5
votes
1answer
80 views

Titanic Question

I was reading this question: Was Titanic's captain's decision correct? @oakad commented about a Russian vessel keeping itself afloat by going in reverse, using hydrodynamic pressure to keep ...
1
vote
0answers
29 views

Water pump with a tap connected at its opening not pumping water when water is drawn from the pump before starting the pump [closed]

Please give your explanation in layman terms, without throwing any complex equations at me. We have a 5000 liter tank dug in ground and a water pump connected to this tank that draws water from it ...
0
votes
1answer
103 views

Calculation of pressure from flow rate of water

Anybody kindly help me to find how to calculate pressure in bar from flow rate. I have a pipe and from that I am transferring water at a constant flow rate of 5ml/min. At this flow rate, with a 0.5 cm ...
1
vote
1answer
79 views

Is a falling, perfect sheet of fluid possible to create?

This is a bit of an abstract question so I'll try explain this as best I can from the bottom up. I would like to know if it is possible to observe a sheet of fluid, much like a sheet of glass, ...
2
votes
1answer
102 views

Does increasing diameter of a water pipe increase speed or volume?

Let's say water is flowing from an arbitrary Source to some arbitrary Sink via a small pipe: I'm curious as to what actually ...
1
vote
0answers
48 views

What kinds of reactions happen when bubbling air through water?

Mostly I have seen air bubbling used to remove impurities in the water itself, like exemplified in this course packet. This is called "Sparging," but I have yet to learn much about transfer between ...
3
votes
4answers
146 views

Force of an impact on water

Today, at the Brazilian news, I heard that a men fell from a cruise into the sea, from a height of 50m, and decided to see if he could have survived. I took his weight for being 80kg. I did ...
2
votes
0answers
47 views

Fluid Dynamics Tsunami

I have been given a energy head (pressure) in meters for a given tsunami on land. My question is if the tsunami hits a wall 1 meter by 1 meter, is it possible to calculate the height it will reach. ...
1
vote
2answers
338 views

What will happen if we put balloon in water tank in space

Imagine this. You have some object (let say barrel) and fill it with water. The water remains rather calm so it doesnt' spills out. Then we take a balloon filled with air and push it in that tank. ...
0
votes
1answer
91 views

What is “hydrostatic uplift pressure”?

I was reading Wikipedia about the St. Francis Dam and came across this sentence. Water that collected in the drainage pipes under the dam to relieve the hydrostatic uplift pressure was carried ...
2
votes
2answers
86 views

Why is a material such as plastic air-tight?

I'm not too familiar with fluid mechanics, but i always wondered how let's say plastic containers would be able to contain a fluid, such as gas or water. How does plastic prevent the molecules of the ...
0
votes
3answers
61 views

Upward bouyant forces?

When an object is submerged in a fluid (e.g., water), there is a pressure on the object due to weight of water by p=mgh, but why is there an upward buoyant force?
4
votes
3answers
143 views

Can one pump water without providing an external source of energy? [closed]

I have a farm situated right beside a canal through which we use to get water for our crops. I am not financially sound to buy an electric motor. The water is 15ft below the ground level. So can ...
3
votes
1answer
319 views

Does water turn solid under deep ocean because of high pressure?

I know that we can make water solid with high pressure, so I think water will be solid in the deep ocean? If that is true, the depth of the ocean would be limited because water will become ice? ...
3
votes
2answers
112 views

How come a whistling kettle starts whistling only when water boils, and not long before - due to hot air escaping under pressure?

A whistling kettle will start to whistle when the water boils and turns into a jet of steam which then exits the small aperture in the spout. But why doesn't this happen much earlier - when the air ...
2
votes
2answers
162 views

If the MH370 black box did sink to 15000 ft, how long would it have taken?

I have been following MH370 on the news just as everyone and latest reports seem to indicate that the black-box could be found. A recent info-graphic http://t.co/lyBBE9C2hF shows the insurmountable ...
1
vote
1answer
54 views

Modeling Water Surface Impact

I have a project that is to model the wave equation in a pond due to a pebble being thrown in. The project is quite simple as all we really have to model is the wave equation with an initial ...
2
votes
1answer
80 views

Time taken in changing surface tension [closed]

I had read some where that the water in glasses has a high surface tension, but in lota (It is sort of a spherical container) the surface tension is lower. How can I measure the water surface ...
4
votes
1answer
119 views

Water falling, why does it spin?

I have noticed that water, when falling will rotate. Looking closely at a thin stream from a faucet and placing a flat object mid stream you will see the water is rotating. The further down the stream ...
3
votes
1answer
97 views

Why is the water on one side of a bridge choppy?

My daily commute take me across the Evergreen Point Floating Bridge on Lake Washington. I have noticed on several occasions that the water on the southern side of the bridge will be quite choppy ...
6
votes
3answers
1k views

Effect of water pressure on sinking objects

As I understand, water pressure increases as we go towards bottom of the ocean. So if an object* is thrown into water and it starts sinking with some speed, does the sinking object's acceleration ...
0
votes
0answers
73 views

Determining The Coefficient of Viscosity and Diffusivity in an Estuary?

I am curious and eager to discuss about the experience of determining viscosity and diffusivity coefficient for our coastal or estuary model. I myself, just start to use the range of: ...
1
vote
2answers
118 views

What is a good model for computing water dropping on a surface?

Before introducing my question I would like to outline the fact that I'm a coder, so I can be wrong when using some kind of terminology. What is a good model for computing the flow, the shape and all ...
4
votes
2answers
111 views

Dynamics of Honey in hot water: Honey accelerates like it is falling through air?

Here is a Video showing the honey accelerating in the hot water. As you can see, there are also dynamics. Since the water started stationary, I guess the dynamics arise because of convection flow. ...
-3
votes
1answer
126 views

Slope of a channel

I have a trapezoidal channel like this: The question is to get the slope of the channel such that we have a Chézy coefficient of 64 $m^{1/2}/s$. Given: $B= 76\: \mathrm{m}$, $y = 10\: ...
2
votes
1answer
85 views

Non-determinitric flow of water stream on vertical porcelain surface

I noticed several times while washing my hands that accumulated water when starts streaming vertically does not flow vertically in straight line on vertical porcelain surface under the force of ...
-2
votes
1answer
73 views

What is the physics concept in sponge filter

I really need help I want to ask what is the physics concept in Sponge Filter?
13
votes
3answers
1k views

How to freeze the Niagara waterfalls?

Here is a picture of the usual vigorous Niagara Falls (in the winter). Here is the picture of Niagara Falls frozen in 1933 (in the very cold winter). Here is the picture of Niagara Falls frozen in ...
2
votes
2answers
118 views

Freezing water in a closed container [duplicate]

We know that density of ice reduces by about 8% during freezing, this means it expands to have little higher volume. But if I fill water in a container (entire volume) which has very low coefficient ...
7
votes
2answers
619 views

How is the water meniscus at the edge of a capillary tube

Suppose we have a capillary tube in which water can rise to a height of x cm. If we dip the tube such that the height above the surface is less than x, then how will the water meniscus be at the edge ...
0
votes
1answer
96 views

Viscosity of water in the presence of solutes

Some physical properties of water change in the presence of solutes: vapor pressure, boiling point, freezing point and osmotic pressure. In particular, these four properties are called colligative ...
0
votes
2answers
665 views

Physics of the inverted bottle dispenser

When you invert a water-bottle in a container, the water rises and then stops at a particular level --- as soon as it touches the hole of the inverted bottle. This will happen no matter how long ...
4
votes
2answers
120 views

The velocity of a cloud?

I noticed an unusually fast moving cloud this morning. My questions: What is the average velocity of a cloud on Earth? What is the greatest ever recorded cloud velocity? What factors affect the ...
1
vote
1answer
365 views

Hydrostatic pressure?

What what I understand, hydrostatic pressure is the "weight" of the water pushing against objects. But if this is true, why is hydrostatic pressure perpendicular to the surface it acts on instead of ...
2
votes
2answers
146 views

Drying up a wet object

I am wondering whether an object which has been wet with hot water always dries up more easily and more quickly than one wet with cold water. How much do the shape, roughness, material, structure of ...
2
votes
1answer
147 views

Why does cornstarch and water mixed together become solid when put under stress? [duplicate]

Here is one of the many videos on youtube showing how a cornstarch and water mixture can become very hard when put under stress. I haven't found a good explanation of why it behaves the way it does. ...
0
votes
0answers
40 views

Which laws of physics apply when creating a soap blaster with pressurized air?

I want to create a soap blaster using: a 1" hose with 8 bar compressed air a non pressured container of soap and water mix without the use a pressurized tank I.e. something like this sand blaster: ...
3
votes
3answers
364 views

Water Level and Pipe Widths

I ran into a bit of physics yesterday, and couldn't understand the physics at work. I've been scouring the Internet, but haven't found the answer yet. I'm guessing there's a basic principle I'm ...
3
votes
1answer
121 views

Mysteries of the water meter

Recently, I got an exceptionally high bill for water consumption. I went to check my water meter, and saw that it rotates in a pace of about 200 cc per minute, even though all the faucets in my home ...
2
votes
2answers
2k views

Why should fluids be confined for Pascal's Law to be applicable

When is Pascal's law about fluid pressure propagation applicable? Is it applicable to a closed circular pipe with a pump rotating the fluid, but not to a tub of water. Most statements require only ...
0
votes
1answer
406 views

Is there a way to let water pour out of bottle without letting air inside? [closed]

Is there a way to let water pour out of bottle without letting air inside? i understand that air needs to enter the bottle to ensure water flow, but i do not want to the water to be exposed to air. ...
5
votes
1answer
687 views

Does something like Pascal's Law apply in a Swimming Pool? If not, how does pressure spread?

I've been trying to wrap my head what happens when a force is exerted on the surface of a swimming pool / pond, or underneath it. Examples include a small boy cannon-balling into the deep end, or a ...
10
votes
2answers
2k views

Is there a way to fill Tank 2 from Tank 1 through Gravity alone?

I am a newbie in water system design but I am currently faced with the exact situation below on my land, and I need to know whether gravity alone is sufficient in order to fill Tank 2 from Tank 1, as ...
4
votes
1answer
250 views

Finding Surface Tension of water at certain Temperature and Pressure

So the question is: Using the Young-Laplace Equation (if applicable), find the surface tension (dynes/cm) for water at 20 degrees Celsius with 2.5 psi. Round to the nearest tenth. ...
7
votes
2answers
489 views

Why water in the sink follow a curved path?

When you fill the sink with water and then allow the water to be drained, the water forms a vortex.. And then it starts to follow a curved path downwards by effects of gravity.. Why this phenomena ...
4
votes
2answers
264 views

Best shape to reduce the splash of a droplet?

Our coffee machine catches the last couple of droplets, after your cup is removed on a shape to reduce plash of the coffee droplets. These shapes are placed inside the spill reservoir. The shape ...
3
votes
2answers
372 views

Pumping water from a closed column. Will the column get empty or just circualte?

As a picture is worth a thousand words, here is my problem: It is a closed water column with a bit of air in the top section. If I run the pump and make the water flow from IN to OUT, Will the ...
1
vote
1answer
704 views

How fast does water fall in the middle of a very very thick waterfall?

Let me create a very artificial experimental set up. Take a bathtub the size of Delaware and suspend it a mile above the ground. Fill it with water (though I'm not sure to what depth - and it might ...
0
votes
1answer
48 views

Depends river stream on river level?

If we have referral particle in the middle of the river, will it's velocity increase with higher river level?
4
votes
3answers
417 views

How can I keep a smaller water reservoir's water level at half available when being fed from a larger reservoir? [closed]

I'm trying to create my own ultrasonic humidifier. I ordered the misting part which works great but it only functions correctly in shallow water. So I'd like to feed from a large water reservoir to a ...