-1
votes
0answers
26 views

How does grounding work in details

How does grounding work exactly? Let's assume there is a wire with bad insulation and some conductor that is attached to this wire (from one end) and unattached on the other end. Current will not ...
1
vote
1answer
49 views

2 simple Generators = Im lost (intensity) [closed]

What happens? we have 2 Generators and 2 intensities, when I2 and I3 come together (they have opposite sides ) what happens? I tried writing down the voltage relations but I'm stuck because I don't ...
2
votes
1answer
58 views

Ambiguity on the notion of potential in electrical circuits?

As everybody else I have been taught elementary electrical circuits from secondary school to engineering level in analog electronics at university. Invariably, the notion of potential used to ...
1
vote
0answers
30 views

ODE envolving current [closed]

I have to do this exercise: 9. The current $I(t)$ at time $t$ flowing in an electric circuit obeys the differential equation $$I''(t) + RI'(t) + I(t) = \sin \omega t$$ where $R$ and ...
2
votes
2answers
166 views

How does AC current flow in an open circuit?

In common house hold wiring we have the hot lead, neutral and ground. If the hot lead in electrical wiring contacts earth ground (perhaps though a short circuit in the chassis of a device) then the ...
0
votes
3answers
57 views

Alternating Current Inquires [duplicate]

I have been looking in to alternating current and I am confused. If the voltage reverses doesn't the flow of electrons also reverse? I am aware of another fair answer on this site here. That answer, ...
0
votes
1answer
85 views

The Voltage and Current of a Discharged Inductor at the Instant the Switch is Closed

The figure shows an LR circuit with a switch and a 240-volt battery. At the instant the switch is closed the current in the circuit and the potential difference between points a and b, Vab, are ...
1
vote
0answers
32 views

To find the center of charge in current waveform

I have a circuit for which output current waveform has both positive and negative points. Now I want to get a center of the charge for this waveform (means where my net charge is concentrated ?). Is ...
0
votes
0answers
33 views

Making elementary guess regarding current in AC circuits

I was just studying the comparisons, between A.C, and D.C, and the effects they can produce in electrical circuits (viz, Joule-heating, Peltier-effect and Seebeck-effect in thermocouples, ...
0
votes
1answer
133 views

Why is $I_0\sin\left(\dfrac{\pi}{2}-\omega t\right)$ not used as a solution of the purely capacitive AC circuit?

Why is $I_0\sin\left(\dfrac{\pi}{2}-\omega t\right)$ not used as a solution of the purely capacitive circuit? My Research I've searched on Google, Phys.SE and many school level Physics books ...
0
votes
2answers
102 views

Why is emf equal to PD when circuit is “open”?

I understand that the set up of a battery consists of very good, but not ideal conductor, and therefore, some internal resistance exists. Also, I get that emf is the PD that would exist if the ...
4
votes
1answer
54 views

Why is Kirchoff's Current Rule valid?

The fact that Kirchoff's Current Rule is valid means that whatever current flows in flows out. But this will only be valid for a steady current circuit, that is, when there is no accumulation of ...
2
votes
3answers
67 views

Resistor and LED - together and separated

Something very basic which I don't get no matter how much I read. circuit A: only a resistor and power supply - the resistor will burn. circuit B: only a LED and power supply - the LED will damaged. ...
0
votes
1answer
316 views

How to calibrate an Ammeter?

Calibrating an ammeter is tricky thing to do. The obvious way would be connecting it to another good ammeter and see if they get the same result. However, people have been telling you can use a ...
0
votes
2answers
52 views

Back $emf$ and power?

The formula relating current to back emf is $V-E=IR$ where $V$ is the source pd and $E$ is the back Emf. Thus it can be seen that as the back emf increases the current decreases. But what is the ...
0
votes
4answers
223 views

What happens in a circuit, when the wire and the battery are superconducting. And shorted

When a wire with no resistance is connected to the terminals of an ideal battery, will a current exist in the circuit? If a capacitor is added to the circuit, will it be charged by the battery or will ...
1
vote
1answer
56 views

Circuits and Power

"The diagram below represents a simple circuit composed of 5 identical light bulbs and 2 flashlight batteries. Which bulb (or bulbs) would you expect to be the brightest? a) V only b) V and W ...
0
votes
1answer
60 views

Back EMF & Current, how can we make I stable?

Lets assume we have a wire that has $10V$ across and $1$ $Amp$ flowing, now if this conductor is introduced to a changing magnetic field, $-EMF$ is induced, can we control our voltage to increase it ...
1
vote
1answer
338 views

The shape of the graph of the equation: $V= -r I + E$

I have recently collected data (for a school experiment) in order to measure the EMF and the internal resistance of a solar cell. The data complied with the equation: $V = -rI + E$, i.e. the voltage ...
1
vote
5answers
287 views

How does series circuit differ from parallel circuit?

Why does same current $I$ flow in the series circuit but it isn't the case with resistors in parallels?
1
vote
1answer
233 views

How is the current flow perpendicular to the wire?

This answer gives a great explanation of how surface charge builds up to force the current to move perpendicular to the wire: http://physics.stackexchange.com/a/102936/41086 However, it fails to ...
0
votes
2answers
109 views

Voltage Drop and Charge Flow

I am hoping someone can help me with understanding voltage drop and charge flow. Here is what I think I know. The voltage drop through a circuit must equal the voltage of the battery source, and ...
1
vote
4answers
75 views

Wrong positioned Ampere-meter and Voltmeter [closed]

I'm dealing with a problem here and even that I'm trying to solve it i can't It says: In what figures the voltmeter and ampere-meter are wrong positioned? I think that all the the others are ...
0
votes
1answer
68 views

The effects of reversing the leads of an ammeter

I was playing around with a battery, an ammeter, and a light bulb. The ammeter originally read 1.99 A, but after reversing the leads going into and out of the ammeter the ammeter read -1.98A. I know ...
-1
votes
1answer
135 views

Electric shock from a frayed wire

Let's say it's a laptop charger not connected to a laptop, and it is frayed near the tip. I am guessing about 20Volts runs through that area. Now if a person touches a bit of plastic below the frayed ...
6
votes
2answers
268 views

Will I get a shock when I try to use my hair-dryer under water?

Occasionally people get killed in their bathtubs by having an electrical device such as a hair-dryer take the bath with them - in movies. It seems to be a common belief that this is realistic, even ...
2
votes
2answers
404 views

Does AC current produce EM waves?

Does AC current in simple wires produce electromagnetic waves? AC current entails very rapid changes in polarity and therefore the electrons in the metal will feel rapidly changing forces which should ...
1
vote
1answer
2k views

Electron flow and electric potential

In the physics tutorial topic on current electricty it defines the positive terminal as the high potential terminal and the negative as the low potential. When talking about positive test charges this ...
1
vote
3answers
964 views

Questions about voltage

For some reason, I feel like the concept of voltage is escaping my grasp. I've done much research on these forums and through texts, and come across answers that seem quite well thought out, but still ...
0
votes
1answer
139 views

Voltage and current in parallel circuit

I am having a bit of a tough time understanding the following: ...
0
votes
3answers
200 views

Current without voltage?

Suppose you have a 120 volt, 20 amp circuit which only has a light bulb connected. When measuring the voltage going to the light bulb my meter reads 120 volts. The basics taught me that a circuit is ...
2
votes
2answers
976 views

Can Kirchhoff laws be applied to any circuit?

Kirchhoff's loop/current rule is just law of conservation of energy and Kirchhoff's junction rule is just law of conservation of charge.So, I think that these can be applied to any circuits unlike ...
3
votes
4answers
626 views

How can there be a Current and an Electric field in an idealized wire with no voltage drop?

In an ideal circuit, How can there be a current b/w points a & b, when there is no potential difference and thus no electric field between a & b? If there is no current, then where does ...
-1
votes
2answers
87 views

Time difference in transmission of AC and DC

Is there any time difference while considering the transmission of AC and DC ? Is either one of them faster than the other one in terms of transmission of energy/power from one point to another? I ...
0
votes
1answer
3k views

Does the phase difference between voltage and current in an LCR circuit exist throughout the circuit?

I know that in an purely inductive circuit the current lags behind voltage by $90^o$, in a purely capacitive circuit vice-versa and in an LCR circuit the current may lag or gain with respect to ...
1
vote
1answer
140 views

Resistance and current

I'm not a current student at any school, but I am learning a new profession, and some of it is a basic understanding of elecrticity. I have some knowledge, but definitely not enough, and I have had to ...
3
votes
2answers
68 views

Direct current and metallic conduction

Suppose we have a circuit with and EMF source and a resistor. We know that when electron moves from one terminal of a voltage source to another it encounters resistance, which is basically collisions ...
1
vote
2answers
2k views

how does an electric field comes inside a conducting wire inside the circuit? [duplicate]

This has been a really great confusion for me now .... Many places i have read in books that when a potential difference is applied across the ends of a wire a constant electric field is generated ...
2
votes
5answers
380 views

Current division in ideal inductors?

The Question is:- Find the current distribution in the inductors at steady state (i.e. assuming $t\rightarrow \infty$ after the switch is closed and circuit established and consider the ...
-8
votes
3answers
4k views

Why current through all the resistors in series is considered to be same? [duplicate]

Consider the circuit shown, where $R_{1} > R_{2}$. I meant to say that resistance offered by the resistor 1 is greater than the resistance offered by the resistor 2. Keep $t$ constant i,e ...
10
votes
3answers
535 views

How does electricity 'decide' on it's pathway? [duplicate]

I'm struggling to understand the fundamental concepts of electricity, more specifically, the way in which it 'chooses' its optimal pathway. I appreciate electricity will always choose the path of ...
1
vote
3answers
134 views

Will the rms current be affected by inserting dielectric in the capacitor in an LCR circuit?

MY thoughts: I think it will not be as the expression for RMS value is dependent only on the peak value of current. Is my thinking correct?
2
votes
1answer
310 views

$\pi/2$ phase shift in RC circuit

I just recently learnt Alternating Current and RCL circuits and I also learnt about phasers and various graphs. Now I also know that current lags in an LR circuit. My intuitive understanding of this ...
1
vote
1answer
70 views

Why junction removal method doesn't work like this?

This is a question from my textbook's chapter on electrical currents. It has a square circuit as shown in figure 1, where all the wires have identical resistivity. While solving the circuit the ...
-1
votes
1answer
380 views

Electric circuit question [closed]

http://www.fisme.uu.nl/nno/opgaven/bestanden/Ronde1-Theorie-2009.pdf, question 5: You have to calculate Id when the switch at S is opened, when its closed, the Id = 0.5 A. All resistors are ...
0
votes
3answers
228 views

Potentiometer voltage change

I'm trying to understand simple things about electricity reading allaboutcircuits.com web. This chapter includes image which┬┤s principle I don't understand. Here it is: When supplying constant ...
2
votes
1answer
2k views

How to find the total current supplied to the circuit?

Recently, I came across a question based on finding electric current of a circuit. Here's the image... I know, by using the formula $I=V/R$, we can easily calculate the current as $V$ is given and ...
2
votes
1answer
213 views

Which direction does the electron move?

If my phone is charging that means it's mass increasing by this Youtube video. Now if an current is flowing from the power station to home, does it mean that electron is flowing from house to the ...
1
vote
2answers
218 views

Battery and current confusion?

How exactly does a battery produce a current in the circuit connected across its ends? I dont want to know the chemical reactions in the battery core, but just the essence of it. I believe it doesn't ...
0
votes
2answers
369 views

How does symmetry allow a rapid determination of the current between $A$ and $B$?

The following was originally given to me as a homework question at my physics 2 course: Consider the following circuit The difference of potentials between the point $V_{1}$and the ...