0
votes
3answers
73 views

Could this open electric circuit work?

Two batteries are interfaced by a resistor. Parameters such as resistance can be set arbitrarily. Does it work?
0
votes
1answer
45 views

The Voltage and Current of a Discharged Inductor at the Instant the Switch is Closed

The figure shows an LR circuit with a switch and a 240-volt battery. At the instant the switch is closed the current in the circuit and the potential difference between points a and b, Vab, are ...
0
votes
3answers
83 views

Capacitance: How to increase total charge drawn from a battery?

I can't seem to find any information about how parallel capacitors or capacitors in a series affect how much a capacitor can charge, not in my textbook or online. Here is the question I am trying to ...
-1
votes
1answer
33 views

High Current at first and then steady from a battery

I just came up with a question, When a battery is connected to a circuit, the current first suddenly peaks up and slowly goes down to a steady value. Why is it so? I have not actually observed this, ...
6
votes
3answers
639 views

What happens if I throw a battery into water?

Today I have by accident thrown a AAA battery into a bucket of water. I fished it out of the water immediately (within 20 seconds or so) and nothing notable had happened and the battery is still full ...
2
votes
1answer
88 views

Do batteries lose charge?

Say I have a charge of +q and -q on the positive and negative terminals of a battery. If I connect wires to each terminal, but don't connect the wires (essentially creating an open circuit), the ...
5
votes
4answers
949 views

How electron movement produces current,instead of having a slow drift speed

Just need a clarification here, how the current is produced due to the movement of electrons, in an external circuit,having a very slow drift speed. Normally in a battery there is high potential ...
1
vote
1answer
213 views

Circuit with inductor and lightbulb when switch is turned off?

I want to know what happens with a lightbulb immediately after a switch is turned off. We're talking about a circuit with a battery (AC), an inductor, a lightbulb and a switch. I need to know it in ...
0
votes
2answers
101 views

Batteries connected in Parallel

"If we connect two batteries in parallel, the battery with higher voltage will discharge into the other one." What is the intuition behind this?
3
votes
2answers
620 views

Why is there no current flow when i connect two opposite terminals of two separate batteries

I don't understand this..maybe there is something wrong with my understanding of battery or electricity. I am learning about electricity more deeply this time. So please spare with me... So lets ...
0
votes
2answers
386 views

What do we mean exactly by the positive/negative charges in cathode and anode?

In batteries, what exactly do we mean by negative and positive charges? My understanding is that the negative charge of the anode is basically an atom with an extra electron in the last orbital and a ...
-2
votes
1answer
322 views

Hard circuit problem [closed]

I want to find the p.d. between points A and B. I'm not sure how to approach this problem though, could I have a hint?
0
votes
1answer
57 views

Cell connections

I have an UPS with two 6V batteries connected in series. Is it possible to use the same system (UPS) to charge another two pieces of 6 volts battery if all the batteries are connected in parallel to ...
2
votes
2answers
3k views

Why two connected 1.5 volt battery become 3 volt

Why two connected 1.5 volt battery become 3 volt? If one battery plus side is connect to minus side of another battery, there should be a current flow between them until no free charge move anymore, ...
2
votes
2answers
8k views

Different batteries connected in parallel

If we have 2 batteries one of emf x and the other is of emf y and we connect them in series we get an effective emf of x+y. But what if we connect them in parallel, how to calculate the emf now?
1
vote
4answers
2k views

Capacitor Charging and Discharging when connected to the ground

When we charge a capacitor using a battery and then remove the battery, the plates of capacitor becomes charged. One holds positive charge and the other one gets equal negative charge. o. k. ? Now ...
5
votes
2answers
1k views

How can a circuit function with two negative battery terminals facing each other?

Here is a drawing of the circuit that is confusing me: I don't quite understand how batteries work in this diagram. If a battery has a negative and positive terminal, there must be a barrier ...
7
votes
3answers
2k views

Path of an electron through an electric circuit

When a potential difference is applied across a conductor, and if an electron moves from the negative terminal of the battery and reaches the positive terminal, then I want to know if the electron ...
0
votes
2answers
626 views

Can a battery charger be too powerful for a rechargeable battery?

I got the impression that a regular iPhone charger can charge the iPhone and the iPhone won't become too hot while charging, and the charging time is standard, but if using the 10W iPad charger to ...
0
votes
1answer
140 views

Battery fully loaded, pull out the chord?

I recently bought a new phone (Samsung Galaxy 3) and when the battery is fully loaded, it says like "Battery fully loaded, pull out the chord". Is this a typo from Samsung, or would there ...
4
votes
1answer
3k views

short circuit an alkaline battery

i'm not doing anything related to physics, but i'm just curious : What really happen when i short circuit an alkaline battery ? some article in the net shown that fire/explosion can be happened when ...
0
votes
2answers
152 views

Does using batteries in a series raise the overall Wh's of the batteries used? Why/Why Not?

If one has 2 batteries of 6 Volts each with 500 mAh each, then separately the batteries should provide 6 Volts * 500 mAh = 3 Wh each or 6 Wh total. However would it be the case that if someone where ...
22
votes
4answers
3k views

Why do 'dead' batteries work again after exchanging the places of the batteries in an electronic device?

My camera, which is powered by two AA batteries in series, would not power on. I removed the batteries, exchanged their locations, and the device worked again - for another 15 minutes or so. The ...
5
votes
3answers
7k views

What happens when we connect a metal wire between the 2 poles of a battery?

As I remembered, at the 2 poles of a battery, positive or negative electric charges are gathered. So there'll be electric field existing within the battery. This filed is neutralized by the chemical ...