# Tagged Questions

12 views

### If a nozzle that converges from an inside diameter of 5cm to 3.5cm carries a gas at a VFR of 0.10 m^3/s, what is the change in average velocity? [closed]

If a circular nozzle that converges from an inside diameter of 5 cm to 3.5 cm carries a gas at a volume flow rate of $0.10 m^3/s$, what is the change in average velocity of the gas? (A nozzle being a ...
20 views

### flow through an orifice [closed]

The surface area of a first orifice with 2 mm diameter is 3 mm$^2$. The surface area of a second orifice is 5 times bigger from the surface area of the first orifice (15 mm$^2$). How much would be ...
50 views

The question is 2.10 taken from: Introductory Chemical Engineering Thermodynamics, 2E by Elliot,Lira Air at 30ºC and 2MPa flows ata steady state in a horizontal pipeline with a velocity of 25m/s. ...
512 views

### Calculate water flow rate through orifice

I'm not very good with fluid physics, and need some help. Imagine the following setup with water contained in-front of a wall with an opening on the bottom: How do I calculate the water flow $Q$?. ...
102 views

### Calculation of pressure from flow rate of water

Anybody kindly help me to find how to calculate pressure in bar from flow rate. I have a pipe and from that I am transferring water at a constant flow rate of 5ml/min. At this flow rate, with a 0.5 cm ...
96 views

### Fluid dynamics - Water level in a container

An open container is being filled with water from the top at a constant volumetric flow rate $300 \frac{cm^3}{s}$. At the same time, water is leaving the container trough a circular whole at the ...
90 views

### Determining fluid flow velocity from experimental volumetric flow rate data

I would be very grateful if someone helps me with my issue. I have a pump pumping water into a tube. My goal is to find velocity of the fluid flow in another tube that will be connected to the first ...
42 views

### To write work capacity of heart by symbols?

I know that the work capacity of the heart is Work capacity of the heart = pumping capacity x aortic impedance. I would mark work by W and impedance by Z. ...
126 views