Electronics is the study of electric circuits and electrical components, and the design of useful devices. Some questions in this tag may be more appropriate for the [Electrical Engineering(http://electronics.stackexchange.com/) SE site.

learn more… | top users | synonyms

14
votes
4answers
1k views

What's the physical meaning of the imaginary component of impedance?

As you know, impedance is defined as a complex number. Ideal capacitors: $$ \frac {1} {j \omega C} \hspace{0.5 pc} \mathrm{or} \hspace{0.5 pc} \frac {1} {sC} $$ Ideal inductors: $$ j \omega L ...
9
votes
1answer
439 views

Why do you only hear high frequencies when a microphone is near its speaker?

The phenomenon I'm talking about is positive feedback, as known from control engineering: when the microphone is too close to its speaker, it can "hear itself", so the signal will be infinitely ...
7
votes
1answer
4k views

How does a digital radio tuner work?

I believe I understand how tuning a radio with an analog tuner works: turning the dial physically changes the length of the antenna, which determines which broadcast wavelength will resonate in the ...
7
votes
2answers
2k views

Is it viable or possible to make your own transistor?

Just wondering if it is possible/viable to construct your own transistor, not small like todays, but the same scale as the one created at Bell Labs.
6
votes
3answers
12k views

Why can electricity flow only in one direction through a diode?

A few days ago I was soldering a small thing which contained a diode, a battery and some other useless things. Unfortunately, I soldered the diode reversed and it didn't work. When I reversed it ...
6
votes
1answer
695 views

How do Zener diodes survive the breakdown during reverse bias?

My highschool textbook states that Zener diodes are a special type of diode which is made of highly doped p and n junctions, and which can survive reverse bias - unlike normal diodes, which get ...
6
votes
1answer
774 views

How do Zener diodes maintain the potential across their terminals?

My physics book has a topic about Zener diodes being used as voltage regulators in the reverse bias. Well, I'm curious to know how does a Zener diode maintain the potential across its terminals after ...
5
votes
6answers
8k views

What would be the effective resistance of the ladder of resistors having n steps

I'm a tutor. This is a high school level problem. In high school, every one have might have solved a problem of effective resistance of a ladder of resistors having infinite steps. Now the problem is ...
5
votes
2answers
131 views

Layered CMOS structure question

I am trying to understand the workings of a CMOS image sensor. I understand that increasing wavelength results in an increased penetration depth in the silicon often used in CMOS image sensors. What ...
4
votes
1answer
465 views

Can electrons move through vacuum?

I studied that electronics is the branch of physics which deals with the practical applications of moving electrons through vacuum, semi-conductors and gasses. Can electrons move through vacuum?
4
votes
3answers
782 views

What are the effects of cosmic rays on consumer electronics?

When electronics/computer companies design a new chip, processor/ memory card/ or a solar cell, do they study the effect of cosmic rays on such electronically sensitive materials? If not, why not?
4
votes
1answer
4k views

Why does it spark when I push a plug in the electrical socket?

When I slowly push a plug into the electrical socket I can often see sparks. Can anybody explain why? Can this be possibly harmful for the devices I plug in?
4
votes
2answers
1k views

Pn junction voltage drop?

This image from wikipedia, explains that there occurs a potential drop across a pn semiconductor junction, and an electric field confined to the depletion region. I already know the reason for the ...
4
votes
1answer
37 views

What does a MEMS gyro measure during off-axis rotations?

I've been working with MEMS gyroscopes in hobbyist projects for years—but it's recently come to my attention that I don't have any principled understanding of what rotation rate measurements ...
4
votes
1answer
557 views

Turn-on delay time for Laser diode

Do you know any simple explanation on the reason why the turn-on delay time on a laser diode is reducing while we increase the bias current? Turn on delay,is the time that the laser needs from the ...
4
votes
2answers
676 views

lifetime of a PN junction in a diode

diodes are made of silicon, which have been enriched in phosphorus and boron to create the PN junction. Since the electrons are always going in the same direction, from N to P in the junction, I was ...
3
votes
4answers
7k views

How does power consumption vary with the processor frequency in a typical computer?

I am looking for an estimate on the relationship between the rate of increase of power usage as the frequency of the processor is increased. Any references to findings on this would be helpful.
3
votes
3answers
5k views

What is a virtual ground?

What is a virtual ground? I would like to know what it is.
3
votes
4answers
12k views

Working of a p-n junction diode when forward biased

If p-type semiconductor and n-type semiconductor of a diode are equally doped, and if the diode is forward biased, then holes will move toward the n-type semiconductor and electrons will move toward ...
3
votes
2answers
907 views

Does van Eck phreaking really work, or is it an urban myth?

Van Eck phreaking, the ability to reconstruct distally the text on a CRT or LCD screen using the leaking em from the target computer, was in the news about five to ten years ago. It is talked about as ...
3
votes
3answers
48 views

Real silicon atom structure?

Text books say that a pure silicon atom has four electrons in its outermost orbit. How do the scientists know it has four electrons?
3
votes
1answer
419 views

Explanation of the Graetz circuit

My knowledge of circuits is pretty rudimentary and I've never really understood circuits, so I'm having trouble with the concept of Graetz circuits: When you register the voltage on the resistor R ...
3
votes
2answers
114 views

Why do batteries become weaker

I was thinking about my phone (Sony Xperia Z2) and when I put it to charge and remove it, the phone says "Please remove the charger, to save battery life," which is very intuitive question for a ...
3
votes
0answers
336 views

Smallest minimum feature size possible for transistors printed by photolithography

I'm doing a project about Moore's Law, one of the subtopics I've come to is photolithography. The way I understand it is that the MOSFET transistors are currently printed on a silicon wafer by ...
3
votes
2answers
366 views

number of electrons my laptop uses in a second

in order to confirm whether I understand the relation ship between amps, columbs and electrons I decided to try out the following. my laptop adapter's label reads 3.34 amps. I assume that: amps are ...
2
votes
2answers
188 views

Mechanical work to required battery power

I have a very practical question where I've calculated the mechanical work needed by a simple mechanical system by solving the line integral $W = \int_C \ F \ dx$. However, since I have a black spot ...
2
votes
2answers
480 views

Why do circuits work so fast?

Drift velocity (explained to me as how fast the electrons are moving) is really slow. My book says the electrons move at around 10 mm/ s. If electrons move so slowly how do circuits work so fast? If ...
2
votes
2answers
130 views

Is it possible to record the 'blue air" effect when a core goes critical?

I've been studying about radiation, and I saw something called the Demon Core. Apparently, it was a core that was under experimentation by the government in Los Alamos to see the exact point at which ...
2
votes
1answer
23 views

Why Microchannel Plates can be operated only in vacuum?

Why it is said that the Microchannel Plates can be operated in vacuum? What is the maximum pressure in which it can be operated? Also, while it is not operating, should it be kept in vacuum? Is this ...
2
votes
2answers
272 views

Problems in the modern semiconductor/electronics technology?

From what I have read, the problem with modern semiconductors/electronics seems to be quantum tunnelling and heat. The root of these problems is the size of the devices. The electrons are leaking out, ...
2
votes
2answers
790 views

What is the difference of the two stable states of a Flip-flop?

In electronics, a flip-flop or latch is a circuit that has two stable states and can be used to store state information. [...] Flip-flops and latches are used as data storage elements. Such data ...
2
votes
1answer
134 views

Why the electric potential of earth is zero?

For a localized charge distribution the potential is set to zero far away from the charge distribution (at infinity) Now, when grounding a conductor, i.e. connecting it to Earth, it is said that we ...
2
votes
1answer
30 views

What do I get when measuring on top of metal/insulator/metal by kelvin probe?

I am using a macroscopic Kelvin Probe for work function measurement. There's one confusing condition. If I measure a trilayer thin film stack with a structure of ITO(bottom)/PMMA(100-200nm)/Al(top), ...
2
votes
2answers
2k views

Why are there two quasi Fermi levels and only one Equilibrium Fermi level?

I am reading a book and I'm trying to understand the concept of quasi Fermi levels. For example, A steady state of Electron Hole pairs are created at the rate of $10^{13}\ \mathrm{cm}^{-3}$ per ...
2
votes
1answer
86 views

How does rust behave as a PN junction?

Reading about old-fangled radios the reference quoted below indicates it was/is possible to use a rusted razor (or perhaps any similar thin corroded metal strip) as a detector. Some resourceful GIs ...
2
votes
0answers
49 views

Really Struggling in electronics. What to do? [closed]

This is my first post so please go easy on me. Okay. Let me introduce myself. I am a first year undergrad CS student who has to study basic electronic course for one semester. As the title says, I am ...
2
votes
2answers
87 views

what could generate a high-pitched whine in electronics where the frequency depends on the current?

So I was operating a Laue machine recently which generates x-rays and fires them at a sample, and I noticed that there was a high-pitched whine coming from the instrument (nothing abnormal, just ...
2
votes
0answers
600 views

How did the Bardeen-Brattain point-contact transistor work?

How did the Bardeen-Brattain point-contact transistor work? What are the conditions under which a Schottky barrier injects minority carriers? In a bipolar junction transistor the forward-biased ...
1
vote
3answers
92 views

How does Ohm's law apply to superconductors?

As radio amateurs we've all learned the various relationships of power, voltage, current and resistance as expressed in Ohm's Law. My question relates to the following simple circuit showing an ideal ...
1
vote
1answer
62 views

How big was the first transistor?

The first working point-contact transistor made in 1947 by Bell Labs. I'm looking for specific dimensions, all I've been able to find is "Fits in the palm of your hand".
1
vote
1answer
104 views

Why is spectral sensivity of a photodiode expressed in A/W

Can someone explain me the meaning of the A/W unit of the photosensivity when reading a spectral response function of the wavelength characteristic of a photodiode?
1
vote
3answers
112 views

Is it possible to produce gamma radiaton using radio emitter?

As in the title, I'm wondering is it possible. I think it is possible, because we have powerful enough radiotechniques and gamma radiation are just EM waves, not particles. However I think is ...
1
vote
2answers
139 views

Electrical analogy for stress and strain

It feels like the relation between stress and strain (and other mechanical properties) is analogous to that of some electrical properties (voltage and current?). I'm comfortable with electrical ...
1
vote
2answers
271 views

Explanation of NMOS processes

Gate (poly-Si + $SiO_2$) and $p^{-}$ silicon operate as capacitors. But how are voltages and charges applied? In order for inversion to occur, there should be charges formed in poly-Si, right? How ...
1
vote
1answer
32 views

why some elements of same group cannot be used for doping semiconductors?

15th group elements like As, Sb, P can be used for doping whereas N and Bi cannot be used for doping even though they too belong belong to 15th group. Why ?
1
vote
1answer
57 views

Diodes (Forward biased)

Why does the width of the depletion region decrease,when the diode is forward biased?Is it because the ions have moved to p-junction,or n-junction? Please clarify.
1
vote
3answers
704 views

Would connecting p-type and n-type semiconductors work as a diode?

If we placed p-type and n-type semiconductors close enough to be touching (see fig. 1), would this arrangement work as a diode? ...
1
vote
4answers
1k views

When does Thevenin's theorem not apply (modelling a power source with a ohmic internal resistance)

Most physics text books say that a power source can be modelled as an EMF with a internal resistance. This is also know as Thevenin's theorem or Norton's theorem. However I have read in some sources ...
1
vote
1answer
12 views

Generator phase noise influence on its averaged signal

I need to estimate averaged signal of a generator with known phase noise and the amplitude noise can be neglected. The averaged signal of the generator is expressed as: $$ \langle A\exp{i(\Omega t + ...
1
vote
1answer
69 views

Calculate TEC efficiency

I am currently doing a small experiment using a Peltier to cool 250ml of water. My aim is to achieve the cooling of 250ml from 23degC to 8degC in under 20minuets which I have done by strapping the ...