Take the 2-minute tour ×
Physics Stack Exchange is a question and answer site for active researchers, academics and students of physics. It's 100% free, no registration required.

I would like to understand how to create an active noise canceling system to reduce the noise coming from a street road bump. The advantage is that the area the noise is coming from is very small.

share|improve this question

closed as off-topic by ACuriousMind, Danu, Kyle Oman, Kyle Kanos, Brandon Enright Oct 4 '14 at 1:25

This question appears to be off-topic. The users who voted to close gave this specific reason:

  • "This question appears to be about engineering, which is the application of scientific knowledge to construct a solution to solve a specific problem. As such, it is off topic for this site, which deals with the science, whether theoretical or experimental, of how the natural world works. For more information, see this meta post." – ACuriousMind, Danu, Kyle Oman, Kyle Kanos, Brandon Enright
If this question can be reworded to fit the rules in the help center, please edit the question.

You can't. Active noise cancelling basically works only in headphones and systems of comparable size: smaller than the sound's wavelength. –  leftaroundabout Nov 25 '13 at 13:55
Could Not Reproduce: I sat in front of a speed bump for half an hour and it did not produce any sounds. What situations are you thinking about? The jiggling of a car around you when you drive over a bump? The noise to a specific passerby coming from vehicles crossing the bump? Or do you want a speaker that will "cancel out" the noise from vehicles for everyone around? –  Emilio Pisanty Nov 25 '13 at 14:24
If the latter, it will prove impossible. It is only possible to produce destructive interference in certain specific regions; other places will show constructive interference. Conservation of energy demands it. –  Emilio Pisanty Nov 25 '13 at 14:28
I am only looking to cancel the bump sound of trucks and cars after they drive over a bump which was put right in front of my house. see: usfps.com/anc.html I was hoping Directional Sound might do the trick: mashable.com/2012/03/22/soundlazer-kickstarter-speaker –  Gil Margolin Nov 28 '13 at 8:40

1 Answer 1

Noise cancelling systems work by cancelling out the noise - coming from potentially all of the environment - within a limited spatial location, usually the size of a human ear. The sound within such a limited location can be seen strictly as the temporal oscillations of the local air pressure, and not as a wave of it.

In contrast, it is not possible to create a sound-cancelling system that will take the noise that originates inside a limited spatial location and cancels it out over all of space. There are two fundamental reasons for this: wave interference and, ultimately, conservation of energy.

When you allow the sound to propagate into the surrounding space, you can no longer treat it as locally homogeneous oscillations: you have a source of waves which you're trying to cancel out by adding a phased-out source. You then have two wave sources, and these will interfere according to the usual rules of wave phenomena: you will have regions where their effects cancel out, and regions where they add up with each other to make a stronger (in fact, by a factor of 4) effect:

Double slit interference.

You can of course dream up fancier systems than just a single ANC source. However, they will all fall foul of this problem. The fundamental reason for this is, of course, conservation of energy. Your noise source is emitting energy into the environment. You are further using your ANC sources to put out even more energy into it. This energy has to end up somewhere - it can't just vanish. Wave interference simply causes a 're-routing' of energy from places where you want it to be quiet into places that necessarily will become louder. For more con this, see What happens to the energy when waves perfectly cancel each other?.

share|improve this answer
Well cancelling out is definitely stupid question, but cant we absorb it ? Place large humongous diaphragma around and place some piezo crystals behind them to convert the sound enrgy to electrical energy –  Rijul Gupta Jan 13 '14 at 0:56
Yes. –  Emilio Pisanty Jan 13 '14 at 1:28

Not the answer you're looking for? Browse other questions tagged or ask your own question.