Take the 2-minute tour ×
Physics Stack Exchange is a question and answer site for active researchers, academics and students of physics. It's 100% free, no registration required.

3 Answers

"Ground" refers to a particular voltage, generally taken to be "zero", or the voltage of the earth. A "virtual ground" is a wire in a circuit whose voltage is held to be zero not because it is directly connected to the true ground, but instead because it is actively driven to that voltage typically by feedback mechanisms.

Here's an example of a virtual ground circuit:
Virtual ground circuit
In the above, the large triangle represents an OP-AMP, that is, an operational amplifier. It drives its output (marked VGND) to be + voltage when its + input has a higher voltage than its - input, and to be - voltage when its - input has a higher voltage than its + input. Since the + input is connected to true ground (marked GND), the op-amp will keep it output VGND at the GND level (to the best of its ability). Since the VGND wire is held at ground but is not connected to ground, it is called a "virtual ground".

By the way, in the usual "electric-circuits" limit, circuits are composed of "wires" where we make the assumption that the voltage of a wire is the same no matter where on the wire we look. That is, we ignore the process by which a signal is sent down a wire.

share|improve this answer
add comment

Virtual ground refers to a circuit element not directly connected to ground, held at a reference voltage. This reference voltage need not be the same voltage as ground either.

For example many op-amp circuits were originally designed for dual power supplies (say +12V and -12V) and could handle filtering or modification of a signal that was oscillating about ground. This need for two power supplies is annoying, so it is possible to remake these circuits with a single supply, and a "virtual ground" held at half the power supply. As long as signal voltage are compared to this virtual ground, filtering or modification of the oscillating signals can be handled just fine as they only go negative relative to the virtual ground.

In this way, it is fairly straight forward to convert dual supply op-amp circuits with single supply circuits by replacing the ground reference voltage in the circuit to a virtual ground to which the signal is referenced. This is the main context in which I have seen 'virtual ground' have a useful application.

share|improve this answer
The "Ground" is nothing but the center point of those two supply voltages. Laymen/beginners have big problems with the concept "ground" or "voltage of ground". So one should always start to explain what "ground" is, and why ground of some circuit may be conected to real ground or not. –  Georg Apr 11 '11 at 9:55
add comment

The ground which locates in the non-inverting terminal of an Op-Amp is called virtual ground.

share|improve this answer
add comment

protected by Qmechanic Nov 21 '13 at 17:23

Thank you for your interest in this question. Because it has attracted low-quality answers, posting an answer now requires 10 reputation on this site.

Would you like to answer one of these unanswered questions instead?

Not the answer you're looking for? Browse other questions tagged or ask your own question.