Take the 2-minute tour ×
Physics Stack Exchange is a question and answer site for active researchers, academics and students of physics. It's 100% free, no registration required.

Today when there was a power cut I saw that the CFL light bulbs were flashing time to time at regular interval. I was amazed as there was no source of power to the CFL bulbs even they were flashing as if they were sucking energy from surrounding, collecting it and then releasing them with a flash. Why was it happening?

share|improve this question
add comment

2 Answers

It's likely the power-cut wasn't a complete loss of power but a drop in voltage. The controller electronics in the CFL bulb base converts the 110/220V AC power into the voltage used inside the lamp, it can also store a small amount of charge. Depending on the design of the circuit it could also convert much lower, say 20-30V AC into the power the lamp needed - at least for a short time.

What probably happened is that the voltage dropped from your normal supply to some low value, say 20-30V as the grid tried to supply the same number of customers from a reduced supply. The lamp was able to store up energy from this low voltage and turn on. Then the voltage dropped to zero turning it off and the process repeats at random.

Modern supply system try and avoid this because it can damage appliances, they will typically sense a fault and go completely off until they are commanded to come back on. Bringing a power failure back online is quite complex. But if you live somewhere without an advanced intelligent grid you can get these voltage fluctuations - called "brown-outs" because they made an old fashioned filament light bulb glow dimly = brown

share|improve this answer
    
NO there was a complete-power cut not a brown-out –  Akash Mar 7 '13 at 19:46
    
How do you know? It might only be a few volts on the line, it might even be residual current in the neutral line. –  Martin Beckett Mar 7 '13 at 19:47
    
If it would have been the condition than the incandescent bulb's would have glown a little bit –  Akash Mar 7 '13 at 19:51
add comment

Do you know if you were getting beamed with microwave pulses? You can light CFL's up easily with an electromagnetic beam at the right frequency.

More seriously, do you have any big capacitors plugged into the same breaker's circuits? A capacitance/inductance/resistance circuit can sustain a fluctuating current for some time after the thing charging the capacitor has been disconnected.

share|improve this answer
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.