Physics Stack Exchange is a question and answer site for active researchers, academics and students of physics. Join them; it only takes a minute:

Sign up
Here's how it works:
  1. Anybody can ask a question
  2. Anybody can answer
  3. The best answers are voted up and rise to the top

Fluorescent lights are already efficient when they’re running but I’ve heard that it takes a lot of energy to turn a fluorescent light tube on. So is it more efficient to turn off a fluorescent tube immediately when you’ve finished using it or is it better to leave it on and then wait until you’re more likely to not use it again for a while?

share|cite|improve this question
up vote 4 down vote accepted

A fluorescent light uses as much energy getting started as it des to run for 23.3 seconds. In other words, that is a bit of a myth about leaving it on for very long. If you’re going to be in the room and gone for less than 23.3 seconds there’s no point it on, basically. You might as well turn it off because it uses not very much more energy. To put that in comparison, an LED has to run for 1.28 seconds before it uses as much energy. The good old-fashioned incandescent lamp: 0.36 seconds before it’s used as much energy it does running as it does to turn it on.

share|cite|improve this answer
Why does the florescent light take so much energy to turn on? – leongz Dec 7 '12 at 5:30
@leongz - why not post that as a new question in its own right? – EnergyNumbers Dec 7 '12 at 7:03

Your Answer


By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.