frictionless surface at a constant velocity, thus its acceleration is 0. According to Newton's second law of motion, the force acting on the block is 0: $a = ...
0
votes
0answers
42 views

How would you explain the difference between these situations?

I have been thinking about this for quite a while, but I just can't seem to formulate a coherent answer. In problem which I will denote (a), we have a man sitting on some sort of chair and he is ...
2
votes
1answer
144 views

How is circular motion possible on a banked road when there is no Friction?

It is given here that the maximum safe speed of a vehicle on a banked road having coefficient of friction $0$, is $V =\sqrt{R g \tan \theta}$, where $\theta$ is the angle of banking. I can't ...
3
votes
3answers
325 views

Conical vs Simple Pendulum

I don't understand why the Tension $T$ on a conical pendulum and a simple pendulum are different. In a simple pendulum, one would say that the tension of the rope is $T=mg \cos(\theta)$. However, ...
0
votes
1answer
83 views

Do we stand on the earth because of Newton's third law?

This is the question I encountered and I'm not sure I understand. The Newton's third law say that, when a body 1 exerts a force on the body 2, then the body 2 will exert the same force on body 1, ...
4
votes
2answers
209 views

If $F=ma$, how do can we experience both gravity and a normal force even though we are not accelerating

So as I sit in my chair, I experience a gravitational force pushing me into the chair and I'm also experiencing the normal force of the chair pushing back at me so I don't fall. According to Newton's ...
1
vote
3answers
308 views

Force when acceleration is zero

i tried to find it in books but i was unable to do so and i am not able to understand this and I couldn't think of a better example. i repeat. its just an example. if i punch someone's face with my ...
1
vote
2answers
299 views

Direction of force of friction?

I know that friction opposes the direction of the velocity, but the problem is when I don't know what the direction of the velocity is. When I'm drawing a FBD for complex systems with ramps and ...
0
votes
2answers
125 views

Is my free diagram of a spring stretched on one end and attached to the wall on the other end correct? [closed]

Consider the following figures. The top one shows the construction of a spring where its left end is attached to the wall and its right end is stretched by a force. The bottom one is supposed to be ...
-1
votes
1answer
93 views

What stops the car?

Centre of mass of a system cannot change its state of motion, unless there is an external force acting on it. Yet the internal force of brakes can bring a car to rest. Then what stops the car?
0
votes
1answer
101 views

Confusing Classical Mechanics Question

I don't want this to be a "do my home work question" so please tell me how I can make this question helpful for other people. In my physics assignment I found the question below. I'd think that both ...
3
votes
1answer
151 views

Force on bolt holding up jet engine on plane

I am to solve the following: A jet engine of mass $m$ is fastened to the fuselage of a passenger jet by a bolt. During flight, the plane encounters turbulence, which suddenly imparts an upward ...
-6
votes
3answers
212 views

Can you lift a basket up while standing inside it? [closed]

Suppose you stand in a basket and you try to pull the handles of the basket. Will you be able to lift the basket from ground? Similarly, Baron M√ľnchhausen allegedly pulled himself and the horse on ...
1
vote
4answers
305 views

Action Reaction when I pushing a trolley?

I tried to explain how those force work but I can hardly figure it out. I exerted a force on the trolley and there will be a force on trolley on me as well. This is the newton's third law. But why the ...
0
votes
4answers
510 views

How can acceleration $a$ be zero when applied force $F$ is non-zero?

An object is at rest and stays at rest, but an attached rope pulls with increasing force. What is the acceleration? The correct solution is that acceleration is constant and 0. Obviously $a= dv/dt ...
1
vote
1answer
525 views

Newton's Third Law of Motion

I want to start off by saying that I've looked around for other explanations, but I've not really found any satisfying ones. My question is basically the whole "Why can anything move at all?" ...
2
votes
1answer
828 views

Static Friction in Free Body Diagram (FBD) of Car parked on Incline

I'm working on a sample problem and it asks on how steep of an incline can a car park? From what I learned the friction is in the opposite direction if there was motion in said friction-less ...
2
votes
1answer
172 views

Vertical Load Reactions On A Ramp

Hello, I'm working on a small hardware project. I have two load sensors located at distance $S_1$ ($x=0$) and $S_2$. Assuming we ignore the weight of the ramp ... What is the load on $S_1$ and ...
32
votes
5answers
11k views

With Newton's third law, why are things capable of moving?

I've got a rather humiliating question considering newton's third law "If an object A exterts a force on object B, then object B exerts an equal but opposite force on object A" -> $F_1=-F_2$ ...
-1
votes
1answer
570 views

How should I draw this free-body diagram?

The horizontal force P acts on the rim of the homogeneous cylinder of radius R and weight W. Determine the smallest coefficient of static friction that enables the cylinder to start rolling up the ...
2
votes
2answers
2k views

Rolling resistance and static friction

I am a bit confused about the relation between rolling resistance and static friction. I have often heard that it is the static friction that lets the wheel roll. Consider the following two cases: ...
1
vote
1answer
2k views

Two problems with free body diagrams. Contradictions (solutions are provided)

This problem is similar, but also different question from my previous question. They are both unfortunately long. Problem/Solution #1 ! ! Quick Concept Check a) Could someone briefly explain to me ...
2
votes
1answer
613 views

Why is static friction omitted here? And comparison with this problem on Newton's second Law. Solutions are all provided

The problem itself is short, but my concept question is...long. So be prepared. Note that problem 1 and problem 2 are related to my concept questions, so I am not taking advantage of asking two in ...
1
vote
2answers
2k views

How do I properly use Newton's Third Law and Free Body Diagrams?

A force of 14.0N is applied to a block as shown in the diagram below ! If the coefficient of friction is between the surface and the blocks is 0.35 a) What is the acceleration of the two blocks? ...