I'm doing a school assignment project and I need to investigate something of my choice. I was thinking of doing something about how the height and angle the blade of a guillotine is dropped from affects how accurately and/or how deep it cuts. And also, it wouldn't hurt if anyone knew the directions to building a mini guillotine. So does anyone know the basic Physics of the guillotine, per se? There's not much about it on the internet and I might have to go and search the library for more info... But if anyone could help, I'd soo appreciate it! thanks all!
closed as off topic by Qmechanic♦, Ron Maimon, David Z♦ May 23 '12 at 15:33
Questions on Physics Stack Exchange are expected to relate to physics within the scope defined by the community. Consider editing the question or leaving comments for improvement if you believe the question can be reworded to fit within the scope. Read more about reopening questions here. If this question can be reworded to fit the rules in the help center, please edit the question.
Meh, morbidity and triviality aside, the basic principle of a guillotine is: Lots of momentum behind a sharp edge produces cutting. An angled blade increases the efficiency of the cut by maintaining higher pressure at the cutting interface than if the entire blade made contact at once.
In building one, you'll have to make sure that you have guides that can make sure the blade drops cleanly. If you have access to a good saw, you make a straigh cut in two pieces of wood. Then, you can fit the shuttle into the kerf (the width of the cuts you just made) and it will slide along these guides. As to the shuttle, you need something you can mount a blade in. A razor blade glued to a credit card might work, although this would not be very heavy. Use your imagination.
As to investigations, your questions seem like a good start. Is cut depth proportional to blade height? For constant blade height and weight, how does angle affect cut depth? You might also investigate different material, for example, carrots vs. tiny sandbags. Which are linear (cut depth proportional to blade height) and which are not?