Take the 2-minute tour ×
Physics Stack Exchange is a question and answer site for active researchers, academics and students of physics. It's 100% free, no registration required.

A fluorescent tube (home-based) works on the principle of discharge of electricity through gases, as far as I can tell (I don't know much about cathode rays or gas discharge)

What happens inside the tube to create this pink color? Wikipedia says that it is because the mercury vapor is absorbed and its spectrum is changed.

Do all the fluorescent tubes (especially Compact Fluorescent Lamps which also use mercury) have this same pink color during dying?

share|improve this question
1  
It is important to recall that such lamps have the inside of the tube coated in phosphors to adjust the spectrum of the light emitted: you aren't seeing the direct emissions. –  dmckee Sep 7 '12 at 18:16

1 Answer 1

up vote 4 down vote accepted

A fluorescent lamp or fluorescent tube is a gas-discharge lamp that uses electricity to excite mercury vapor. The excited mercury atoms produce short-wave ultraviolet light that then causes a phosphor to fluoresce, producing visible light.

Taken right from Wikipedia! http://en.wikipedia.org/wiki/Fluorescent_lamp

End of life

The end of life failure mode for fluorescent lamps varies depending on how they are used and their control gear type. Often the light will turn pink (see "Loss of mercury" section for details) with black burns on the ends of the lamp due to sputtering of emission mix (see below). The lamp may also flicker at a noticeable rate (see "Flicker problems" section for details).

Mercury is slowly absorbed into glass, phosphor, and tube electrodes throughout the lamp life, until it can't function.

The failure symptom cycle starts out with a flicker (run-up time to full light output). When the mercury runs out (absorbed by the glass, phosphor, and tube electrodes) the lamp glows a dim pink and the argon base gas takes over as the primary discharge.

The same effect can be observed with new tubes. Mercury is present in the form of an amalgam and takes some time to be liberated in sufficient amount. New lamps may initially glow pink for several seconds after startup. This period is minimized after about 100 hours of operation.

share|improve this answer
    
Sure thing. I tried to explain the absorption of mercury into the glass. –  Nate Sep 15 '12 at 15:54

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.